scholarly journals Licensed Countrywide Full-Spectrum Allocation: A New Paradigm for Millimeter-Wave Mobile Systems in 5G/6G Era

IEEE Access ◽  
2020 ◽  
Vol 8 ◽  
pp. 166612-166629
Author(s):  
Rony Kumer Saha
2021 ◽  
Vol 2021 ◽  
pp. 1-21
Author(s):  
Rony Kumer Saha

In this paper, by exploiting the frequency-domain, we propose a countrywide millimeter-wave (mmWave) spectrum allocation and reuse technique to allocate and reuse spatially the countrywide 28 GHz licensed spectrum and 60 GHz unlicensed spectrum to small cells (SCs) on each floor of a building of each Fifth-Generation (5G) New Radio (NR) Mobile Network Operator (MNO) of an arbitrary country. We develop an interference management scheme, model user statistics per SC, and interferer statistics per apartment and formulate the amount of the 28 GHz and 60 GHz spectra per MNO. We derive average capacity, spectral efficiency (SE), energy efficiency (EE), and cost efficiency (CE) when employing the proposed technique, as well as the traditional static licensed spectrum allocation technique. We discuss the implementation of the proposed technique and evaluate the performance under two scenarios, namely, SCs operate only in the 28 GHz in scenario 1, and both 28 GHz and 60 GHz in scenario 2. Extensive results and analyses are carried out for four MNOs, i.e., MNOs 1, 2, 3, and 4, in scenario 1. However, in scenario 2, in addition to MNOs 1, 2, 3, and 4, an incumbent Wireless Gigabit (WiGig) operator is considered. It is shown that the proposed technique with no co-channel interference can improve average capacity, SE, EE, and CE of MNO 1 by 3 times, 1.65 times, 75%, and 60%, respectively, in scenario 1, whereas 6.12 times, 5.104 times, 85.8%, and 83.15%, respectively, in scenario 2. Moreover, with an increase in reuse factors, SE increases linearly and EE increases negative exponentially. Further, we show that the proposed technique can satisfy SE and EE requirements for sixth-generation (6G) mobile systems. Finally, we discuss offered benefits and point out key issues of the proposed technique for further studies.


2012 ◽  
Vol 20 (21) ◽  
pp. 23623 ◽  
Author(s):  
Julien Macario ◽  
Peng Yao ◽  
Shouyuan Shi ◽  
Alicia Zablocki ◽  
Charles Harrity ◽  
...  

Sensors ◽  
2020 ◽  
Vol 20 (14) ◽  
pp. 3979
Author(s):  
Rony Kumer Saha

In this paper, we propose a hybrid interweave–underlay spectrum access and reuse technique for the dynamic spectrum access and reuse of the countrywide 28 GHz millimeter-wave (mmWave) spectrum to in-building small cells of each mobile network operator (MNO) in a country. For the spectrum access, the proposed technique explores both interweave and underlay spectrum access techniques, whereas, for the spectrum reuse, it considers reusing the countrywide spectrum to each three-dimensional (3D) cluster of small cells in a building. To access the countrywide spectrum, each MNO is considered by paying a licensing fee following its number of subscribers. We present the 3D clustering of in-building of small cells and derive average capacity, spectral efficiency (SE), and energy efficiency (EE). We then perform extensive numerical and simulation results and analyses for an MNO of a country consisting of four MNOs. It is shown that, for no spectrum reuse to in-building small cells, the proposed technique improves average capacity and SE by 3.63 and 2.42 times, respectively, whereas EE improves by 72.79%. However, for vertical spatial reuse of six times (as an example) to small cells in a building, average capacity, SE, and EE improve further by 21.77 times, 14.51 times, and 95.66%, respectively. Moreover, the proposed technique can satisfy SE and EE requirements for sixth-generation (6G) mobile systems by horizontal spatial reuse of the countrywide spectrum to small cells of about 40.62%, 9.37%, and 6.25% less buildings than that required by the traditional static licensed spectrum access (SLSA) technique.


2000 ◽  
Vol 6 (S2) ◽  
pp. 1048-1049
Author(s):  
I.M. Anderson

Spectrum imaging, where a full spectrum is acquired at each pixel in a two-dimensional array, provides a new paradigm for materials characterization that combines the advantages of traditional paradigms for imaging and analysis in electron optical characterization. Traditionally, electron optical imaging (e.g., secondary electron imaging of electron-opaque or bright-field imaging of electron-transparent specimens) emphasizes contrast production among distinct features of the microstructure. An excellent survey of the specimen microstructure is achieved - many pixels are acquired - but typically no quantitative analysis of image intensities is performed. In contrast, electron optical analysis techniques traditionally concentrate on quantitative elemental analysis (e.g., electron probe microanalysis), or at least comprehensive qualitative analysis through full spectrum acquisition (e.g., energy-dispersive X-ray or electron energy-loss spectrometry). However, these analyses are typically performed at only a few locations on the specimen, which are pre-selected on the basis of the image contrast generated as described above.


Sign in / Sign up

Export Citation Format

Share Document