Robust Fault-tolerant Control for Uncertain NCS Based on Dynamic Output Feedback

2011 ◽  
Author(s):  
Li Wei ◽  
Cao Huichao ◽  
Wang Jun
Keyword(s):  
Output Feedback ◽  
Fault Tolerant ◽  
Fault Tolerant Control ◽  
Dynamic Output Feedback ◽  
Dynamic Output

scholarly journals Dynamic Output Feedback Based Active Decentralized Fault-Tolerant Control for Reconfigurable Manipulator with Concurrent Failures

2015 ◽  
Vol 2015 ◽  
pp. 1-14
Author(s):  
Yuanchun Li ◽  
Fan Zhou ◽  
Bo Zhao
Keyword(s):  
Output Feedback ◽  
Fault Tolerant ◽  
Fault Tolerant Control ◽  
Fault Detection And Isolation ◽  
System Model ◽  
Linear Matrix ◽  
Dynamic Output Feedback ◽  
Actuator Fault ◽  
Dynamic Output ◽  
Reconfigurable Manipulators

The goal of this paper is to describe an active decentralized fault-tolerant control (ADFTC) strategy based on dynamic output feedback for reconfigurable manipulators with concurrent actuator and sensor failures. Consider each joint module of the reconfigurable manipulator as a subsystem, and treat the fault as the unknown input of the subsystem. Firstly, by virtue of linear matrix inequality (LMI) technique, the decentralized proportional-integral observer (DPIO) is designed to estimate and compensate the sensor fault online; hereafter, the compensated system model could be derived. Then, the actuator fault is estimated similarly by another DPIO using LMI as well, and the sufficient condition of the existence ofH∞fault-tolerant controller in the dynamic output feedback is presented for the compensated system model. Furthermore, the dynamic output feedback controller is presented based on the estimation of actuator fault to realize active fault-tolerant control. Finally, two 3-DOF reconfigurable manipulators with different configurations are employed to verify the effectiveness of the proposed scheme in simulation. The main advantages of the proposed scheme lie in that it can handle the concurrent faults act on the actuator and sensor on the same joint module, as well as there is no requirement of fault detection and isolation process; moreover, it is more feasible to the modularity of the reconfigurable manipulator.

Sign in / Sign up

Export Citation Format

Share Document