Experimental Study on the Atmospheric Delay Based on GPS, SAR Interferometry, and Numerical Weather Model Data

2013 ◽  
Vol 51 (1) ◽  
pp. 6-11 ◽  
Author(s):  
P. Mateus ◽  
G. Nico ◽  
R. Tome ◽  
J. Catalao ◽  
P. M. A. Miranda
Keyword(s):  
Experimental Study ◽  
Sar Interferometry ◽  
Model Data ◽  
Numerical Weather ◽  
Numerical Weather Model ◽  
Atmospheric Delay ◽  
Weather Model

Database of Crustal Deformation Observed by SAR: Improving Atmospheric Delay Mitigation for Satellite SAR Interferometry and Developing L-Band Multi-Type Portable SAR

2019 ◽  
Vol 14 (5) ◽  
pp. 713-727
Author(s):  
Taku Ozawa ◽  
Yosuke Aoki ◽  
Satoshi Okuyama ◽  
Xiaowen Wang ◽  
Yousuke Miyagi ◽  
...  
Keyword(s):  
Human Resource Development ◽  
Crustal Deformation ◽  
Sar Interferometry ◽  
Japan Meteorological Agency ◽  
Numerical Weather ◽  
Numerical Weather Model ◽  
Atmospheric Delay ◽  
Weather Model ◽  
L Band ◽  
Volcanic Activities

Spaceborne synthetic aperture radar (SAR) and ground-based radar interferometers (GBRIs) can be used to detect spatially detailed crustal deformations that are difficult to detect by on-site observations, the Global Navigation Satellite System, tiltmeters, and so on. To make such crustal deformation information readily available to those engaged in evaluating volcanic activities and researching the mechanisms, we are preparing a database within the Japan Volcanological Data Network data sharing system to store crustal deformation detected by spaceborne SAR and GBRIs (Subtheme 2-1, Project B, the Integrated Program for Next Generation Volcano Research and Human Resource Development). In this study, we examined methods to reduce atmospheric delay noise in SAR interferometry using the numerical weather model and determined the methods for resampling the analytical values of the numerical weather model and estimating atmospheric delay to efficiently determine atmospheric delay. We show that the atmospheric delay can be estimated with higher accuracy by properly combining the isobaric surface and ground surface data of the mesoscale model (MSM) provided by the Japan Meteorological Agency. We are developing a multi-type portable SAR system as a GBRI system such that it would allow campaign observations whenever increased volcanic activities are observed and acquire crustal deformation with a higher temporal resolution than spaceborne SAR for storage in the database. This system employs L-band radar, which has a higher penetrability against vegetation. Two modes of observations are possible: ground-based SAR and car-borne SAR. The prototype was fabricated to conduct experiments necessary to develop a working model. The experimental observations was carried out around Asama volcano, and we confirmed that clear fringe was obtained.

TOMOREF operator as a tool to improve weather forecasts

2021 ◽  
Author(s):  
Natalia Hanna ◽  
Estera Trzcina ◽  
Maciej Kryza ◽  
Witold Rohm
Keyword(s):  
Data Assimilation ◽  
Weather Forecasting ◽  
Positive Impact ◽  
Precipitation Event ◽  
Initial State ◽  
Total Delay ◽  
Numerical Weather ◽  
Numerical Weather Model ◽  
Weather Model ◽  
Tomography Data

<p>The numerical weather model starts from the initial state of the Earth's atmosphere in a given place and time. The initial state is created by blending the previous forecast runs (first-guess), together with observations from different platforms. The better the initial state, the better the forecast; hence, it is worthy to combine new observation types. The GNSS tomography technique, developed in recent years, provides a 3-D field of humidity in the troposphere. This technique shows positive results in the monitoring of severe weather events. However, to assimilate the tomographic outputs to the numerical weather model, the proper observation operator needs to be built.</p><p>This study demonstrates the TOMOREF operator dedicated to the assimilation of the GNSS tomography‐derived 3‐D fields of wet refractivity in a Weather Research and Forecasting (WRF) Data Assimilation (DA) system. The new tool has been tested based on wet refractivity fields derived during a very intense precipitation event. The results were validated using radiosonde observations, synoptic data, ERA5 reanalysis, and radar data. In the presented experiment, a positive impact of the GNSS tomography data assimilation on the forecast of relative humidity (RH) was noticed (an improvement of root‐mean‐square error up to 0.5%). Moreover, within 1 hour after assimilation, the GNSS data reduced the bias of precipitation up to 0.1 mm. Additionally, the assimilation of GNSS tomography data had more influence on the WRF model than the Zenith Total Delay (ZTD) observations, which confirms the potential of the GNSS tomography data for weather forecasting.</p>

scholarly journals Validation of 7 Years in-Flight HY-2A Calibration Microwave Radiometer Products Using Numerical Weather Model and Radiosondes

2019 ◽  
Vol 11 (13) ◽  
pp. 1616 ◽  
Author(s):  
Zhilu Wu ◽  
Jungang Wang ◽  
Yanxiong Liu ◽  
Xiufeng He ◽  
Yang Liu ◽  
...  
Keyword(s):  
Microwave Radiometer ◽  
The Arctic ◽  
Radiosonde Data ◽  
Polar Regions ◽  
Systematic Bias ◽  
Tropical Regions ◽  
Numerical Weather ◽  
Numerical Weather Model ◽  
Weather Model ◽  
Interim Products

Haiyang-2A (HY-2A) has been working in-flight for over seven years, and the accuracy of HY-2A calibration microwave radiometer (CMR) data is extremely important for the wet troposphere delay correction (WTC) in sea surface height (SSH) determination. We present a comprehensive evaluation of the HY-2A CMR observation using the numerical weather model (NWM) for all the data available period from October 2011 to February 2018, including the WTC and the precipitable water vapor (PWV). The ERA(ECMWF Re-Analysis)-Interim products from European Centre for Medium-Range Weather Forecasts (ECMWF) are used for the validation of HY-2A WTC and PWV products. In general, a global agreement of root-mean-square (RMS) of 2.3 cm in WTC and 3.6 mm in PWV are demonstrated between HY-2A observation and ERA-Interim products. Systematic biases are revealed where before 2014 there was a positive WTC/PWV bias and after that, a negative one. Spatially, HY-2A CMR products show a larger bias in polar regions compared with mid-latitude regions and tropical regions and agree better in the Antarctic than in the Arctic with NWM. Moreover, HY-2A CMR products have larger biases in the coastal area, which are all caused by the brightness temperature (TB) contamination from land or sea ice. Temporally, the WTC/PWV biases increase from October 2011 to March 2014 with a systematic bias over 1 cm in WTC and 2 mm in PWV, and the maximum RMS values of 4.62 cm in WTC and 7.61 mm in PWV occur in August 2013, which is because of the unsuitable retrieval coefficients and systematic TB measurements biases from 37 GHz band. After April 2014, the TB bias is corrected, HY-2A CMR products agree very well with NWM from April 2014 to May 2017 with the average RMS of 1.68 cm in WTC and 2.65 mm in PWV. However, since June 2017, TB measurements from the 18.7 GHz band become unstable, which led to the huge differences between HY-2A CMR products and the NWM with an average RMS of 2.62 cm in WTC and 4.33 mm in PWV. HY-2A CMR shows high accuracy when three bands work normally and further calibration for HY-2A CMR is in urgent need. Furtherly, 137 global coastal radiosonde stations were used to validate HY-2A CMR. The validation based on radiosonde data shows the same variation trend in time of HY-2A CMR compared to the results from ECMWF, which verifies the results from ECMWF.

Synergistic Use of Satellite Observations and Numerical Weather Model to Study Atmospheric Occluded Fronts

2015 ◽  
Vol 53 (9) ◽  
pp. 5269-5279 ◽  
Author(s):  
Xiaofeng Li ◽  
Xiaofeng Yang ◽  
Weizhong Zheng ◽  
Jun A. Zhang ◽  
Leonard J. Pietrafesa ◽  
...  
Keyword(s):  
Satellite Observations ◽  
Numerical Weather ◽  
Numerical Weather Model ◽  
Weather Model
Sign in / Sign up

Export Citation Format

Share Document