Effect of Increasing Rated Torque of PMSG with Variable Wind Speed on Per Phase Output Voltage for Off-Grid Wind Energy Conversion System

2015 ◽  
Author(s):  
Nirmal ◽  
Pradeep Kumar
Keyword(s):  
Wind Speed ◽  
Wind Energy ◽  
Energy Conversion ◽  
Output Voltage ◽  
Wind Energy Conversion System ◽  
Wind Energy Conversion ◽  
Conversion System ◽  
Energy Conversion System ◽  
Variable Wind

scholarly journals A Controller for Optimum Electrical Power Extraction from a Small Grid-Interconnected Wind Turbine

Energies ◽  
2020 ◽  
Vol 13 (21) ◽  
pp. 5809
Author(s):  
Tania García-Sánchez ◽  
Arbinda Kumar Mishra ◽  
Elías Hurtado-Pérez ◽  
Rubén Puché-Panadero ◽  
Ana Fernández-Guillamón
Keyword(s):  
Wind Speed ◽  
Wind Energy ◽  
Energy Conversion ◽  
Wind Turbine ◽  
Wind Power ◽  
Maximum Power ◽  
Wind Energy Conversion System ◽  
Wind Energy Conversion ◽  
Conversion System ◽  
Energy Conversion System

Currently, wind power is the fastest-growing means of electricity generation in the world. To obtain the maximum efficiency from the wind energy conversion system, it is important that the control strategy design is carried out in the best possible way. In fact, besides regulating the frequency and output voltage of the electrical signal, these strategies should also extract energy from wind power at the maximum level of efficiency. With advances in micro-controllers and electronic components, the design and implementation of efficient controllers are steadily improving. This paper presents a maximum power point tracking controller scheme for a small wind energy conversion system with a variable speed permanent magnet synchronous generator. With the controller, the system extracts optimum possible power from the wind speed reaching the wind turbine and feeds it to the grid at constant voltage and frequency based on the AC–DC–AC conversion system. A MATLAB/SimPowerSystems environment was used to carry out the simulations of the system. Simulation results were analyzed under variable wind speed and load conditions, exhibiting the performance of the proposed controller. It was observed that the controllers can extract maximum power and regulate the voltage and frequency under such variable conditions. Extensive results are included in the paper.

MPPT Control for Current Source Converter Based PMSG Wind Energy Conversion System

2012 ◽  
Vol 614-615 ◽  
pp. 1460-1464
Author(s):  
Jian Yu Bao ◽  
Wei Bing Bao ◽  
Jie Gong
Keyword(s):  
Wind Energy ◽  
Energy Conversion ◽  
Current Source ◽  
Maximum Power ◽  
Wind Energy Conversion System ◽  
Wind Energy Conversion ◽  
Current Source Converter ◽  
Conversion System ◽  
Energy Conversion System ◽  
Variable Wind

Current source converter (CSC) configuration tailored to high-power grid-connected wind energy conversion system (WECS) has been an attractive solution for direct drive of permanent magnet synchronous generators (PMSGs). A maximum power point tracking (MPPT) scheme for a PMSG-based WECS is presented in this paper. On the generator side, a fully controlled current source converter is inserted as a circuit interface to handle a wide range of the variable wind speeds. Rectifier side controller extracts maximum power through closed-loop regulation of generator speed. The available maximum power fed to the grid is adjusted by regulating dc-link output current of CSC according to the variable wind speed. Simulation results obtained from a megawatt PSIM model are provided to verify the proposed concepts.

scholarly journals Control of PMSG based variable speed wind energy conversion system connected to the grid with PI and ADRC approach

2020 ◽  
Vol 11 (2) ◽  
pp. 953
Author(s):  
Youssef Barradi ◽  
Khalida Zazi ◽  
Malika Zazi ◽  
Naoufel Khaldi
Keyword(s):  
Wind Speed ◽  
Wind Energy ◽  
Energy Conversion ◽  
High Performance ◽  
Synchronous Generator ◽  
Wind Energy Conversion System ◽  
Wind Energy Conversion ◽  
Disturbance Rejection Control ◽  
Conversion System ◽  
Energy Conversion System

This paper presents the modeling and simulation of wind energy Conversion System using the Permanent Magnet Synchronous Generator (PMSG). <br /> The objectives are: to extract the maximum power of the wind speed by controlling the electromagnetic torque of the PMSG, to maintain constant the DC-link voltage despite the wind speed variations and to attain the unity power factor. In order to ensure a regulation with high performance and a good robustness against the internal and the external disturbances, a new control strategy called the Active Disturbance Rejection Control (ADRC) is used. Therefore, the Analysis and simulation of the ADRC and PI controllers are developed with MATLAB/Simulink software. The performance of these controllers is compared in term of references tracking, robustness <br /> and grid faults.

Sign in / Sign up

Export Citation Format

Share Document