Low cost printed circularly polarized wire antenna

2012 ◽  
Author(s):  
Ka-ming Mak ◽  
Hau-wah Lai ◽  
Kwai-man Luk
Keyword(s):  
Low Cost ◽  
Wire Antenna ◽  
Circularly Polarized

Bilayer split-ring chiral metamaterial based reconfigurable antenna for polarization conversion

Frequenz ◽  
2021 ◽  
Vol 0 (0) ◽  
Author(s):  
Preet Kaur ◽  
Pravin R. Prajapati
Keyword(s):  
Low Cost ◽  
Axial Ratio ◽  
Center Frequency ◽  
Impedance Bandwidth ◽  
Split Ring ◽  
Circularly Polarized ◽  
Left Hand ◽  
Rectangular Patch ◽  
Mode 2 ◽  
Chiral Metamaterial

Abstract A bilayer split-ring chiral metamaterial converts the linearly polarized wave, into a nearly perfect left or right-handed circularly polarized wave. The proposed antenna is intended to operate at center frequency of 5.80 GHz with switchable polarization capability. The polarization re-configurability is achieved by electronically switching of two PIN-diode pairs, which are embedded into bilayer split-ring Chiral Metamaterial. The optimized length of rectangular patch is 16 mm and width is 12.1 mm. Two types of radiation characteristics offered by the proposed antenna; left hand circularly polarized in mode 1 and right hand circularly polarized in mode 2. Measured results show that its impedance bandwidth is 155 MHz from 5.70 to 5.855 GHz for both mode 1 and mode 2. The measured axial-ratio bandwidth is 100 MHz from 5.75 to 5.85 GHz for mode 1 and 110 MHz from 5.73 to 5.84 GHz for mode 2. Antenna has LHCP gain of 2.52 dBi and RHCP gain of −23 dBi in mode 1. RHCP gain of 2 dBi and polarization purity of about −20 dBi is obtained in mode 2. The proposed antenna has simple structure, low cost and it has potential application in field of wireless communication (i.e., WiMax, WLAN etc.).

scholarly journals Low Cost Circularly Polarized Antenna for IoT Space Applications

Electronics ◽  
2020 ◽  
Vol 9 (10) ◽  
pp. 1564
Author(s):  
Le Huy Trinh ◽  
Nguyen Vu Truong ◽  
Fabien Ferrero
Keyword(s):  
Circular Polarization ◽  
Radiation Pattern ◽  
Insertion Loss ◽  
Low Cost ◽  
Total Efficiency ◽  
Area Network ◽  
Wide Area Network ◽  
Space Applications ◽  
Circularly Polarized ◽  
Compact Size

This work presents the use of a three-element radiating structure for circularly polarized Low-Power Wide Area Network (LP-WAN) communication with space. The proposed structure has a 72 mm × 72 mm × 12 mm compact size with Right-Handed Circular Polarization (RHCP) and a 120∘ wide beamwidth radiation pattern. Printed on low-cost FR4 Epoxy substrate, a feeding network circuit based on Quasi Lumped Quadrature Coupler (QLQC), it achieves a −0.6 dB insertion loss and a very compact size. The final structure has a 69% total efficiency and a 3.14 dBic realized gain.

scholarly journals A Millimeter-Wave Wideband Circularly Polarized Planar Spiral Antenna Array with Unequal Amplitude Feeding Network

2021 ◽  
Vol 2021 ◽  
pp. 1-10
Author(s):  
Huakang Chen ◽  
Yu Shao ◽  
Zhangjian He ◽  
Changhong Zhang ◽  
Zhizhong Zhang
Keyword(s):  
Antenna Array ◽  
Millimeter Wave ◽  
Printed Circuit Board ◽  
Low Cost ◽  
Axial Ratio ◽  
Circuit Board ◽  
Impedance Bandwidth ◽  
Side Lobe Level ◽  
Archimedean Spiral ◽  
Circularly Polarized

A 2 × 2 wideband circularly polarized (CP) antenna array operating at millimeter wave (mmWave) band is presented. The array element is a wideband CP Archimedean spiral radiator with special-shaped ring slot. The elements are fed by an unequal amplitude (UA) feeding network based on a microstrip line (MSL) power divider. The side lobe level is improved by this UA feeding network. In addition, a cross slot is employed to isolate the elements for decoupling. A prototype is fabricated, and the measured results show that the proposed array achieves an impedance bandwidth (IBW) of 6.31 GHz (22.5% referring to 28 GHz) and an axial ratio bandwidth (ARBW) of 7.32 GHz (26.1% referring to 28 GHz). The peak gain of the proposed array is 11.3 dBic, and the gain is greater than 9.3 dBic within the whole desired band (from 25 GHz to 31 GHz). The proposed array consists of only one substrate layer and can be built by the conventional printed circuit board technology. Attributed to the characteristics of wide bandwidth, simple structure, low profile, and low cost, the proposed antenna array has a great potential in mmWave wireless communications.

scholarly journals ESTIMATION OF DATA MEMORY CAPACITY FOR CIRCULARLY POLARIZED SYNTHETIC APERTURE RADAR ONBOARD UNMANNED AERIAL VEHICLE PLATFORM (CP-SAR UAV)

2011 ◽  
Vol 7 (1) ◽  
Author(s):  
P. Rizki Akbar ◽  
J.T. Sri Sumantyo ◽  
V.C.Koo ◽  
H.Kuzel
Keyword(s):  
Synthetic Aperture Radar ◽  
Unmanned Aerial Vehicle ◽  
Early Stage ◽  
Low Cost ◽  
Image Data ◽  
Memory Capacity ◽  
Synthetic Aperture ◽  
Circularly Polarized ◽  
Aerial Vehicle ◽  
Aperture Radar

Previously only linear polarization is widely used in the Synthetic Aperture Radar(SAR) system onboard spaceborne and airborne platforms. In such linearly polarized SAR(LP-SAR) systems, Faraday rotation in the ionosphere and platform posture will contribute tothe system noise. Therefore to improve this situation, currently a novel Circularly PolarizedSynthetic Aperture Radar (CP-SAR) sensor is developed in Microwave Remote SensingLaboratory, Chiba University. Moreover, from this research, a new backscattering data basedon circularly polarized wave in the remote sensing field can be obtained. As an early stage ofthe development of this CP-SAR sensor, we built an Unmanned Aerial Vehicle (UAV)platform for testing CP-SAR sensor capabilities. In this paper, we describe the novel CP-SARsensor and the method to design CP-SAR UAV especially in estimating the requirement ofdata memory capacity. Also a smaller antenna is possible to be implemented since the 3-dBaxial ratio on antenna characteristic becomes the main parameter in this new CP-SARtechnique. Hence, a compact CP-SAR sensor onboard a small and low cost spaceborneplatform yielding a high accuracy SAR image data can be realized in the near future.

A compact wideband circularly polarized quadrifilar antenna with PIFA elements for UHF RFID readers

2020 ◽  
Vol 12 (10) ◽  
pp. 1020-1028
Author(s):  
Chawanat Lerkbangplad ◽  
Alongkorn Namahoot ◽  
Prayoot Akkaraekthalin ◽  
Suramate Chalermwisutkul
Keyword(s):  
Frequency Band ◽  
Radio Frequency Identification ◽  
Low Cost ◽  
Impedance Matching ◽  
Axial Ratio ◽  
Uhf Rfid ◽  
Total Size ◽  
Circularly Polarized ◽  
Directional Radiation ◽  
Feed Network

AbstractIn this paper, a compact circularly polarized quadrifilar antenna with planar inverted-F antenna (PIFA) elements is presented. The proposed antenna consists of four PIFA elements and a Wilkinson divider-based feed network fabricated on FR-4 substrate (ɛr = 4.4, loss tangent = 0.02, thickness = 1.6 mm). The total size of the antenna is 120 × 120 × 13.2 mm3. Impedance matching with a reflection coefficient <−15 dB and an axial ratio (AR) <3 dB are achieved over the global ultra-high frequency (UHF) radio frequency identification (RFID) frequency band and beyond. The realized gain ranges from 2.25 to 3.75 dBic within the frequency band of interest from 860 to 960 MHz with a directional radiation pattern. The proposed antenna is compact, low-cost and extremely wideband in terms of matching and AR compared to state-of-the-art UHF RFID reader antennas.

Sign in / Sign up

Export Citation Format

Share Document