The effect of perineural anaesthesia and handler position on limb loading and hoof balance of the vertical ground reaction force in sound horses

2015 ◽  
Vol 48 (5) ◽  
pp. 608-612 ◽  
Author(s):  
E. Van de Water ◽  
M. Oosterlinck ◽  
F. Pille
Keyword(s):  
Ground Reaction Force ◽  
Reaction Force ◽  
Vertical Ground Reaction Force ◽  
Limb Loading ◽  
Vertical Ground

scholarly journals A Review of Biomechanical Gait Classification with Reference to Collected Trot, Passage and Piaffe in Dressage Horses

Animals ◽  
2019 ◽  
Vol 9 (10) ◽  
pp. 763 ◽  
Author(s):  
Clayton ◽  
Hobbs
Keyword(s):  
Ground Reaction Force ◽  
Inverted Pendulum ◽  
Center Of Mass ◽  
Reaction Force ◽  
Vertical Ground Reaction Force ◽  
Phase Duration ◽  
Hind Limbs ◽  
Limb Loading ◽  
Vertical Ground ◽  
Lift Off

Gaits are typically classified as walking or running based on kinematics, the shape of the vertical ground reaction force (GRF) curve, and the use of inverted pendulum or spring-mass mechanics during the stance phase. The objectives of this review were to describe the biomechanical characteristics that differentiate walking and running gaits, then apply these criteria to classify and compare the enhanced natural gait of collected trot with the artificial gaits of passage and piaffe as performed by highly trained dressage horses. Limb contact and lift off times were used to determine contact sequence, limb phase, duty factor, and aerial phase duration. Ground reaction force data were plotted to assess fore and hind limb loading patterns. The center of mass (COM) trajectory was evaluated in relation to changes in potential and kinetic energy to assess the use of inverted pendulum and spring-mass mechanics. Collected trot and passage were classified as running gaits according to all three criteria whereas piaffe appears to be a hybrid gait combining walking kinematics with running GRFs and COM mechanics. The hind limbs act as springs and show greater limb compression in passage and piaffe compared with trot, whereas the forelimbs behave more like struts showing less compression in passage and piaffe than in trot.

scholarly journals EFFECT OF TRANSTIBIAL PROSTHESIS MASS ON GAIT ASYMMETRIES

2020 ◽  
Vol 3 (2) ◽  
Author(s):  
Mayank Seth ◽  
Wei Hou ◽  
Laura Goyarts ◽  
James Galassi ◽  
Eric Lamberg
Keyword(s):  
Ground Reaction Force ◽  
Reaction Force ◽  
Vertical Ground Reaction Force ◽  
Heavy Load ◽  
Below The Knee ◽  
Light Load ◽  
Limb Loading ◽  
Force Peak ◽  
Vertical Ground ◽  
Mass Increase

BACKGROUND: Individuals with transtibial amputation (TTA) typically walk with an asymmetrical gait pattern, which may predispose them to secondary complications and increase risk of fall. Gait asymmetry may be influenced by prosthesis mass. OBJECTIVE: To explore the effects of prosthesis mass on temporal and limb loading asymmetry in people with TTA following seven days of acclimation and community use. METHODS: Eight individuals with transtibial amputation participated. A counterbalanced repeated measures study, involving three sessions (each one week apart) was conducted, during which three load conditions were examined: no load, light load and heavy load. The light load and heavy load conditions were achieved by adding 30% and 50% of the mass difference between legs, at a proximal location on the prosthesis. Kinematic and ground reaction force data was captured while walking one week after the added mass. Symmetry indices between the prosthetic and intact side were computed for temporal (Stance and Swing time) and limb loading measures (vertical ground reaction force Peak and Impulse). FINDINGS: Following seven days of acclimation, no significant differences were observed between the three mass conditions (no load, light load and heavy load) for temporal (Stance time: p=0.61; Swing time: p=0.13) and limb loading asymmetry (vertical ground reaction force Peak: p=0.95;  vertical ground reaction force Impulse: p=0.55). CONCLUSION: Prosthesis mass increase at a proximal location did not increase temporal and limb loading asymmetry during walking in individuals with TTA. Hence, mass increase subsequent to replacing proximally located prosthesis components may not increase gait asymmetry, thereby allowing more flexibility to the clinician for component selection. Layman's Abstract People with a below the knee amputation typically have an asymmetrical walking style, i.e., they spend more time and put more body weight on their non-amputated leg. This may result in development of knee or hip osteoarthritis of the non-amputated leg, over time. Further, an asymmetrical walking style may also predispose people to a greater number of falls. It is believed that the weight of a prosthesis may influence the walking asymmetry. It is, however, unclear if changing the weight of a prothesis during routine clinical visits (for example, switching or replacing prosthesis parts) would increase walking asymmetry. To explore this, eight individuals with a below the knee amputation had two different weights added to the top half of their prosthesis. After the addition of the weight, participants went home to use the device in their communities for seven days. Subsequently, they returned to the lab to record their walking. We observed that walking with the heavier prosthesis, using either load, did not increase the amount of time spent and body weight applied by our participants on their non-amputated side. Hence, adding mass to the top half of a prosthesis may not increase walking asymmetry. Article PDF Link: https://jps.library.utoronto.ca/index.php/cpoj/article/view/34609/26769 How To Cite: Seth M, Hou W, Goyarts L.R, Galassi J.P, Lamberg E.M. Effect of transtibial prosthesis mass on gait asymmetries. Canadian Prosthetics & Orthotics Journal. 2020;Volume 3, Issue 2, No.5. https://doi.org/10.33137/cpoj.v3i2.34609 Corresponding Author: Mayank Seth, PhDDelaware Limb Loss Studies Lab, University of Delaware, Newark, USA.E-mail: [email protected]: https://orcid.org/0000-0003-3526-7058

scholarly journals Running ground reaction forces across footwear conditions are predicted from the motion of two body mass components

2019 ◽  
Vol 126 (5) ◽  
pp. 1315-1325 ◽  
Author(s):  
Andrew B. Udofa ◽  
Kenneth P. Clark ◽  
Laurence J. Ryan ◽  
Peter G. Weyand
Keyword(s):  
Ground Reaction Force ◽  
Lower Limb ◽  
Reaction Force ◽  
Ground Reaction Forces ◽  
Vertical Ground Reaction Force ◽  
Time Patterns ◽  
Foot Strike ◽  
Reaction Forces ◽  
Vertical Ground ◽  
Force Time

Although running shoes alter foot-ground reaction forces, particularly during impact, how they do so is incompletely understood. Here, we hypothesized that footwear effects on running ground reaction force-time patterns can be accurately predicted from the motion of two components of the body’s mass (mb): the contacting lower-limb (m1 = 0.08mb) and the remainder (m2 = 0.92mb). Simultaneous motion and vertical ground reaction force-time data were acquired at 1,000 Hz from eight uninstructed subjects running on a force-instrumented treadmill at 4.0 and 7.0 m/s under four footwear conditions: barefoot, minimal sole, thin sole, and thick sole. Vertical ground reaction force-time patterns were generated from the two-mass model using body mass and footfall-specific measures of contact time, aerial time, and lower-limb impact deceleration. Model force-time patterns generated using the empirical inputs acquired for each footfall matched the measured patterns closely across the four footwear conditions at both protocol speeds ( r2 = 0.96 ± 0.004; root mean squared error  = 0.17 ± 0.01 body-weight units; n = 275 total footfalls). Foot landing angles (θF) were inversely related to footwear thickness; more positive or plantar-flexed landing angles coincided with longer-impact durations and force-time patterns lacking distinct rising-edge force peaks. Our results support three conclusions: 1) running ground reaction force-time patterns across footwear conditions can be accurately predicted using our two-mass, two-impulse model, 2) impact forces, regardless of foot strike mechanics, can be accurately quantified from lower-limb motion and a fixed anatomical mass (0.08mb), and 3) runners maintain similar loading rates (ΔFvertical/Δtime) across footwear conditions by altering foot strike angle to regulate the duration of impact. NEW & NOTEWORTHY Here, we validate a two-mass, two-impulse model of running vertical ground reaction forces across four footwear thickness conditions (barefoot, minimal, thin, thick). Our model allows the impact portion of the impulse to be extracted from measured total ground reaction force-time patterns using motion data from the ankle. The gait adjustments observed across footwear conditions revealed that runners maintained similar loading rates across footwear conditions by altering foot strike angles to regulate the duration of impact.

Carrying loads with springy poles

1991 ◽  
Vol 71 (3) ◽  
pp. 1119-1122 ◽  
Author(s):  
R. Kram
Keyword(s):  
Oxygen Consumption ◽  
Ground Reaction Force ◽  
Oxygen Consumption Rate ◽  
Consumption Rate ◽  
Reaction Force ◽  
Load Carriage ◽  
Vertical Ground Reaction Force ◽  
Suspension Systems ◽  
Vertical Ground ◽  
Male Subjects

People throughout Asia use springy bamboo poles to carry the loads of everyday life. These poles are a very compliant suspension system that allows the load to move along a nearly horizontal path while the person bounces up and down with each step. Could this be an economical way to carry loads inasmuch as no gravitational work has to be done to lift the load repeatedly? To find out, an experiment was conducted in which four male subjects ran at 3.0 m/s on a motorized treadmill with no load and while carrying a load equal to 19% body wt with compliant poles. Oxygen consumption rate, vertical ground reaction force, and the force exerted by the load on the shoulders were measured. Oxygen consumption rate increased by 22%. The same increase has previously been observed when loads are carried with a backpack. Thus compliant poles are not a particularly economical method of load carriage. However, pole suspension systems offer important advantages: they minimize peak shoulder forces and loading rates. In addition, the peak vertical ground reaction force is only slightly increased above unloaded levels when loads are carried with poles.

scholarly journals The Relationship Between Vertical Loadrates and Tibial Acceleration Across Footstrike Patterns

2018 ◽  
Vol 3 (3) ◽  
pp. 2473011418S0020 ◽  
Author(s):  
Irene Davis ◽  
Todd Hayano ◽  
Adam Tenforde
Keyword(s):  
Impact Loading ◽  
Ground Reaction Force ◽  
Reaction Force ◽  
Force Plate ◽  
Correlation Coefficients ◽  
Strongly Correlated ◽  
Vertical Ground Reaction Force ◽  
Vertical Ground ◽  
Tibial Acceleration ◽  
The Relationship

Category: Other Introduction/Purpose: While the etiology of injuries is multifactorial, impact loading, as measured by the loadrate of the vertical ground reaction force has been implicated. These loadrates are typically measured with a force plate. However, this limits the measure of impacts to laboratory environments. Tibial acceleration, another measure of running impacts, is considered a surrogate for loadrate. It can be measured using new wearable technology that can be used in a runner’s natural environment. However, the correlation between tibial acceleration measured from mobile devices and vertical ground reaction force loadrates, measured from forceplates, is unknown. The purpose of this study was to determine the correlation between vertical and resultant loadrates to vertical and resultant tibial acceleration across different footstrike patterns (FSP) in runners. Methods: The study involved a sample of convenience made up of 169 runners (74 F, 95 M; age: 38.66±13.08 yrs) presenting at a running injury clinic. This included 25 habitual forefoot strike (FFS), 17 midfoot strike (MFS) and 127 rearfoot strike (RFS) runners. Participants ran on an instrumented treadmill (average speed 2.52±0.25 m/s), with a tri-axial accelerometer attached at the left distal medial tibia. Only subjects running with pain <3/10 on a VAS scale during the treadmill run were included to reduce the confounding effect of pain. Vertical average, vertical instantaneous and resultant instantaneous loadrates (VALR, VILR and RILR) and peak vertical and resultant tibial accelerations (VTA, RTA) were averaged for 8 consecutive left steps. Correlation coefficients (r) were calculated between tibial accelerations and loadrates. Results: All tibial accelerations were significantly correlated across all loadrates, with the exception of RTA with VILR for FFS (Table 1) which was nearly significant (p=0.068). Correlations ranged from 0.37-0.82. VTA was strongly correlated with all loadrates (r = 0.66). RTA was also strongly correlated with both loadrates for RFS and MFS, but only moderately correlated with loadrates for FFS (r = 0.47). Correlations were similar across the different loadrates (VALR, VILR, RILR). Conclusion: The stronger correlation between vertical tibial acceleration and all loadrates (VALR, VILR, RILR) suggests that it may be the best surrogate for loadrates when studying impact loading in runners.

scholarly journals Vertical ground reaction force shape is associated with gait parameters, timed up and go, and functional reach in elderly females

2004 ◽  
Vol 36 (1) ◽  
pp. 42-45 ◽  
Author(s):  
Toshiaki Takahashi ◽  
Kenji Ishida ◽  
Daisuke Hirose ◽  
Yasunori Nagano ◽  
Kiyoto Okumiya ◽  
...  
Keyword(s):  
Ground Reaction Force ◽  
Reaction Force ◽  
Vertical Ground Reaction Force ◽  
Timed Up And Go ◽  
Functional Reach ◽  
Gait Parameters ◽  
Vertical Ground
Sign in / Sign up

Export Citation Format

Share Document