Delay Spread Characteristics of Wideband MIMO Channels Based on Outdoor Non-Line-of-Sight Measurements

2007 ◽  
Author(s):  
Yaoqing Lamar Yang ◽  
Zhangdui Zhong ◽  
Guanghan Xu
Keyword(s):  
Line Of Sight ◽  
Delay Spread ◽  
Mimo Channels ◽  
Non Line Of Sight

Integrating the Non-Line of Sight Launching System (NLOS-LS) in the United States Navy

2007 ◽  
Author(s):  
Jonathon Emis ◽  
Bryan Huang ◽  
Timothy Jones ◽  
Mei Li ◽  
Don Tumbocon
Keyword(s):  
United States ◽  
United States Navy ◽  
The United States ◽  
Line Of Sight ◽  
Non Line Of Sight

scholarly journals Interference Mitigation for Visible Light Communications in Underground Mines Using Angle Diversity Receivers

Sensors ◽  
2020 ◽  
Vol 20 (2) ◽  
pp. 367 ◽  
Author(s):  
Pablo Palacios Játiva ◽  
Milton Román Cañizares ◽  
Cesar A. Azurdia-Meza ◽  
David Zabala-Blanco ◽  
Ali Dehghan Firoozabadi ◽  
...  
Keyword(s):  
Visible Light ◽  
Mine Working ◽  
Channel Model ◽  
Underground Mining ◽  
Cumulative Distribution ◽  
Line Of Sight ◽  
Delay Spread ◽  
Noise Power ◽  
Working Face ◽  
Angle Diversity

This paper proposes two solutions based on angle diversity receivers (ADRs) to mitigate inter-cell interference (ICI) in underground mining visible light communication (VLC) systems, one of them is a novel approach. A realistic VLC system based on two underground mining scenarios, termed as mining roadway and mine working face, is developed and modeled. A channel model based on the direct component in line-of-sight (LoS) and reflections of non-line-of-sight (NLoS) links is considered, as well as thermal and shot noises. The design and mathematical models of a pyramid distribution and a new hemi-dodecahedral distribution are addressed in detail. The performances of these approaches, accompanied by signal combining schemes, are evaluated with the baseline of a single photo-diode in reception. Results show that the minimum lighting standards established in both scenarios are met. As expected, the root-mean-square delay spread decreases as the distance between the transmitters and receivers increases. Furthermore, the hemi-dodecahedron ADR in conjunction with the maximum ratio combining (MRC) scheme, presents the best performance in the evaluated VLC system, with a maximum user data rate of 250 Mbps in mining roadway and 120 Mbps in mine working face, received energy per bit/noise power of 32 dB and 23 dB, respectively, when the bit error rate corresponds to 10 − 4 , and finally, values of 120 dB in mining roadway and 118 dB in mine working face for signal-to-interference-plus-noise ratio are observed in a cumulative distribution function.

scholarly journals Low-cost SPAD sensing for non-line-of-sight tracking, material classification and depth imaging

2021 ◽  
Vol 40 (4) ◽  
pp. 1-12
Author(s):  
Clara Callenberg ◽  
Zheng Shi ◽  
Felix Heide ◽  
Matthias B. Hullin
Keyword(s):  
Low Cost ◽  
Line Of Sight ◽  
Depth Imaging ◽  
Material Classification ◽  
Non Line Of Sight

scholarly journals Target Localization via Integrated and Segregated Ranging Based on RSS and TOA Measurements

Sensors ◽  
2019 ◽  
Vol 19 (2) ◽  
pp. 230 ◽  
Author(s):  
Slavisa Tomic ◽  
Marko Beko
Keyword(s):  
State Of The Art ◽  
Hybrid Approach ◽  
Critical Distance ◽  
Heuristic Approach ◽  
Target Localization ◽  
Line Of Sight ◽  
Time Of Arrival ◽  
Individual Measurement ◽  
New Approach ◽  
Non Line Of Sight

This work addresses the problem of target localization in adverse non-line-of-sight (NLOS) environments by using received signal strength (RSS) and time of arrival (TOA) measurements. It is inspired by a recently published work in which authors discuss about a critical distance below and above which employing combined RSS-TOA measurements is inferior to employing RSS-only and TOA-only measurements, respectively. Here, we revise state-of-the-art estimators for the considered target localization problem and study their performance against their counterparts that employ each individual measurement exclusively. It is shown that the hybrid approach is not the best one by default. Thus, we propose a simple heuristic approach to choose the best measurement for each link, and we show that it can enhance the performance of an estimator. The new approach implicitly relies on the concept of the critical distance, but does not assume certain link parameters as given. Our simulations corroborate with findings available in the literature for line-of-sight (LOS) to a certain extent, but they indicate that more work is required for NLOS environments. Moreover, they show that the heuristic approach works well, matching or even improving the performance of the best fixed choice in all considered scenarios.

scholarly journals Non-Line-of-Sight Imaging with Picosecond Temporal Resolution

2021 ◽  
Vol 127 (5) ◽  
Author(s):  
Bin Wang ◽  
Ming-Yang Zheng ◽  
Jin-Jian Han ◽  
Xin Huang ◽  
Xiu-Ping Xie ◽  
...  
Keyword(s):  
Temporal Resolution ◽  
Line Of Sight ◽  
Non Line Of Sight

scholarly journals Thermal non-line-of-sight imaging from specular and diffuse reflections

2019 ◽  
Vol 11 (1) ◽  
Author(s):  
Masaki Kaga ◽  
Takahiro Kushida ◽  
Tsuyoshi Takatani ◽  
Kenichiro Tanaka ◽  
Takuya Funatomi ◽  
...  
Keyword(s):  
Angular Distribution ◽  
Heat Source ◽  
Real World ◽  
Diffuse Reflection ◽  
Far Infrared ◽  
Infrared Light ◽  
Line Of Sight ◽  
Thermal Camera ◽  
Reflection Component ◽  
Non Line Of Sight

Abstract This paper presents a non-line-of-sight technique to estimate the position and temperature of an occluded object from a camera via reflection on a wall. Because objects with heat emit far infrared light with respect to their temperature, positions and temperatures are estimated from reflections on a wall. A key idea is that light paths from a hidden object to the camera depend on the position of the hidden object. The position of the object is recovered from the angular distribution of specular and diffuse reflection component, and the temperature of the heat source is recovered from the estimated position and the intensity of reflection. The effectiveness of our method is evaluated by conducting real-world experiments, showing that the position and the temperature of the hidden object can be recovered from the reflection destination of the wall by using a conventional thermal camera.

Sign in / Sign up

Export Citation Format

Share Document