Study on propagation characteristics of high frequency signal in 10 kV single core crosslinking polyethylene power cable

2017 ◽  
Author(s):  
Liang Jianfeng ◽  
Li Binglin ◽  
Duan Jiandong ◽  
Xue Bing
Keyword(s):  
High Frequency ◽  
Power Cable ◽  
Propagation Characteristics ◽  
Frequency Signal ◽  
High Frequency Signal

Dither in a rolling airframe flight vehicle with a two-position actuator: An amplitude distribution approach

2016 ◽  
Vol 39 (8) ◽  
pp. 1205-1215 ◽  
Author(s):  
Bahram Mohammadi ◽  
Mohammad Reza Arvan ◽  
Yousof Koohmaskan
Keyword(s):  
High Frequency ◽  
Degrees Of Freedom ◽  
Coupling Effect ◽  
Cross Coupling ◽  
Amplitude Distribution ◽  
Feedback System ◽  
Flight Vehicle ◽  
Frequency Signal ◽  
High Frequency Signal ◽  
Minimal Error

Rolling airframe manoeuvring is a type of manoeuvre in which the missile provides continuous roll during flight. Cross-coupling between the angle of attack and sideslip in rolling airframe missiles (RAMs) yields a coning motion around the flight path. As the pitch and yaw cross-coupling effect decreases, the radius of this coning motion decreases and the accuracy of the control system increases. Two-position (on–off) actuators are used in most RAMs. The presence of a two-position actuator in a feedback system makes its characteristics non-linear. A high-frequency signal so-called dither is applied to compensate for the non-linearity effect of the actuator characteristic in the feedback system and to stabilize the coning motion. The amplitude distribution function (ADF) method in dither analysis shows that the smoothed non-linearity characteristic can be computed as the convolution of the original non-linearity and the ADF of the dither signal. According to the four-degrees-of-freedom (4-DOF) equations of RAMs in a non-rolling frame and regarding various dither signals through the ADF approach on a two-position actuator, an analytical condition for dither amplitude in coning motion stability of RAMs is derived. It was shown that the triangular signal with specified amplitude and high enough frequency led to a smoother response of two-position actuators. Finally, by applying beam-riding guidance to a RAM, the performance of dithers for decreasing the distance of the missile from the centre of the beam is validated through simulations. It is illustrated that applying the triangular dither resulted in minimal error.

Sign in / Sign up

Export Citation Format

Share Document