scholarly journals The Environment-Power System Analysis Tool development program

1989 ◽  
Vol 4 (11) ◽  
pp. 40-43
Author(s):  
G.A. Jongeward ◽  
R.A. Kuharski ◽  
E.M. Kennedy ◽  
K.G. Wilcox ◽  
N.J. Stevens ◽  
...  
Keyword(s):  
Power System ◽  
System Analysis ◽  
Development Program ◽  
Analysis Tool ◽  
Tool Development ◽  
Power System Analysis

scholarly journals The Environment-Power System Analysis Tool development program

2003 ◽  
Author(s):  
G.A. Jongeward ◽  
R.A. Kuharski ◽  
E.M. Kennedy ◽  
K.G. Wilcox ◽  
N.J. Stevens ◽  
...  
Keyword(s):  
Power System ◽  
System Analysis ◽  
Development Program ◽  
Analysis Tool ◽  
Tool Development ◽  
Power System Analysis

scholarly journals A Novel Hybrid Particle Swarm- Multiverse Optimization based Voltage Stability Improvement in IEEE 57 Bus System

2018 ◽  
Vol 7 (2.24) ◽  
pp. 381
Author(s):  
P K.Dhal ◽  
K Ramash Kumar
Keyword(s):  
Power System ◽  
Hybrid Algorithm ◽  
Voltage Stability ◽  
System Analysis ◽  
Test System ◽  
Analysis Tool ◽  
Power System Analysis ◽  
Sudden Loading ◽  
And Control ◽  
Bus System

The major role of power system is voltage stability. It is required to plan properly and smooth operation and control. It presents a new approach of voltage stability improvement in IEEE 57 bus system using hybrid algorithm. The hybrid algorithm (PSO-MVO) is combination of PSO which is used for exploitation and MVO used for exploration. It is used in an uncertain environment. The FACTS device as STATCOM is connected in IEEE 57 test system to check for event of voltage stability improvement through power system analysis tool (PSAT) software. Once the ability of system goes through sudden loading, its stability gets affected. It desires compensation to boost voltage from disturbances. The varied operative condition while not used STATCOM in the system, used with STATCOM tuned by PSO-MVO algorithm are measured judge the performance of the projected system. The hybrid PSO-MVO technique is implemented in this paper to solve the proposed problem. The simulation results are obtained by PSAT software for 57 IEEE bus systems. The hybrid algorithm validates its effectiveness compare to individual PSO and MVO algorithm.     

Common Models Comparison and Conversion between PSASP and PSS/E

2015 ◽  
Vol 740 ◽  
pp. 411-414
Author(s):  
Ting Zhao ◽  
Fei Tang ◽  
Junru Xu ◽  
Jian Yang ◽  
Qian Zhang
Keyword(s):  
Power System ◽  
Transient Stability ◽  
System Analysis ◽  
Data Conversion ◽  
Model Parameters ◽  
Analysis Tool ◽  
Analysis Software ◽  
Power System Analysis ◽  
Software Packages ◽  
Models Comparison

As for transient stability simulation, Chinese researchers often use PSASP (Power System Analysis Software Package) as an auxiliary analysis tool while PSS/E (Power System Simulator for Engineering) is commonly used overseas. The correspondence of models contained in these two software packages will be discussed in this paper. Correspondent model parameters can be converted mutually based on the inner link of PSASP and PSS/E. Similar testing results of one standard IEEE case show that this data conversion method is primarily workable.

Development of a Hybrid Simulator for Power System Analysis for a High Penetration of Distributed Generations

2016 ◽  
Vol 136 (1) ◽  
pp. 63-71
Author(s):  
Ryouhei Kitagawa ◽  
Teruo Takagi ◽  
Koichi Yokoi ◽  
Kimihiko Shimomura ◽  
Atsushi Harada ◽  
...  
Keyword(s):  
Power System ◽  
System Analysis ◽  
Distributed Generations ◽  
Power System Analysis ◽  
High Penetration ◽  
Hybrid Simulator

scholarly journals Fast 10-Point DFT Algorithm for Power System Harmonic Analysis

2021 ◽  
Vol 11 (15) ◽  
pp. 7007
Author(s):  
Janusz P. Paplinski ◽  
Aleksandr Cariow
Keyword(s):  
Computational Complexity ◽  
Power System ◽  
Harmonic Analysis ◽  
Efficient Algorithm ◽  
System Analysis ◽  
Spectral Leakage ◽  
Power System Analysis ◽  
Improve Accuracy ◽  
The Cost ◽  
Harmonic Power

This article presents an efficient algorithm for computing a 10-point DFT. The proposed algorithm reduces the number of multiplications at the cost of a slight increase in the number of additions in comparison with the known algorithms. Using a 10-point DFT for harmonic power system analysis can improve accuracy and reduce errors caused by spectral leakage. This paper compares the computational complexity for an L×10M-point DFT with a 2M-point DFT.

Sign in / Sign up

Export Citation Format

Share Document