Preliminary evaluation of the effect of several management measures for the station blackout severe accident of the pressurized water reactor nuclear power plant

2011 ◽  
Author(s):  
Wen-kui Lu ◽  
Bo Zhao
Keyword(s):  
Power Plant ◽  
Nuclear Power Plant ◽  
Nuclear Power ◽  
Severe Accident ◽  
Preliminary Evaluation ◽  
Pressurized Water Reactor ◽  
Pressurized Water ◽  
Water Reactor ◽  
Management Measures ◽  
Station Blackout

scholarly journals Concentration of Radiocarbon and Its Chemical Forms in Gaseous Effluents, Environmental Air, Nuclear Waste and Primary Water of a Pressurized Water Reactor Power Plant in Hungary

Radiocarbon ◽  
1995 ◽  
Vol 37 (2) ◽  
pp. 497-504 ◽  
Author(s):  
Mihály Veres ◽  
Ede Hertelendi ◽  
György Uchrin ◽  
Eszter Csaba ◽  
István Barnabás ◽  
...  
Keyword(s):  
Power Plant ◽  
Nuclear Power Plant ◽  
Nuclear Power ◽  
Discharge Rate ◽  
Chemical Forms ◽  
Pressurized Water Reactor ◽  
Primary Coolant ◽  
Pressurized Water ◽  
Water Reactor ◽  
Environmental Air

We measured airborne releases of 14C from the Paks Pressurized Water Reactor (PWR) Nuclear Power Plant (NPP). Two continuous stack samplers collect 14C in 14CO2 and 14CnHm chemical forms. 14C activities were measured using two techniques; environmental air samples of lower activities were analyzed by proportional counting, stack samples were measured by liquid scintillation counting. 14C concentration of air in the stack varies between 80 and 200 Bqm−3. The average normalized yearly discharge rates for 1988–1993 were 0.74 TBqGW−1ey−1 for hydrocarbons and 0.06 TBqGW−1ey−1 for CO2. The discharge rate from Paks Nuclear Power Plant is about four times higher than the mean discharge value of a typical Western European PWR NPP. The higher 14C production may be apportioned to the higher level of nitrogen impurities in the primary coolant. Monitoring the long-term average excess from the NPP gave D14C = 3.5‰ for CO2 and D14C = 20‰ for hydrocarbons. We determined 14C activity concentration in the primary coolant to be ca. 4 kBq liter−1. The 14C activity concentrations of spent mixed bed ion exchange resins vary between 1.2 and 5.3 MBqkg−1 dry weight.

Analysis of RCS Depressurization Effects on Containment Temperature for Qinshan Phase II Nuclear Power Plant

2014 ◽  
Author(s):  
Liu Lili ◽  
Zhang Ming ◽  
Deng Jian
Keyword(s):  
Power Plant ◽  
Nuclear Power Plant ◽  
Nuclear Power ◽  
Hydrogen Generation ◽  
Hydrogen Combustion ◽  
Severe Accident ◽  
Generation Rate ◽  
Pressurized Water Reactor ◽  
Gas Temperature ◽  
Pressurized Water

A severe accident code was applied for modeling of a typical pressurized water reactor (PWR) nuclear power plant, and the effects of RCS depressurization on the gas temperature of the relief tank cell in the containment during a station blackout (SBO) induced accident was analyzed. The sensitivity calculation indicated that the hydrogen generation rate obviously increased due to RCS depressurization in a critical stage. The results show that RCS depressurization can play an important role in hydrogen generation rate and total accumulation, and the temperature of the containment atmosphere is highly influenced by hydrogen combustion. High temperature induced by hydrogen combustion may degrade the equipment and instruments capabilities. Based on this analysis, a feasible strategy of RCS depressurization for mitigating the accident consequence is provided for developing the capacity of the SBO treatment of Qinshan Phase Nuclear Power Plant (QSP-II NPP).

Study on the Small Pressurized Water Reactor Based on Fully Ceramic Microencapsulated Fuel

2021 ◽  
Author(s):  
Jin Feng Huang
Keyword(s):  
Thermal Conductivity ◽  
Silicon Carbide ◽  
Power Plant ◽  
Nuclear Power Plant ◽  
Nuclear Power ◽  
Pressurized Water Reactor ◽  
Pressurized Water ◽  
Water Reactor ◽  
Carbide Matrix ◽  
Silicon Carbide Matrix

Abstract After Fukushima nuclear power plant disaster, the efforts to overcome these defects of PWRs were carried out, such as replacing the cladding and fuel materials. One of these feasible efforts is using Fully Ceramic Microencapsulated (FCM) fuel replacement traditional UO2 pellets fuel into PWR. The FCM fuels are composed of Tri-structural-isotropic (TRISO) particles embedded in silicon carbide matrix. The TRISO fuel can hold its containment integrity and without fission production releases under the design temperature limit of 1600 °C. Furthermore, the silicon carbide matrix will benefit the thermal conductivity, radiation damage resistance, environmental stability and proliferation resistance. Consequently, the safety of the reactor could be significantly improved with FCM fuel instead of the conventional UO2 pellet fuel in PWR. We also analyzed the temperature distribution for the FCM fuel compared the traditional UO2 pellets, the calculation indicated that the centerline temperature is lower than UO2 pellets due to FCM higher thermal conductivity. The calculation demonstrated that, utilizing FCM replacement of conventional UO2 fuel rod is feasible and more security in a small pressurized water reactor. In this paper, a small pressurized water reactor utilizing FCM fuel is considered. A 17 × 17 fuel assemblies with Zircalloy cladding was applied in conceptual design through a preliminary neutronics and thermal hydraulics analysis. The reactor physics is accomplished, including the refuel cycle length, the effective multiplication factor, power distribution analysis being discussed. The Soluble Boron Free (SBF) concepts are introduced in small PWR, as a result, it makes the nuclear power plant more simpler and economical. FCM fuel loading has a very high excess reactivity at the beginning of reactor core life, and it is important to flat reactivity curve during operation, or to minimize excess reactivity during the core life. Consequently, conventional burnable poison configurations were introduced to suppress excess reactivity control at beginning of cycle.

scholarly journals The Impact of Climate Changes on the Thermal Performance of a Proposed Pressurized Water Reactor: Nuclear-Power Plant

2014 ◽  
Vol 2014 ◽  
pp. 1-7 ◽  
Author(s):  
Said M. A. Ibrahim ◽  
Mohamed M. A. Ibrahim ◽  
Sami. I. Attia
Keyword(s):  
Power Plant ◽  
Nuclear Power Plant ◽  
Thermal Performance ◽  
Nuclear Power ◽  
Cooling Water ◽  
Plant Performance ◽  
Pressurized Water Reactor ◽  
Pressurized Water ◽  
Water Reactor ◽  
The Impact

This paper presents a methodology for studying the impact of the cooling water temperature on the thermal performance of a proposed pressurized water reactor nuclear power plant (PWR NPP) through the thermodynamic analysis based on the thermodynamic laws to gain some new aspects into the plant performance. The main findings of this study are that an increase of one degree Celsius in temperature of the coolant extracted from environment is forecasted to decrease by 0.39293 and 0.16% in the power output and the thermal efficiency of the nuclear-power plant considered, respectively.

scholarly journals Radiocarbon Releases At the Krško Nuclear Power Plant

Radiocarbon ◽  
1997 ◽  
Vol 39 (3) ◽  
pp. 285-292 ◽  
Author(s):  
Barbara Vokal ◽  
Ivan Kobal
Keyword(s):  
Power Plant ◽  
Nuclear Power Plant ◽  
Tree Rings ◽  
Indoor Air ◽  
Nuclear Power ◽  
Monitoring Program ◽  
Pressurized Water Reactor ◽  
Pressurized Water ◽  
Water Reactor ◽  
Radioactivity Monitoring

Since 1991, radiocarbon analyses of exhaust air have been part of the regular radioactivity monitoring program at the Krško Nuclear Power Plant (NPP), a Westinghouse 632 MWe pressurized water reactor (PWR). Activity of CO2 and hydrocarbons has been identified; the former contributes ca. 43%. A normalized release of total 14C of 0.219 TBqGWe−1a−1 was obtained. Indoor air 14C concentrations in selected rooms inside the plant have generally been <5 Bq m−3, although rare peaks of >1000 Bq m−3 may be reached. Tree rings have shown slight enhanced 14C activity due to the operation of the plant.

Sign in / Sign up

Export Citation Format

Share Document