Electromagnetic Effect on Underground Pipeline of the Lightning Strike 330kV Transmission Lines

2017 ◽  
Author(s):  
Xing-Ting Liu ◽  
Wei Wang ◽  
Hua Yu
Keyword(s):  
Transmission Lines ◽  
Lightning Strike ◽  
Underground Pipeline ◽  
Electromagnetic Effect

scholarly journals Effect of indirect lightning strike to 66kV transmission line in Java-Bali system

2018 ◽  
Vol 197 ◽  
pp. 11001
Author(s):  
Aristo Adi Kusuma ◽  
Putu Agus Aditya Pramana ◽  
Brian Bramantyo S.D.A. Harsono ◽  
Buyung Sofiarto Munir
Keyword(s):  
Transmission Line ◽  
Transmission Lines ◽  
Lightning Strike ◽  
Actual Condition ◽  
Peak Current ◽  
Lightning Strikes ◽  
Detection Systems ◽  
Current Magnitude ◽  
Lightning Detection ◽  
Insulator Flashover

Based on Java-Bali grid disturbance data, the 66kV transmission lines that is close to or intersect with 150kV or 500kV transmission line is often experienced earth fault due to insulator flashover. The insulator flashover can be caused by indirect lightning strike since lightning strikes tend to strike higher structure. Therefore, this paper will determine the effect of indirect lightning strike on 150kV or 500kV transmission line to 66kV transmission line by modeling and simulation using application of transient analysis. Variation of lightning peak current magnitude and gap between 66kV transmission line and transmission line with higher voltage is performed during simulation. The range of peak current magnitude follows the data from lightning detection systems, while the value of gap follows the data from actual condition. It is found that higher current peak and closer gap will cause higher transient overvoltage on insulator of 66kV transmission line thus insulator flashover may occur more frequent. Addition of earth wire on 66kV transmission line and gap between each transmission by organizing the sag of conductor can be performed to minimize the insulator flashover.

scholarly journals Analysis of Lightning Performance on 345 kV Transmission Lines Using Python Programming

2020 ◽  
Vol 3 (3) ◽  
pp. 65-76
Author(s):  
Fri Murdiya ◽  
Rofi Hariadi
Keyword(s):  
Transmission Lines ◽  
Power Transmission ◽  
Electrical Power ◽  
Object Oriented Programming ◽  
Computer Application ◽  
Lightning Strike ◽  
Percentage Error ◽  
Power Transmission Lines ◽  
Shielding Failure ◽  
Python Programming

One of main causes of interruption of electrical power supply is the lightning strike on overhead power transmission lines. The lightning performance of transmission line can be determined by value of shielding failure flashover rate (SFFOR) and back flashover rate (BFOR). The object of this study is to create a computer application to compute lightning performance on the transmission lines using Python programming. Pythons package tkinter used for program interface window. Application programming is done by using the concept of object-oriented programming (OOP) using Pythons keyword class. Validation shows that the application has applied the method correctly with a percentage error 0 % for SFFOR and 3.14 % for BFOR. The application can do analysis on the factors that affecting SFFOR and BFOR such as the effect of thunder day, tower foot resistance, and number of isolator disk. The results obtained in this study is computer application that can perform lightning performance analysis and analysis of factors that can affect it, such as thunder day, tower foot resistance and the number of isolator disk.

Analysis on Lightning Withstand Level of Back Striking Flashover for Double-Circuit Transmission Line

2014 ◽  
Vol 1070-1072 ◽  
pp. 1050-1055 ◽  
Author(s):  
Shi Jun Xie ◽  
Jian Ming Li ◽  
Yu Han Jiang ◽  
Yu Zhang
Keyword(s):  
Power System ◽  
Simulation Model ◽  
Transmission Lines ◽  
Physical Mechanism ◽  
Transient Simulation ◽  
Lightning Strike ◽  
Significant Component ◽  
The Earth ◽  
Model Combining ◽  
The Stability

The double-circuit transmission lines have already been the significant component of power system. Because of the symmetric insulation of the two circuits, the case that both circuits trip out often happens when the tower suffer lightning strike. And it harms the stability of power system and causes serious impacts to power equipments. In this paper, an electric-magnetic transient simulation model was established. Using this model, combining the analysis of physical mechanism of back striking trip-out, the influences of earth resistance, height of tower and length of insulator on the lightning withstand level of back striking (LWLBS) were clarified. The LWLBS of high tower is much low, therefore the relative high tower should be paid more attention to defense the back striking. Reducing the earth resistance and increasing the length of insulator can both upgrade the LWLBS observably. Especially, reducing the earth resistance can enhance the effect of upgrading the LWLBS by increasing the length of insulator.

scholarly journals Lightning Performance of Unshielded 220kV Transmission Lines Equipped with Metal-oxide Arresters

2021 ◽  
Vol 242 ◽  
pp. 03009
Author(s):  
Pengkang Xie ◽  
Zhen Fang
Keyword(s):  
Metal Oxide ◽  
Simulation Model ◽  
Energy Absorption ◽  
Transmission Lines ◽  
Power Supply ◽  
Lightning Strike ◽  
Transmission Tower ◽  
Absorbed Energy ◽  
Lightning Strikes ◽  
Grounding Resistance

Overhead ground wires have been proved to be effective to protect conductors from direct lightning strikes, but breakouts of ground wires have been frequently reported. In order to prevent ground wire breakout incidents to happen, unshielded 220kV lines equipped with metal oxide arresters (MOAs) whole line have been proposed in this paper. After cancelling ground wire, lightning strike risk of transmission lines becomes much higher. In order to improve the anti-lightning abilities of unshielded transmission lines, it is necessary to obtain the lightning energy absorption ability of these MOAs. In this paper, simulation model of MOA equipped unshielded 220kV transmission line was built, the influences of lightning parameters, striking occurrence point and grounding resistance of transmission tower on the absorbed energy of MOAs were calculated, and the suggested energy absorption ability of MOA was given, which can give references for the improvement of power supply reliability of transmission lines.

scholarly journals The application of the technology of sensor networks for the intellectualization of the overhead power transmission lines

2020 ◽  
Vol 220 ◽  
pp. 01071
Author(s):  
Dmitry Ivanov ◽  
Marat Sadykov ◽  
Aleksandr Golenishchev-Kutuzov ◽  
Danil Yaroslavsky ◽  
Tatyana Galieva ◽  
...  
Keyword(s):  
Transmission Lines ◽  
Power Transmission ◽  
Short Circuit ◽  
Ice Formation ◽  
Lightning Strike ◽  
Power Transmission Lines ◽  
Wide Range ◽  
Overhead Power Transmission Lines ◽  
The Wire

The length of overhead power transmission lines in the Russian Federation is over 2.8 million kilometers. Power grids are rapidly becoming obsolete. The level of deterioration of the equipment achieves 70% [1]. This leads to breakdowns on overhead power transmission lines and reduce the quality of electricity supply. One of the focus areas towards improving the situation is a deep modernization of the power grid with an orientation on energy efficiency. The purpose of this work is the creation a system for operative monitoring of the technical condition of high-voltage power-transmission lines based on modular devices. The modular device is configured depending on the issues at hand: control of ice formation; control of ice melting; localization of the place of short circuit, breakage, lightning strike; determination of electrical loads on the wire or control of the load of overhead power transmission lines; determination of mechanical loads at the wire suspension point; determination of conditions for the occurrence of ice formation, determination of defects in insulators. This will equip the overhead line diagnostic systems without serious financial costs by simple installation on the wire of the developed device which design allows to change the configuration of the equipment and solve a wide range of tasks.

scholarly journals Calculation of OPGW Strands Melting due to DC Arc Discharge Simulating High-Energy Lightning Strike

2019 ◽  
Vol 6 (2) ◽  
pp. 188-192
Author(s):  
M. Iwata ◽  
T. Nakano ◽  
M. Kotari ◽  
T. Ohtaka ◽  
Y. Goda
Keyword(s):  
Tensile Strength ◽  
Transmission Lines ◽  
Power Transmission ◽  
Arc Discharge ◽  
Melting Behavior ◽  
High Energy ◽  
Composite Fiber ◽  
The Other ◽  
Lightning Strike ◽  
Dc Arc

Metal strands of OPGWs (composite fiber-optic ground wires) installed in overhead power transmission lines are sometimes melted and broken when struck by high-energy lightning. This paper presents the calculation results regarding OPGW strands melting behavior when struck by DC arcs simulating high-energy lightning. The calculations revealed that the melted volume of the strand was 26% of the strand volume before the arc test, i.e. the rate of the non-melted volume of the strand was 74%. On the other hand, the residual tensile strength of the melted strand was 69% of the other non-melted strands after DC arc test. These results suggest there is a strong correlation between the calculated non-melted volume of the strand and the measured residual tensile strength of the melted strand.

Sign in / Sign up

Export Citation Format

Share Document