Development of 900MHz band one-sided directional antenna on flexible substrate

Author(s):  
T. Hirabaru ◽  
H. Kanaya ◽  
D. Kanemoto ◽  
K. Yoshida ◽  
R. K. Pokharel ◽  
...  
2010 ◽  
Vol E93-B (10) ◽  
pp. 2570-2577 ◽  
Author(s):  
Daisuke UCHIDA ◽  
Hiroyuki ARAI ◽  
Yuki INOUE ◽  
Keizo CHO

Author(s):  
Rinkle Chhabra ◽  
Anuradha Saini

Mobile Ad Hoc Networks (MANET) are autonomous, infrastructure less and self-configuring networks. MANETs has gained lots of popularity due to on the fly deployment i.e. small network setup time and ability to provide communication in obstreperous terrains. Major challenges in MANETs include routing, energy efficiency, network topology control, security etc. Primary focus in this article is to provide method and algorithm to ensure significant energy savings using re-configurable directional antennas. Significant energy gains can be clinched using directional antenna. Key challenges while using directional antenna are to find destination location, antenna focusing, signal power and distance calculations. Re-configurable directional antenna can ensure significant energy gains if used intelligently. This article provides a brief insight into improved energy savings using re-configurable directional antennas and an associated algorithm


PIERS Online ◽  
2010 ◽  
Vol 6 (2) ◽  
pp. 105-108 ◽  
Author(s):  
Haipeng Lu ◽  
Jing Yang ◽  
Longjiang Deng

Author(s):  
Byoung-Joon Kim ◽  
Hae-A-Seul Shin ◽  
In-Suk Choi ◽  
Young-Chang Joo

Abstract The electrical resistance Cu film on flexible substrate was investigated in cyclic bending deformation. The electrical resistance of 1 µm thick Cu film on flexible substrate increased up to 120 % after 500,000 cycles in 1.1 % tensile bending strain. Crack and extrusion were observed due to the fatigue damage of metal film. Low bending strain did not cause any damage on metal film but higher bending strain resulted in severe electrical and mechanical damage. Thinner film showed higher fatigue resistance because of the better mechanical property of thin film. Cu film with NiCr under-layer showed poorer fatigue resistance in tensile bending mode. Ni capping layer did not improve the fatigue resistance of Cu film, but Al capping layer suppressed crack formation and lowered electrical resistance change. The NiCr under layer, Ni capping layer, and Al capping layer effect on electrical resistance change of Cu film was compared with Cu only sample.


2017 ◽  
Vol 9 (5) ◽  
pp. 05035-1-05035-6 ◽  
Author(s):  
G. I. Kopach ◽  
◽  
R. P. Mygushchenko ◽  
G. S. Khrypunov ◽  
A. I. Dobrozhan ◽  
...  

2020 ◽  
Vol 315 ◽  
pp. 112341
Author(s):  
Zhaojun Liu ◽  
Bian Tian ◽  
Xu Fan ◽  
Jiangjiang Liu ◽  
Zhongkai Zhang ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document