Gain and noise figure spectrum control algorithm for fiber Raman amplifiers

2006 ◽  
Vol 18 (10) ◽  
pp. 1125-1127 ◽  
Author(s):  
J. Park ◽  
Jonghan Park ◽  
Pilhan Kim ◽  
Namkyoo Park
2015 ◽  
Vol 25 (2) ◽  
pp. 147
Author(s):  
Bui Trung Ninh ◽  
Nguyen Quoc Tuan ◽  
Ta Viet Hung ◽  
Nguyen The Anh ◽  
Pham Van Hoi

We present the results of investigation  for  influence of amplified spontaneous emission (ASE) noise, noise figure (NF) and  chromatic dispersion on the performance of middle-distance Dense-wavelength-division-multiplexing (DWDM) networks using low-power pumped distributed Raman amplifiers (DRAs) in two different pump configurations, i.e., forward and backward pumping. We found that the pumping configurations, ASE noise, and dispersion play an important role for improving network performance by decrease of noise figure and bit error rate (BER) of the system. Simulation results show that the lowest bit error rate and low noise figure were obtained, when using forward pumping configuration. Moreover, we have also compared ASE noise powers of the simulation with these of the experiment. These results conclude that DRA with low pump power  ($<1$~W) is the promising key technology for short-- and/or middle-distance DWDM transmission networks.


2021 ◽  
Vol 46 (5) ◽  
pp. 1157
Author(s):  
Uiara Celine de Moura ◽  
Ann Margareth Rosa Brusin ◽  
Andrea Carena ◽  
Darko Zibar ◽  
Francesco Da Ros

Author(s):  
Dimitrios Dimitropoulos ◽  
Daniel R. Solli ◽  
Ozdal Boyraz ◽  
Bahram Jalali

2018 ◽  
Vol 39 (2) ◽  
pp. 209-214
Author(s):  
Kulwinder Singh ◽  
Manjeet Singh Patterh ◽  
Manjit Singh Bhamrah

AbstractBackward pumping in fiber Raman amplifiers has been investigated in this paper in terms of on-off Raman gain, noise figure and optical signal-to-noise ratio. The results exhibit that with four first-order pumps and one second-order pump scheme can be employed to achieve 8.2 dB noise figure in 64 channel fiber optic communication system. It has also been reported that 2.65 dB gain ripple, 0.87 dB noise figure tilt and 2.02 dB OSNR tilt can be attained with the second-order pumping in fiber Raman amplifiers. The main advantage of the scheme is that only 50 mW second-order pump shows appreciable improvement in the system performance. It shows that further increase in first-order and second-order pump powers increase system noise implications.


2006 ◽  
Vol 18 (8) ◽  
pp. 980-982 ◽  
Author(s):  
B. Bristiel ◽  
Shifeng Jiang ◽  
P. Gallion ◽  
E. Pincemin

Sign in / Sign up

Export Citation Format

Share Document