Continuous refractive index sensing based on carbon-nanotube-deposited joint single-mode multi-mode fiber segment

2015 ◽  
Author(s):  
Y. C. Tan ◽  
J. Y. Huang ◽  
K. K. Chow
Keyword(s):  
Refractive Index ◽  
Carbon Nanotube ◽  
Single Mode ◽  
Refractive Index Sensing ◽  
Fiber Segment ◽  
Multi Mode

scholarly journals Up-down Taper Based In-Fiber Mach-Zehnder Interferometer for Liquid Refractive Index Sensing

Sensors ◽  
2019 ◽  
Vol 19 (24) ◽  
pp. 5440 ◽  
Author(s):  
Xiaopeng Han ◽  
Chunyu Liu ◽  
Shengxu Jiang ◽  
Shuo Leng ◽  
Jiuru Yang
Keyword(s):  
Refractive Index ◽  
Temperature Fluctuation ◽  
Extinction Ratio ◽  
Single Mode ◽  
Zehnder Interferometer ◽  
Structure Parameters ◽  
Refractive Index Sensing ◽  
Polarization Maintaining Fiber ◽  
Polarization Maintaining ◽  
Mach Zehnder Interferometer

A novel in-fiber Mach-Zehnder interferometer based on cascaded up-down-taper (UDT) structure is proposed by sandwiching a piece of polarization maintaining fiber between two single-mode fibers (SMF) and by utilizing over-fusion splicing method. The dual up tapers respectively act as fiber splitter/combiner, the down taper acts as an optical attenuator. The structure parameters are analyzed and optimized. A larger interference fringe extinction ratio ~15 dB is obtained to achieve refractive index (RI) sensing based on intensity demodulation. The experimental results show that the RI sensitivity is −310.40 dB/RIU with the linearity is improved to 0.99 in the range of 1.3164–1.3444. The corresponding resolution can reach 3.22 × 10−5 RIU, which is 6.8 times higher than wavelength demodulation. The cross sensitivity which caused by temperature fluctuation is less than 1.4 × 10−4.

Refractive-index-sensing RF comb using intra-cavity multi-mode interference fiber sensor

2018 ◽  
Author(s):  
Ryo Oe ◽  
Kosuke Nagai ◽  
Takeo Minamikawa ◽  
Shuji Taue ◽  
Hideki Fukano ◽  
...  
Keyword(s):  
Refractive Index ◽  
Fiber Sensor ◽  
Refractive Index Sensing ◽  
Multi Mode ◽  
Mode Interference

Graphene oxide-polymethylmethacrylate polymer waveguide device based on near infrared fingerprint spectrum for refractive index sensing

2017 ◽  
Vol 40 (8) ◽  
pp. 2607-2610
Author(s):  
Botao Wang ◽  
Qi Wang ◽  
Lingxin Kong ◽  
Riqing Lv
Keyword(s):  
Refractive Index ◽  
Graphene Oxide ◽  
Near Infrared ◽  
High Sensitivity ◽  
Single Mode ◽  
Glycerol Solution ◽  
Refractive Index Measurement ◽  
Polymer Waveguide ◽  
Refractive Index Sensing ◽  
High Measurement

A graphene oxide-polymethylmethacrylate (GO-PMMA) microfiber sensor is proposed and experimentally demonstrated in this paper, which is based on the absorption principle of near infrared spectra for external refractive index sensing. The sensor was fabricated by splicing a section of 1 mm GO-PMMA between two tapered single mode fibers. The hydrophilic groups of graphene oxide can be used to measure the proportion of water in glycerol solution, and achieve the goal of refractive index measurement indirectly. Experiments were conducted for moisture content of 4.3%~45% (refractive index range from 1.3400 to 1.4054) in glycerin solution. Different concentrations of glycerol solution have different intensities of absorption peaks near 1530 nm wavelength. The absorption peak power near 1530 nm wavelength responses to the external refractive index was experimentally studied. The results show that the sensor possesses a high sensitivity of 167.39 dB/RIU in the refractive index range of 1.34~1.41 and has a good linearity response to external refractive index. The proposed sensor is attractive owing to its high measurement speed, accurate, no pollution and lower cost, and is suited for long-term online real-time measurement.

Sign in / Sign up

Export Citation Format

Share Document