An electronic half-tone image recording technique

1966 ◽  
Vol 54 (2) ◽  
pp. 319-320 ◽  
Author(s):  
W.M. Waters
Keyword(s):  
Recording Technique ◽  
Image Recording ◽  
Half Tone Image

scholarly journals Direct comparison of conventional and computed radiography with a dual-image recording technique.

Radiographics ◽  
1991 ◽  
Vol 11 (2) ◽  
pp. 259-268 ◽  
Author(s):  
H MacMahon ◽  
S Sanada ◽  
K Doi ◽  
M Giger ◽  
X W Xu ◽  
...  
Keyword(s):  
Computed Radiography ◽  
Recording Technique ◽  
Image Recording ◽  
Dual Image

Transmission Scanning Electron Microscopy and Energy Analysis with the Siemens ELMISKOP 101

1972 ◽  
Vol 30 ◽  
pp. 450-451
Author(s):  
H. M. Thieringer
Keyword(s):  
Objective Lens ◽  
Transmission Microscopy ◽  
Image Recording ◽  
Mode Of Operation ◽  
Scanning Transmission ◽  
Electron Microscopes ◽  
And Performance ◽  
Convergent Beam ◽  
Ray Path ◽  
Beam Diffraction

It has repeatedly been show that with conventional electron microscopes very fine electron probes can be produced, therefore allowing various micro-techniques such as micro recording, X-ray microanalysis and convergent beam diffraction. In this paper the function and performance of an SIEMENS ELMISKOP 101 used as a scanning transmission microscope (STEM) is described. This mode of operation has some advantages over the conventional transmission microscopy (CTEM) especially for the observation of thick specimen, in spite of somewhat longer image recording times.Fig.1 shows schematically the ray path and the additional electronics of an ELMISKOP 101 working as a STEM. With a point-cathode, and using condensor I and the objective lens as a demagnifying system, an electron probe with a half-width ob about 25 Å and a typical current of 5.10-11 amp at 100 kV can be obtained in the back focal plane of the objective lens.

The DQE of an electron image recording system

1978 ◽  
Vol 36 (1) ◽  
pp. 100-101
Author(s):  
K.-H. Herrmann ◽  
D. Krahl ◽  
H.-P Rust
Keyword(s):  
Primary Electron ◽  
Ideal Case ◽  
Image Recording ◽  
Main Requirement ◽  
High Detection ◽  
Electron Image ◽  
Video Amplifier ◽  
Detection Quantum Efficiency ◽  
Selection Of ◽  
The Ideal

The high detection quantum efficiency (DQE) is the main requirement for an imagerecording system used in electron microscopy of radiation-sensitive specimens. An electronic TV system of the type shown in Fig. 1 fulfills these conditions and can be used for either analog or digital image storage and processing [1], Several sources of noise may reduce the DQE, and therefore a careful selection of various elements is imperative.The noise of target and of video amplifier can be neglected when the converter stages produce sufficient target electrons per incident primary electron. The required gain depends on the type of the tube and also on the type of the signal processing chosen. For EBS tubes, for example, it exceeds 10. The ideal case, in which all impinging electrons create uniform charge peaks at the target, is not obtainable for several reasons, and these will be discussed as they relate to a system with a scintillator, fiber-optic and photo-cathode combination as the first stage.

Application of an image management system in microscopy

1992 ◽  
Vol 50 (2) ◽  
pp. 1052-1053
Author(s):  
Richard S. Chemock
Keyword(s):  
Data Storage ◽  
Cost Savings ◽  
Image Data ◽  
Analytical Techniques ◽  
Operational Mode ◽  
Fine Grained ◽  
Image Recording ◽  
Primary Output ◽  
Capacity Data ◽  
Image Management System

One of the most common tasks in a typical analysis lab is the recording of images. Many analytical techniques (TEM, SEM, and metallography for example) produce images as their primary output. Until recently, the most common method of recording images was by using film. Current PS/2R systems offer very large capacity data storage devices and high resolution displays, making it practical to work with analytical images on PS/2s, thereby sidestepping the traditional film and darkroom steps. This change in operational mode offers many benefits: cost savings, throughput, archiving and searching capabilities as well as direct incorporation of the image data into reports.The conventional way to record images involves film, either sheet film (with its associated wet chemistry) for TEM or PolaroidR film for SEM and light microscopy. Although film is inconvenient, it does have the highest quality of all available image recording techniques. The fine grained film used for TEM has a resolution that would exceed a 4096x4096x16 bit digital image.

High-resolution measurement of birefringent fine structure in living cells using a new polarized light microscope

1995 ◽  
Vol 53 ◽  
pp. 54-55
Author(s):  
Rudolf Oldenbourg
Keyword(s):  
Light Microscope ◽  
Fluorescent Dyes ◽  
Polarized Light ◽  
Processing System ◽  
Video Camera ◽  
Molecular Organization ◽  
Computer Assisted ◽  
Image Recording ◽  
Birefringent Crystal ◽  
Technological Advances

The recent renaissance of the light microsope is fueled in part by technological advances in components on the periphery of the microscope, such as the laser as illumination source, electronic image recording (video), computer assisted image analysis and the biochemistry of fluorescent dyes for labeling specimens. After great progress in these peripheral parts, it seems timely to examine the optics itself and ask how progress in the periphery facilitates the use of new optical components and of new optical designs inside the microscope. Some results of this fruitful reflection are presented in this symposium.We have considered the polarized light microscope, and developed a design that replaces the traditional compensator, typically a birefringent crystal plate, with a precision universal compensator made of two liquid crystal variable retarders. A video camera and digital image processing system provide fast measurements of specimen anisotropy (retardance magnitude and azimuth) at ALL POINTS of the image forming the field of view. The images document fine structural and molecular organization within a thin optical section of the specimen.

Estimation of the noise in TEM image recorded on “imaging plate”

1987 ◽  
Vol 45 ◽  
pp. 748-749
Author(s):  
T. Oikawa ◽  
N. Mori ◽  
T. Katoh ◽  
Y. Harada ◽  
J. Miyahara ◽  
...  
Keyword(s):  
Low Dose ◽  
Quantum Noise ◽  
Laser Light ◽  
Imaging Plate ◽  
Total System ◽  
Electron Dose ◽  
X Ray ◽  
Image Recording ◽  
Recording Material ◽  
Highly Sensitive

The “Imaging Plate”(IP) is a highly sensitive image recording plate for X-ray radiography. It has been ascertained that the IP has superior properties and high practicability as an image recording material in a TEM. The sensitivity, one of the properties, is about 3 orders higher than that of conventional photo film. The IP is expected to be applied to low dose techniques. In this paper, an estimation of the quantum noise on the TEM image which appears in case of low electron dose on the IP is reported.In this experiment, the JEM-2000FX TEM and an IP having the same size as photo film were used.Figure 1 shows the schematic diagram of the total system including the TEM used in this experiment. In the reader, He-Ne laser light is scanned across the IP, then blue light is emitted from the IP.

Low-light-level three-dimensional video microscope with long working distance objective lenses

1994 ◽  
Vol 52 ◽  
pp. 226-227
Author(s):  
W. Lin ◽  
J. Gregorio ◽  
T.J. Holmes ◽  
D. H. Szarowski ◽  
J.N. Turner
Keyword(s):  
Three Dimensional ◽  
Light Level ◽  
Stereo Pair ◽  
Light Illumination ◽  
Initial Image ◽  
Low Light ◽  
Image Recording ◽  
Depth Discrimination ◽  
Video Microscope ◽  
Working Distance

A low-light level video microscope with long working distance objective lenses has been built as part of our integrated three-dimensional (3-D) light microscopy workstation (Fig. 1). It allows the observation of living specimens under sufficiently low light illumination that no significant photobleaching or alternation of specimen physiology is produced. The improved image quality, depth discrimination and 3-D reconstruction provides a versatile intermediate resolution system that replaces the commonly used dissection microscope for initial image recording and positioning of microelectrodes for neurobiology. A 3-D image is displayed on-line to guide the execution of complex experiments. An image composed of 40 optical sections requires 7 minutes to process and display a stereo pair.The low-light level video microscope utilizes long working distance objective lenses from Mitutoyo (10X, 0.28NA, 37 mm working distance; 20X, 0.42NA, 20 mm working distance; 50X, 0.42NA, 20 mm working distance). They provide enough working distance to allow the placement of microelectrodes in the specimen.

Tandem scanning confocal light microscopy as compared with x-ray diffraction for characterizing the behavior of clays in fluid-saturated petroleum reservoir rock

1989 ◽  
Vol 47 ◽  
pp. 148-149
Author(s):  
C.J. Stuart ◽  
B.E. Viani ◽  
J. Walker ◽  
T.H. Levesque
Keyword(s):  
Light Microscopy ◽  
Image Plane ◽  
Reservoir Rock ◽  
Depth Of Field ◽  
Objective Lens ◽  
Scanning System ◽  
Light Sources ◽  
Petroleum Reservoir ◽  
Image Recording ◽  
Scan Speed

Many techniques of imaging used to characterize petroleum reservoir rocks are applied to dehydrated specimens. In order to directly study behavior of fines in reservoir rock at conditions similar to those found in-situ these materials need to be characterized in a fluid saturated state.Standard light microscopy can be used on wet specimens but depth of field and focus cannot be obtained; by using the Tandem Scanning Confocal Microscope (TSM) images can be produced from thin focused layers with high contrast and resolution. Optical sectioning and extended focus images are then produced with the microscope. The TSM uses reflected light, bulk specimens, and wet samples as opposed to thin section analysis used in standard light microscopy. The TSM also has additional advantages: the high scan speed, the ability to use a variety of light sources to produce real color images, and the simple, small size scanning system. The TSM has frame rates in excess of normal TV rates with many more lines of resolution. This is accomplished by incorporating a method of parallel image scanning and detection. The parallel scanning in the TSM is accomplished by means of multiple apertures in a disk which is positioned in the intermediate image plane of the objective lens. Thousands of apertures are distributed in an annulus, so that as the disk is spun, the specimen is illuminated simultaneously by a large number of scanning beams with uniform illumination. The high frame speeds greatly simplify the task of image recording since any of the normally used devices such as photographic cameras, normal or low light TV cameras, VCR or optical disks can be used without modification. Any frame store device compatible with a standard TV camera may be used to digitize TSM images.

Interactive Computer-Video Modules for Health Sciences Education

1989 ◽  
Vol 28 (04) ◽  
pp. 360-363 ◽  
Author(s):  
J. McArthur ◽  
J. Bolles ◽  
J. Fine ◽  
P. Kidd ◽  
M. Bessis
Keyword(s):  
Medical Informatics ◽  
Computer Control ◽  
Health Science ◽  
Knowledge Structures ◽  
Image Recording ◽  
Central Computer ◽  
Key Word ◽  
The University ◽  
Development Group ◽  
Basic Medical

Abstract:Advances in electronic image recording and computer technologyhave resulted in a remarkable increase in the power and flexibility of interactive computer-video teaching systems. The University of Washington Health Science Videodisc Development Group first demonstrated a laser videodisc controlled by a remote central computer in 1980. Even this rudimentary unit highlighted basic medical informatics principles including: rapid accessibility; a “generic” or multi-purposed format; ease of computer control; and large collections of valid, rigorously reviewed images. Advances in medical informatics have led to the development of the following previously undescribed series of teaching units:1. The hypertext programs Hypercard, Linkway, and Guide have been used with videodiscs to develop easy-to-use instructional and reference materials. These materials demonstrate the ease with which a computer-naive instructor may develop new programs and the advantage that the intuitive nature of these programs brings to student users.2. Patient simulations using single and double screens plus pre-defined knowledge structures;3. Interactive single topic tutorials using preset knowledge structures;4. A key-word-based disc searching system;5. Electronic video microscopy;6. A series of programs developed independently by health science faculty who have purchased multi-purpose videodiscs that demonstrate the flexibility of the multi-purpose or “generic”: collection concept.

Sign in / Sign up

Export Citation Format

Share Document