Assimilating Passive Microwave Brightness Temperature Data into a Land Surface Model to Improve the Snow Depth Predictability

2006 ◽  
Author(s):  
T. Graf ◽  
T. Koike ◽  
X. Li ◽  
M. Hirai ◽  
H. Tsutsui
Keyword(s):  
Brightness Temperature ◽  
Land Surface ◽  
Snow Depth ◽  
Land Surface Model ◽  
Temperature Data ◽  
Passive Microwave ◽  
Surface Model ◽  
Microwave Brightness Temperature

scholarly journals Exploring the Utility of Machine Learning-Based Passive Microwave Brightness Temperature Data Assimilation over Terrestrial Snow in High Mountain Asia

2019 ◽  
Vol 11 (19) ◽  
pp. 2265 ◽  
Author(s):  
Yonghwan Kwon ◽  
Barton A. Forman ◽  
Jawairia A. Ahmad ◽  
Sujay V. Kumar ◽  
Yeosang Yoon
Keyword(s):  
Standard Deviation ◽  
Data Assimilation ◽  
Brightness Temperature ◽  
Liquid Water ◽  
Temperature Data ◽  
Passive Microwave ◽  
Support Vector ◽  
Surface Model ◽  
High Mountain ◽  
Microwave Brightness Temperature

This study explores the use of a support vector machine (SVM) as the observation operator within a passive microwave brightness temperature data assimilation framework (herein SVM-DA) to enhance the characterization of snow water equivalent (SWE) over High Mountain Asia (HMA). A series of synthetic twin experiments were conducted with the NASA Land Information System (LIS) at a number of locations across HMA. Overall, the SVM-DA framework is effective at improving SWE estimates (~70% reduction in RMSE relative to the Open Loop) for SWE depths less than 200 mm during dry snowpack conditions. The SVM-DA framework also improves SWE estimates in deep, wet snow (~45% reduction in RMSE) when snow liquid water is well estimated by the land surface model, but can lead to model degradation when snow liquid water estimates diverge from values used during SVM training. In particular, two key challenges of using the SVM-DA framework were observed over deep, wet snowpacks. First, variations in snow liquid water content dominate the brightness temperature spectral difference (ΔTB) signal associated with emission from a wet snowpack, which can lead to abrupt changes in SWE during the analysis update. Second, the ensemble of SVM-based predictions can collapse (i.e., yield a near-zero standard deviation across the ensemble) when prior estimates of snow are outside the range of snow inputs used during the SVM training procedure. Such a scenario can lead to the presence of spurious error correlations between SWE and ΔTB, and as a consequence, can result in degraded SWE estimates from the analysis update. These degraded analysis updates can be largely mitigated by applying rule-based approaches. For example, restricting the SWE update when the standard deviation of the predicted ΔTB is greater than 0.05 K helps prevent the occurrence of filter divergence. Similarly, adding a thin layer (i.e., 5 mm) of SWE when the synthetic ΔTB is larger than 5 K can improve SVM-DA performance in the presence of a precipitation dry bias. The study demonstrates that a carefully constructed SVM-DA framework cognizant of the inherent limitations of passive microwave-based SWE estimation holds promise for snow mass data assimilation.

Examination of Dielectric Models in AMSR2 Soil Moisture Estimation Algorithm for Japanese and Cambodian Soils

2020 ◽  
Author(s):  
Kumiko Tsujimoto ◽  
Tetsu Ohta
Keyword(s):  
Soil Moisture ◽  
Brightness Temperature ◽  
Land Surface ◽  
Surface Soil ◽  
Land Surface Model ◽  
Mixing Model ◽  
Dielectric Behavior ◽  
Moisture Distribution ◽  
Surface Model ◽  
In Situ Observation

<p>The Advanced Microwave Scanning Radiometer 2 (AMSR2) onboard the Global Change Observation Mission – Water (GCOM-W) satellite provides global surface soil moisture as well as other water-related variables over the earth. With its brightness temperature observations at 10 and 36 GHz, the global soil moisture product is operationally created by the Japan Aerospace Exploration Agency (JAXA) based on the Koike’s algorithm (Koike et al., 2004) using the Polar Index (PI) and the Index of Soil Wetness (ISW). A land data assimilation system, LDAS-UT, has been also developed by Yang et al. (2007) to retrieve the optimized soil moisture estimates using both the brightness temperature observation and a land surface model.</p><p>In this study, we applied the distributed hydrological model, WEB-DHM (Wang et al., 2009), which incorporates the same land surface model with LDAS-UT, to a river basin in Cambodia and then calculated the brightness temperature at 6.9GHz from the simulated soil moisture distribution, using the same forward model as LDAS-UT. The temporal and spatial distribution of soil moisture was calibrated and validated against in-situ observation through river discharge using WEB-DHM, and the calculated brightness temperature was compared with the AMSR2 observation at 6.9 GHz. In addition to the dielectric mixing model by Dobson (Dobson et al., 1985) which is originally used in the LDAS-UT as well as in the JAXA's soil moisture retrieval algorithm, the performance of the Mironov model (Mironov et al., 2004) was examined as an alternative for the dielectric mixing model in the forward calculation and the calculated results from the two models were compared.</p><p>Along with the hydrological simulation, field measurements and laboratory experiments were conducted in Cambodia and Japan to evaluate the dielectric behavior of wet soils with different soil water content at a point scale. A ground microwave radiometer was temporally installed over a paddy field in Japan to measure the brightness temperature at 6.9GHz directly from the near surface. Soil samples were also taken from this field as well as several other locations in Japan and Cambodia to measure the permittivity with different soil moisture content with a network analyzer in the laboratory, in order to examine the dielectric behavior of wet soils for different soil textures. The measured results were then compared with the Dobson and Mironov models to evaluate their performance for Asian soils.</p>

The Contributions of Gauge-Based Precipitation and SMAP Brightness Temperature Observations to the Skill of the SMAP Level-4 Soil Moisture Product

2020 ◽  
Author(s):  
Rolf H. Reichle ◽  
Qing Liu ◽  
Joseph V. Ardizzone ◽  
Wade T. Crow ◽  
Gabrielle J. M. De Lannoy ◽  
...  
Keyword(s):  
Soil Moisture ◽  
Brightness Temperature ◽  
Land Surface ◽  
Root Zone ◽  
Land Surface Model ◽  
Surface Model ◽  
Meteorological Forcing ◽  
Earth Observing System ◽  
Error Surface

AbstractSoil Moisture Active Passive (SMAP) mission L-band brightness temperature (Tb) observations are routinely assimilated into the Catchment land surface model to generate Level-4 Soil Moisture (L4_SM) estimates of global surface and root-zone soil moisture at 9-km, 3-hourly resolution with ~2.5-day latency. The Catchment model in the L4_SM algorithm is driven with ¼-degree, hourly surface meteorological forcing data from the Goddard Earth Observing System (GEOS). Outside of Africa and the high latitudes, GEOS precipitation is corrected using Climate Prediction Center Unified (CPCU) gauge-based, ½-degree, daily precipitation. L4_SM soil moisture was previously shown to improve over land model-only estimates that use CPCU precipitation but no Tb assimilation (CPCU_SIM). Here, we additionally examine the skill of model-only (CTRL) and Tb assimilation-only (SMAP_DA) estimates derived without CPCU precipitation. Soil moisture is assessed versus in situ measurements in well-instrumented regions and globally through the Instrumental Variable (IV) method using independent soil moisture retrievals from the Advanced Scatterometer. At the in situ locations, SMAP_DA and CPCU_SIM have comparable soil moisture skill improvements relative to CTRL for the unbiased root-mean-square error (surface and root-zone) and correlation metrics (root-zone only). In the global average, SMAP Tb assimilation increases the surface soil moisture anomaly correlation by 0.10-0.11 compared to an increase of 0.02-0.03 from the CPCU-based precipitation corrections. The contrast is particularly strong in central Australia, where CPCU is known to have errors and observation-minus-forecast Tb residuals are larger when CPCU precipitation is used. Validation versus streamflow measurements in the contiguous U.S. reveals that CPCU precipitation provides most of the skill gained in L4_SM runoff estimates over CTRL.

Sign in / Sign up

Export Citation Format

Share Document