A high step-up current fed multi-resonant converter with output voltage doubler

2011 ◽  
Author(s):  
Donghao Li ◽  
Bo Liu ◽  
Bo Yuan ◽  
Xu Yang ◽  
Jason Duan ◽  
...  
Keyword(s):  
Output Voltage ◽  
Resonant Converter ◽  
Voltage Doubler

scholarly journals Resonant Converter with Voltage-Doubler Rectifier or Full-Bridge Rectifier for Wide-Output Voltage and High-Power Applications

Electronics ◽  
2018 ◽  
Vol 8 (1) ◽  
pp. 3 ◽  
Author(s):  
Bor-Ren Lin ◽  
Guan-Hong Lin ◽  
Aries Jian
Keyword(s):  
Output Voltage ◽  
Low Voltage ◽  
Resonant Circuit ◽  
Resonant Converter ◽  
Power Devices ◽  
Voltage Output ◽  
Power Switches ◽  
Bridge Rectifier ◽  
Voltage Doubler ◽  
Secondary Side

This paper presents a resonant converter with the benefits of wide output voltage, wide soft switching characteristics for power devices and high circuit efficiency. Since the series resonant circuit is adopted on the primary side, the power switches are turned on under zero voltage switching and power diodes on the secondary side can be turned off under zero current switching. To overcome the drawback of narrow voltage operation range in the conventional resonant converter, full-bridge rectifier and voltage-doubler rectifier topologies are employed on the secondary side for low-voltage output and high-voltage output applications. Therefore, the voltage rating of power devices on the secondary side is clamped at output voltage, rather than two times output voltage, in the center-tapped rectifier circuit. Synchronous power switches are used on the secondary side to further reduce the conduction losses so that the circuit efficiency can be further improved. To verify the theoretical analysis and circuit performance, a laboratory prototype with 1 kW rated power was built and tested.

scholarly journals Novel High-Efficiency High Step-Up DC–DC Converter with Soft Switching and Low Component Voltage Stress for Photovoltaic System

Processes ◽  
2021 ◽  
Vol 9 (7) ◽  
pp. 1112
Author(s):  
Yu-En Wu ◽  
Jyun-Wei Wang
Keyword(s):  
High Voltage ◽  
Output Voltage ◽  
High Efficiency ◽  
Low Voltage ◽  
Leakage Inductance ◽  
Power Switch ◽  
Half Wave Voltage ◽  
Half Wave ◽  
Voltage Stress ◽  
Voltage Doubler

This study developed a novel, high-efficiency, high step-up DC–DC converter for photovoltaic (PV) systems. The converter can step-up the low output voltage of PV modules to the voltage level of the inverter and is used to feed into the grid. The converter can achieve a high step-up voltage through its architecture consisting of a three-winding coupled inductor common iron core on the low-voltage side and a half-wave voltage doubler circuit on the high-voltage side. The leakage inductance energy generated by the coupling inductor during the conversion process can be recovered by the capacitor on the low-voltage side to reduce the voltage surge on the power switch, which gives the power switch of the circuit a soft-switching effect. In addition, the half-wave voltage doubler circuit on the high-voltage side can recover the leakage inductance energy of the tertiary side and increase the output voltage. The advantages of the circuit are low loss, high efficiency, high conversion ratio, and low component voltage stress. Finally, a 500-W high step-up converter was experimentally tested to verify the feasibility and practicability of the proposed architecture. The results revealed that the highest efficiency of the circuit is 98%.

scholarly journals Quasi-resonant inverter power pulsed radar system

2015 ◽  
pp. 27-32
Author(s):  
V. N. Dolov ◽  
V. F. Strelkov ◽  
V. V. Vanyaev ◽  
A. A. Kochnev
Keyword(s):  
Output Voltage ◽  
Closed Loop ◽  
Power Transmission ◽  
Voltage Regulation ◽  
Open Loop ◽  
Radar System ◽  
Resonant Converter ◽  
Resonant Inverter ◽  
Pulse Output ◽  
External Characteristics

Presented by quasi-resonant converter of a pulse of microwave power transmission device lamp radar with pulse output voltage regulation. The features of his work are given a mathematical model, the external characteristics and some simulation results in open-loop and closed-loop output voltage system.

Sign in / Sign up

Export Citation Format

Share Document