Modeling, analysis and parameters design of rotor current control in DFIG-based wind turbines for dynamic performance optimizing

2017 ◽  
Author(s):  
Yuanzhu Chang ◽  
Jiabing Hu
Keyword(s):  
Wind Turbines ◽  
Dynamic Performance ◽  
Current Control ◽  
Modeling Analysis ◽  
Performance Optimizing

Inductor Saturation Compensation in Three-Phase Three-Wire Voltage-Source Converters via Inverse System Dynamics-I

2020 ◽  
Author(s):  
Ziya Özkan ◽  
Ahmet Masum Hava
Keyword(s):  
Dynamic Model ◽  
Dynamic Performance ◽  
Current Control ◽  
Inverse System ◽  
Voltage Source ◽  
Voltage Source Converter ◽  
Two Phase ◽  
Inverse Dynamic ◽  
Three Phase ◽  
Steady State Current

In three-phase three-wire (3P3W) voltage-source converter (VSC) systems, utilization of filter inductors with deep saturation characteristics is often advantageous due to the improved size, cost, and efficiency. However, with the use of conventional synchronous frame current control (CSCC) methods, the inductor saturation results in significant dynamic performance loss and poor steady-state current waveform quality. This paper proposes an inverse dynamic model based compensation (IDMBC) method to overcome these performance issues. Accordingly, a review of inductor saturation and core materials is performed, and the motivation on the use of saturable inductors is clarified. Then, two-phase exact modelling of the 3P3W VSC control system is obtained and the drawbacks of CSCC have been demonstrated analytically. Based on the exact modelling, the inverse system dynamic model of the nonlinear system is obtained and employed such that the nonlinear plant is converted to a fictitious linear inductor system for linear current regulators to perform satisfactorily.

Gain-phase margins-based delay-dependent stability analysis of pitch control system of large wind turbines

2019 ◽  
Vol 41 (13) ◽  
pp. 3626-3636 ◽  
Author(s):  
Omer Turksoy ◽  
Saffet Ayasun ◽  
Yakup Hames ◽  
Sahin Sonmez
Keyword(s):  
Control System ◽  
Stability Analysis ◽  
Wind Turbines ◽  
Time Domain ◽  
Dynamic Performance ◽  
Pitch Control ◽  
Wide Range ◽  
Delay Dependent ◽  
Delay Dependent Stability ◽  
Large Wind

This paper investigates the effect of gain and phase margins (GPMs) on the delay-dependent stability analysis of the pitch control system (PCS) of large wind turbines (LWTs) with time delays. A frequency-domain based exact method that takes into account both GPMs is utilized to determine stability delay margins in terms of system and controller parameters. A gain-phase margin tester (GPMT) is introduced to the PCS to take into GPMs in delay margin computation. For a wide range of proportional–integral controller gains, time delay values at which the PCS is both stable and have desired stability margin measured by GPMs are computed. The accuracy of stability delay margins is verified by an independent algorithm, Quasi-Polynomial Mapping Based Rootfinder (QPmR) and time-domain simulations. The time-domain simulation studies also indicate that delay margins must be determined considering GPMs to have a better dynamic performance in term of fast damping of oscillations, less overshoot and settling time.

scholarly journals Foundations, Design, and Dynamic Performance of Wind Turbines: Overview and Challenges in Sudan

2021 ◽  
Vol 9 (1) ◽  
pp. 96-103
Author(s):  
Ruba Asim Hamza ◽  
Amged Osman Abdelatif
Keyword(s):  
Dynamic Response ◽  
Wind Turbine ◽  
Wind Turbines ◽  
Structural Damage ◽  
Renewable Energy Sources ◽  
Dynamic Performance ◽  
Scaled Model ◽  
Static Loads ◽  
Design Loads ◽  
Foundation Type

Sudan is one of the developing countries that suffers from a lack of electricity, where the national electrification rate is estimated at 38.5%. In order to solve this problem, it is possible to use renewable energy sources such as wind energy. Beside many aspects to be considered at the design of wind turbine foundations, more attention should be given to the geotechnical part. There are many types of foundations for wind turbines. The foundation must satisfy two design criteria: 1) It should be safe against bearing failure in soils under design loads and settlements during the life of the structure must not cause structural damage; 2) In addition to static loads, wind turbine foundations loads are extremely eccentrically and the loading is usually highly dynamic. Therefore, the selection of foundation type should consider these two criteria taking into account the nature and magnitude of these loads. This paper presents a review of different types of wind turbine foundations of focusing on on-shore wind turbine foundation types and the dynamic response of wind turbine. The paper also demonstrate experimentally the dynamic response of the wind turbines using wind tunnel facility test on a scaled model.  

Using Hierarchical Linear Modeling to Examine Dynamic Performance Criteria Over Time

1997 ◽  
Vol 23 (6) ◽  
pp. 745-757 ◽  
Author(s):  
Diana L. Deadrick ◽  
Nathan Bennett ◽  
Craig J. Russell
Keyword(s):  
Hierarchical Linear Modeling ◽  
Dynamic Performance ◽  
Individual Performance ◽  
Performance Criteria ◽  
Practical Significance ◽  
Linear Modeling ◽  
Modeling Analysis ◽  
And Performance ◽  
Over Time ◽  
Dynamic Criteria

The selection literature has long debated the theoretical and practical significance of dynamic criteria. Recent research has begun to explore the nature of individual performance over time. This study contributes to this body of research through a hierarchical linear modeling analysis of dynamic criteria. The purpose of this study was to investigate the role of ability in explaining initial job performance, as well as the rate of improvement-or performance trend-among a sample of 408 sewing machine operators over a 24 week period. The results of a hierarchical linear modeling analysis suggest that ability measures are differentially related to initial performance and performance improvement trend.

scholarly journals Separated Phase–Current Controls Using Inverter-Based DGs to Mitigate Effects of Fault Current Contribution from Synchronous DGs on Recloser–Fuse

2019 ◽  
Vol 9 (20) ◽  
pp. 4311 ◽  
Author(s):  
Boonyapakdee ◽  
Konghirun ◽  
Sangswang
Keyword(s):  
Dynamic Performance ◽  
Voltage Regulation ◽  
Current Control ◽  
Current Phase ◽  
Fault Current ◽  
Grid Voltage ◽  
Phase Current ◽  
Distributed Generators ◽  
Current Contribution ◽  
Measurement Units

Synchronous distributed generators (SDGs) significantly affect recloser–fuse coordination due to the high fault current contribution. This paper proposes a separated phase–current control using inverter-based distributed generators (IBDGs) to remove the effects of fault current contributions from SDGs during unsymmetrical faults. The three-phase current produced by IBDGs is independently controlled. While the total fault current is reduced by adjusting the current phase angle in the faulty phase, the energy in the DC-link capacitor (Cdc) is delivered to the grid in order to avoid the rise of DC-link voltage (Vdc) by means of injection of the active current into the nonfaulty phase. To maintain the proper grid voltage, the voltage regulation feature is installed in the IBDGs. Moreover, current estimations programmed within the IBDGs are introduced to avoid the performance degradation of separated phase–current controls caused by phasor measurement units (PMUs). The dynamic performance of the separated phase–current controls using IBDGs was evaluated using an IEEE 34-node radial test feeder. According to the simulation results, the IBDGs could eliminate the effects of fault current contributions from the SDG without interruption since the disconnections caused by excessive Vdc were prevented. They could also regulate the grid voltage in the nonfaulty phase.

Unbalanced Control Strategy for DFIG Used in Wind Turbines

2013 ◽  
Vol 805-806 ◽  
pp. 430-435
Author(s):  
Chang Xi Huang ◽  
Shu Ying Yang ◽  
Liu Wei Chen
Keyword(s):  
Wind Turbine ◽  
Wind Turbines ◽  
Power Grid ◽  
Current Control ◽  
Doubly Fed Induction Generator ◽  
Test Bed ◽  
Negative Sequence ◽  
Synchronous Reference Frame ◽  
Sequence Components ◽  
Doubly Fed

Unbalanced input voltages would make doubly fed induction generator (DFIG)-based wind turbine operating performance deteriorate, such as shaft tremble, temperature increasing, and so on, even make it cut out of the power grid. Meanwhile, without proper control the power ripples generated from wind turbines may further aggravate power grid. Considering the unbalanced conditions, DFIG was modeled in dual synchronous reference frame (SRF), namely the positive one and the negative one, based on which the dual PI current controllers were designed. To implement the dual current control, the sensing variables were divided into positive and negative sequence components, which were controlled in positive and negative SRF respectively. At the same time, to synchronize with the positive and negative sequence voltage components, a phase latch loop (PLL) control was designed. Experimental results on 11kW DFIG wind turbine test bed validated the designed control system.

Development of Predictive Current Controller for Multi-Port DC/DC Converter

2015 ◽  
Vol 6 (4) ◽  
pp. 683 ◽  
Author(s):  
Santhosh T K ◽  
Govindaraju C
Keyword(s):  
Hybrid Electric Vehicle ◽  
Dynamic Performance ◽  
Mode Selection ◽  
Current Control ◽  
Power Electronic ◽  
Control Laws ◽  
Operating Modes ◽  
Dc Power ◽  
Current Controller ◽  
Power Electronic Converter

This paper investigates the utilization of a predictive current control for a fourport DC/DC power electronic converter with an input port, two storage portsand a load port suitable for a Hybrid Electric Vehicle. Being a power converterwith multiple ports, it has different operating modes. While the Stateflow con-troller is employed to handle mode selection, the predictive current controller isemployed for the inductor current control. The control laws governing each op-erating mode is derived out for valley current control. By making the inductorcurrent in the upcoming switching cycle equivalent to the reference, the duty cycleis predicted. Simulation and experimental results show improvements in currentripple minimization, faster dynamic performance and comparable to traditionalcontrol method.

scholarly journals A modeling analysis of grounding resistance and sea surface potential on the jacket foundation offshore wind turbines

2018 ◽  
Vol 72 ◽  
pp. 01004
Author(s):  
Shiqi Tao ◽  
Xiaoqing Zhang ◽  
Yaowu Wang
Keyword(s):  
Surface Potential ◽  
Wind Turbines ◽  
Three Dimensional ◽  
Influential Factors ◽  
Sea Surface ◽  
Offshore Wind ◽  
Grounding System ◽  
Grounding Resistance ◽  
Offshore Wind Turbines ◽  
Modeling Analysis

Offshore wind turbines (WTs) are frequently exposed to the risk from lightning, storm, and waves. As a kind of fixed foundations, jacket foundation can effectively reduce the correlatively risk and loss. In order to provide more information about the lightning protection of jacket foundation, a simulation model has been built by simplifying the hollow steel tubes into a series of solid steel cylinders. And some conclusions on the grounding resistance of jacket foundation have been summarized in this paper by using the GSSAS (Grounding System Safe Analysis Software). According to the simulation results, the actual influential factors of grounding resistance, including the depth of seawater, the thickness of clay layer and the resistivity of gravel layer, have been analysed and compared. It is found that the grounding resistance is influenced most severely by the depth of seawater. In addition, the values of sea surface potential have been calculated by the software GSSAS and the three-dimensional diagrams of potential distribution have been mapped out.

Sign in / Sign up

Export Citation Format

Share Document