Measurement of surface roughness effects on conductivity in the terahertz regime with a high-Q quasioptical resonator

2011 ◽  
Author(s):  
Benjamin B. Yang ◽  
Sarah L. Katz ◽  
John H. Booske
Keyword(s):  
Surface Roughness ◽  
Roughness Effects ◽  
High Q ◽  
Quasioptical Resonator

Surface roughness effects on the reinforcement of cement mortars through 3D printed metallic fibers

2016 ◽  
Vol 99 ◽  
pp. 305-311 ◽  
Author(s):  
Ilenia Farina ◽  
Francesco Fabbrocino ◽  
Francesco Colangelo ◽  
Luciano Feo ◽  
Fernando Fraternali
Keyword(s):  
Surface Roughness ◽  
Roughness Effects ◽  
Cement Mortars ◽  
3D Printed ◽  
Metallic Fibers

Investigation of surface roughness effects on fluid flow in passive micromixer

2013 ◽  
Vol 20 (12) ◽  
pp. 2261-2269 ◽  
Author(s):  
Gaurav Pendharkar ◽  
Raghavendra Deshmukh ◽  
Rajendra Patrikar
Keyword(s):  
Surface Roughness ◽  
Fluid Flow ◽  
Roughness Effects ◽  
Passive Micromixer

Surface roughness effects on equilibrium temperature.

1969 ◽  
Vol 6 (8) ◽  
pp. 955-957 ◽  
Author(s):  
R. G. HERING ◽  
T. F. SMITH
Keyword(s):  
Surface Roughness ◽  
Equilibrium Temperature ◽  
Roughness Effects

Surface roughness effects in turbulent boundary layers

1999 ◽  
Vol 27 (5) ◽  
pp. 450-460 ◽  
Author(s):  
P.-Å. Krogstadt ◽  
R.A. Antonia
Keyword(s):  
Surface Roughness ◽  
Boundary Layers ◽  
Turbulent Boundary Layers ◽  
Roughness Effects

An Evaluation of the Average Flow Model [1] for Surface Roughness Effects in Lubrication

1980 ◽  
Vol 102 (3) ◽  
pp. 360-366 ◽  
Author(s):  
J. L. Teale ◽  
A. O. Lebeck
Keyword(s):  
Surface Roughness ◽  
Flow Model ◽  
Two Dimensional ◽  
Roughness Effects ◽  
Important Conclusion ◽  
Average Flow ◽  
One Dimensional ◽  
Dimensional Flow ◽  
Two Dimensional Flow ◽  
Average Flow Model

The average flow model presented by Patir and Cheng [1] is evaluated. First, it is shown that the choice of grid used in the average flow model influences the results. The results presented are different from those given by Patir and Cheng. Second, it is shown that the introduction of two-dimensional flow greatly reduces the effect of roughness on flow. Results based on one-dimensional flow cannot be relied upon for two-dimensional problems. Finally, some average flow factors are given for truncated rough surfaces. These can be applied to partially worn surfaces. The most important conclusion reached is that an even closer examination of the average flow concept is needed before the results can be applied with confidence to lubrication problems.

Sign in / Sign up

Export Citation Format

Share Document