A Buccal Mucosal Graft Sub‐Coronal Resurfacing to Treat Recurrent Penile Adhesions: The Buccal Belt

2021 ◽  
Author(s):  
Matthew R. Beamer ◽  
Javier C. Angulo ◽  
Leandro Capiel ◽  
Damian López‐Alvarado ◽  
Erick A. Ramirez ◽  
...  
Keyword(s):  
Buccal Mucosal Graft

Outcome of Buccal Mucosal Graft Urethroplasty in Long Segment Anterior Urethral Stricture

2020 ◽  
Vol 19 (2) ◽  
pp. 64-68
Author(s):  
Mrinmoy Biswas ◽  
Sudip Das Gupta ◽  
Mohammed Mizanur Rahman ◽  
Sharif Mohammad Wasimuddin
Keyword(s):  
Urethral Stricture ◽  
Flow Rate ◽  
Surgical Outcome ◽  
Simple Technique ◽  
Anterior Segment ◽  
Maximum Flow ◽  
Anastomotic Site ◽  
Buccal Mucosal Graft ◽  
Male Patients

Objective: To assess the success of BMG urethroplasty in long segment anterior urethral stricture. Method: From January 2014 to December 2015, twenty male patients with long anterior segment urethral stricture were managed by BMG urethroplasty. After voiding trial they were followed up at 3 month with Uroflowmetry, RGU & MCU and PVR measurement by USG. Patients were further followed up with Uroflowmetry and PVR at 6 months interval.Successful outcome was defined as normal voiding with a maximum flow rate >15ml /sec and PVR<50 ml with consideration of maximum one attempt of OIU after catheter removal. Results: Mean stricture length was 5.2 cm (range 3-9 cm) and mean follow-up was 15.55 months (range 6-23 months). Only two patients developed stricture at proximal anastomotic site during follow-up. One of them voided normally after single attempt of OIU. Other one required second attempt of OIU and was considered as failure (5%). Conclusion: BMG urethroplasty is a simple technique with good surgical outcome. Bangladesh Journal of Urology, Vol. 19, No. 2, July 2016 p.64-68

scholarly journals Buccal mucosal graft urethroplasty for radiation-induced urethral strictures: an evaluation using the extended Urethral Stricture Surgery Patient-Reported Outcome Measure (USS PROM)

2020 ◽  
Vol 38 (11) ◽  
pp. 2863-2872 ◽  
Author(s):  
Malte W. Vetterlein ◽  
◽  
Luis A. Kluth ◽  
Valentin Zumstein ◽  
Christian P. Meyer ◽  
...  
Keyword(s):  
Radiation Therapy ◽  
Urethral Stricture ◽  
Outcome Measure ◽  
Patient Reported Outcome ◽  
Patient Reported Outcome Measure ◽  
Urethral Strictures ◽  
Buccal Mucosal Graft ◽  
Surgery Patient ◽  
Patient Reported ◽  
Radiation Induced

Abstract Objectives To evaluate objective treatment success and subjective patient-reported outcomes in patients with radiation-induced urethral strictures undergoing single-stage urethroplasty. Patients and methods Monocentric study of patients who underwent single-stage ventral onlay buccal mucosal graft urethroplasty for a radiation-induced stricture between January 2009 and December 2016. Patients were characterized by descriptive analyses. Kaplan–Meier estimates were employed to plot recurrence-free survival. Recurrence was defined as any subsequent urethral instrumentation (dilation, urethrotomy, urethroplasty). Patient-reported functional outcomes were evaluated using the validated German extension of the Urethral Stricture Surgery Patient-Reported Outcome Measure (USS PROM). Results Overall, 47 patients were available for final analyses. Median age was 70 (IQR 65–74). Except for two, all patients had undergone pelvic radiation therapy for prostate cancer. Predominant modality was external beam radiation therapy in 70% of patients. Stricture recurrence rate was 33% at a median follow-up of 44 months (IQR 28–68). In 37 patients with available USS PROM data, mean six-item LUTS score was 7.2 (SD 4.3). Mean ICIQ sum score was 9.8 (SD 5.4). Overall, 53% of patients reported daily leaking and of all, 26% patients underwent subsequent artificial urinary sphincter implantation. Mean IIEF-EF score was 4.4 (SD 7.1), indicating severe erectile dysfunction. In 38 patients with data regarding the generic health status and treatment satisfaction, mean EQ-5D index score and EQ VAS score was 0.91 (SD 0.15) and 65 (SD 21), respectively. Overall, 71% of patients were satisfied with the outcome. Conclusion The success rate and functional outcome after BMGU for radiation-induced strictures were reasonable. However, compared to existing long-term data on non-irradiated patients, the outcome is impaired and patients should be counseled accordingly.

scholarly journals Recurrent contracted sockets treated with personalized, three-dimensionally printed conformers and buccal grafts

2021 ◽  
pp. 112067212110000
Author(s):  
Annabel LW Groot ◽  
Jelmer S Remmers ◽  
Roel JHM Kloos ◽  
Peerooz Saeed ◽  
Dyonne T Hartong
Keyword(s):  
Three Dimensional ◽  
Case Series ◽  
Secondary Outcome ◽  
Retrospective Case ◽  
Upper Eyelid ◽  
Ocular Prosthesis ◽  
Buccal Mucosal Graft ◽  
Custom Made ◽  
3D Printed

Purpose: Recurrent contracted sockets are complex situations where previous surgeries have failed, disabling the wear of an ocular prosthesis. A combined method of surgery and long-term fixation using custom-made, three-dimensional (3D) printed conformers is evaluated. Methods: Retrospective case series of nine patients with recurrent excessive socket contraction and inability to wear a prosthesis, caused by chemical burns ( n = 3), fireworks ( n = 3), trauma ( n = 2) and enucleation and radiotherapy at childhood due to optic nerve glioma ( n = 1) with three average previous socket surgeries (range 2–6). Treatment consisted of a buccal mucosal graft and personalized 3D-printed conformer designed to be fixated to the periosteum and tarsal plates for minimal 2 months. Primary outcome was the retention of an ocular prosthesis. Secondary outcome was the need for additional surgeries. Results: Outcomes were measured at final follow-up between 7 and 36 months postoperatively (mean 20 months). Eight cases were able to wear an ocular prosthesis after 2 months. Three cases initially treated for only the upper or only the lower fornix needed subsequent surgery for the opposite fornix for functional reasons. Two cases had later surgery for cosmetic improvement of upper eyelid position. Despite pre-existing lid abnormalities (scar, entropion, lash deficiency), cosmetic outcome was judged highly acceptable in six cases because of symmetric contour and volume, and reasonably acceptable in the remaining two. Conclusions: Buccal mucosal transplant fixated with a personalized 3D-designed conformer enables retention of a well-fitted ocular prosthesis in previously failed socket surgeries. Initial treatment of both upper and lower fornices is recommended to avoid subsequent surgeries for functional reasons.

scholarly journals Total Reconstruction of the Upper Lip Using Bilateral Nasolabial Flaps, Submental Flap, and Mucosa Graft following Complete Resection for Squamous Cell Carcinoma

2015 ◽  
Vol 2015 ◽  
pp. 1-4 ◽  
Author(s):  
O. G. Oseni ◽  
A. E. Fadare ◽  
M. O. Majaro ◽  
P. B. Olaitan
Keyword(s):  
Squamous Cell Carcinoma ◽  
Cell Carcinoma ◽  
Complete Resection ◽  
Upper Lip ◽  
Total Resection ◽  
Lip Reconstruction ◽  
Buccal Mucosal Graft ◽  
Submental Flap ◽  
Upper Lip Reconstruction ◽  
Total Reconstruction

Lip reconstruction following resection for tumour or following extensive trauma may pose a challenge. This is more so when the resection is total and a complete lip has to be constructed. We present a case of lip reconstruction following a total resection of the upper lip. The procedure used in this case was a combination of bilateral nasolabial flaps with a submental flap and buccal mucosal graft lining. We believe that this provides an alternative method of total upper lip reconstruction with minimal disruption of the facial aesthesis.

Closure of Palatal Fistula with a Local Mucoperiosteal Flap Lined with Buccal Mucosal Graft

2000 ◽  
Vol 37 (2) ◽  
pp. 127-129 ◽  
Author(s):  
M.B.O.M. Honnebier ◽  
D.S. Johnson ◽  
A.A. Parsa ◽  
A. Dorian ◽  
F.D. Parsa
Keyword(s):  
Standard Form ◽  
Senior Author ◽  
Fistula Formation ◽  
Fistula Repair ◽  
Suitable Alternative ◽  
Buccal Mucosal Graft ◽  
Nasal Side ◽  
Long Term Follow Up ◽  
Mucoperiosteal Flap ◽  
Cleft Palate Repair

Objective Oro-nasal fistula is a common complication of palatoplasty. Current methods for fistula repair utilize mucoperiosteal flaps or pedicled flaps. These procedures are often cumbersome and leave a raw nasal surface, which may increase the incidence of postoperative risks and problems. In addition, the recurrence rate of the fistula is as high as 34%. We propose a simple two-layer method of fistula repair to avoid recurrences. Design A standard mucoperiosteal flap is raised on the oral side. A buccal mucosal graft is harvested from the cheeks and sutured to the nasal side of the flap that is then inset into the fistula. Setting Patients were either referred to the senior author's private practice (four patients) or were patients who had previously been operated on by the senior author himself (three patients). Subjects Study subjects consisted of seven patients, four males and three females, ages 14 months to 8 years. All patients had previously undergone cleft palate repair, complicated by subsequent oro-nasal fistula formation. Interventions All patients underwent oro-nasal fistula repair under general anesthesia with a local mucoperiosteal flap lined with buccal mucosal grafts placed on the nasal side of the flap. Results In all cases, the fistula was completely closed at first attempt without complications. Patients were followed for a minimum of 2 years, without evidence of recurrence. Conclusions Our proposed surgical procedure for fistula closure using a standard mucoperiosteal flap lined with a buccal mucosal graft is a suitable alternative for the repair of postpalatoplasty oro-nasal fistulas. Further study and long-term follow-up is needed to establish this method as a new standard form of repair.

Sign in / Sign up

Export Citation Format

Share Document