Harmonic Source Location at the Point of Common Coupling Based on the Nonlinearity Index of Load

2009 ◽  
Author(s):  
Yamei Liu ◽  
Hualin Gong ◽  
Xian-Yong Xiao ◽  
Honggeng Yang
Keyword(s):  
Source Location ◽  
Point Of Common Coupling ◽  
Harmonic Source ◽  
Common Coupling

scholarly journals A Diagnostic Analytics of Harmonic Source Signature Recognition by Using Periodogram

2018 ◽  
Vol 8 (6) ◽  
pp. 5399
Author(s):  
M. H. Jopri ◽  
A. R. Abdullah ◽  
T. Sutikno ◽  
M. Manap ◽  
M. R. Ab Ghani ◽  
...  
Keyword(s):  
Distribution System ◽  
Single Point ◽  
Signature Analysis ◽  
Recognition Pattern ◽  
Point Of Common Coupling ◽  
Signature Recognition ◽  
Harmonic Source ◽  
Common Coupling ◽  
Harmonic Components ◽  
Current Signature

<span lang="EN-GB">This paper presents a diagnostic analytics of harmonic source signature recognition of rectifier and inverter-based load in the distribution system with single-point measurement at the point of common coupling by utilizing Periodogram. Signature recognition pattern is used to distinguish the harmonic sources accurately by obtaining the distribution of harmonic and interharmonic components and the harmonic contribution changes.  This is achieved by using the significant signature recognition of harmonic producing load obtained from analysing the harmonic contribution changes. </span><span>Based on voltage and current signature analysis, the distribution of harmonic components can be divided into three zones. To distinguish between the harmonic producing loads, the harmonic components are observed at these zones to get the signature recognition pattern.</span><span lang="EN-GB"> The result demonstrate that periodogram technique accurately diagnose and distinguish the type of harmonic sources in the distribution system.</span>

scholarly journals Method of Harmonic Source Identification Based on Harmonic Apparent Power

2018 ◽  
Vol 38 ◽  
pp. 01001 ◽  
Author(s):  
Lin Xu ◽  
Rui Xing Lin ◽  
Shuang Ting Xu
Keyword(s):  
Source Identification ◽  
New Method ◽  
Impedance Method ◽  
Independent Action ◽  
Harmonic Current ◽  
Point Of Common Coupling ◽  
Harmonic Voltage ◽  
Harmonic Source ◽  
Common Coupling ◽  
Power Standard

Based on the harmonic apparent power defined by the IEEE 1459-2010 power standard, the paper proposed a new method of identifying the main harmonic source at the point of common coupling (PCC). Using the reference impedance method, the utility and customer harmonic voltage and current contributions are calculated. And then combined with the IEEE 1459-2010 standard, defined the harmonic apparent power caused by the independent action of the equivalent harmonic source on the system side and the user side, by directly comparing the size of the two to determine the location of the main harmonic source. The method can consider the comprehensive influence of harmonic voltage and harmonic current, then identify the main harmonic source at PCC point. Finally, the rationality of the method is verified by the simulation of the IEEE 13 node system.

scholarly journals A Proposed Harmonic Monitoring System for Large Power Users Considering Harmonic Limits

Energies ◽  
2020 ◽  
Vol 13 (17) ◽  
pp. 4507
Author(s):  
Rosalia Sinvula ◽  
Khaled Mohamed Abo-Al-Ez ◽  
Mohamed Tariq Kahn
Keyword(s):  
Monitoring System ◽  
Renewable Energy Sources ◽  
Electronic Devices ◽  
Harmonic Distortion ◽  
Large Power ◽  
High Penetration ◽  
Point Of Common Coupling ◽  
Common Coupling ◽  
Power Utilities ◽  
The Individual

Most power utilities within Southern Africa are faced with the challenges of harmonic distortion due to the high penetration of renewable energy sources (RES) and the use of electronic devices. There is an excessive total harmonic distortion (THD) measured at the point of common coupling (PCC). In this paper, a proposed harmonic monitoring system for large power users (LPUs) is developed. This proposed system considers harmonic limits of the individual and THD of the customers allowed injecting into the network, which should be part of the contractual electricity supply agreement (ESA). Hence, it will enable the monitoring of harmonic distortion to be smooth by determining whether the customer has passed or failed compliance for individual harmonic order and the THD of the voltage. The measurements of harmonic distortion are done using the Unipower power quality (PQ) analyzers that are connected at different points within the industrial network. Measurements of harmonic distortion of an industrial site are compared to the simulation results performed by DIgSILENT software to validate the proposed harmonic monitoring system. Based on the validation results, it is recommended that the ESA between the power utilities and the customers should consist of the harmonic limits.

Assessment of power quality parameters and indicators at the point of common coupling in a low voltage power grid with photovoltaic generation emulated

2022 ◽  
Vol 203 ◽  
pp. 107679
Author(s):  
Oscar Pinzón-Quintero ◽  
Daniel Gaviria-Ospina ◽  
Alejandro Parrado-Duque ◽  
Rusber Rodríguez-Velásquez ◽  
German Osma-Pinto
Keyword(s):  
Power Quality ◽  
Low Voltage ◽  
Power Grid ◽  
Quality Parameters ◽  
Photovoltaic Generation ◽  
Point Of Common Coupling ◽  
Common Coupling

Power Quality Assessment and Enhancement in a Grid Connected Renewable Energy System Using Dynamic Voltage Restorer

2014 ◽  
Vol 573 ◽  
pp. 716-721
Author(s):  
S. Rajeshbabu ◽  
B.V. Manikandan
Keyword(s):  
Neural Network ◽  
Renewable Energy ◽  
Power Quality ◽  
Energy System ◽  
Dynamic Voltage Restorer ◽  
Renewable Energy System ◽  
Voltage Restorer ◽  
Point Of Common Coupling ◽  
Dynamic Voltage ◽  
Common Coupling

Renewable energy sources provide the additional/satisfy the power to the consumer through power electronics interfaces and integrated with the grid. In grid integration power quality is one of the important parameter that need to be paying more attention. This proposed work focuses on power quality issues in a grid connected renewable energy system. Power quality issues will arises due to many factors here with the by introducing a fault condition in a grid connected renewable energy system the measurements were made at the point of common coupling and the mitigation is done with the help of a dynamic voltage restorer. The dynamic voltage restorer is a device which offers series compensation activated by neural network based controller. The sag improvement and the total harmonic assessment were made at the point of common coupling. Keywords: Neural network, Point of common coupling, Renewable energy source, Power quality, Dynamic voltage restorer ,electric grid.

Sign in / Sign up

Export Citation Format

Share Document