A real-time calculation method for optimal reactive power compensator

1989 ◽  
Vol 4 (2) ◽  
pp. 643-652 ◽  
Author(s):  
C.E. Lin ◽  
T.-C. Chen ◽  
C.-L. Huang
Keyword(s):  
Real Time ◽  
Calculation Method ◽  
Reactive Power ◽  
Time Calculation ◽  
Reactive Power Compensator

Real-Time Calculation Method for Single-Phase Cascaded H-Bridge Inverters Based on Phase-Shifted Carrier Pulsewidth Modulation

2020 ◽  
Vol 35 (1) ◽  
pp. 977-987 ◽  
Author(s):  
Junpeng Ma ◽  
Xiongfei Wang ◽  
Frede Blaabjerg ◽  
Wensheng Song ◽  
Shunliang Wang ◽  
...  
Keyword(s):  
Real Time ◽  
Calculation Method ◽  
Single Phase ◽  
Pulsewidth Modulation ◽  
Time Calculation

A Method for Controlling a Reactive Power Compensator in the Real-Time Mode at Nonstationary Nonlinear Loads

2021 ◽  
Vol 92 (7) ◽  
pp. 397-400
Author(s):  
I. N. Vorotnikov ◽  
M. A. Mastepanenko ◽  
Sh. Zh. Gabrielyan ◽  
A. A. Shunina
Keyword(s):  
Real Time ◽  
Reactive Power ◽  
Nonlinear Loads ◽  
The Real ◽  
Real Time Mode ◽  
Reactive Power Compensator

Research on Real-Time Calculation Method of Load Response in FPSO Soft Yoke Mooring System Based on Long and Short-Term Memory Network

2020 ◽  
Author(s):  
Yu Sun ◽  
Liping Sun ◽  
Peng Li ◽  
Gang Ma
Keyword(s):  
Real Time ◽  
Calculation Method ◽  
Short Term Memory ◽  
Short Circuit ◽  
Mooring System ◽  
Short Term ◽  
Critical Position ◽  
Term Memory ◽  
Load Response ◽  
Time Calculation

Abstract Due to the complex marine environment factors such as wind and waves, FPSO (Floating Production Storage Offloading) relies on the mooring system for positioning and reducing the serious consequences when excessive hull movement happens. Therefore, the production, storage, and unloading operation of FPSO are directly affected by the safety of the mooring system. At present, installing the fiber grating strain sensor on the mooring system of FPSO is the primary way of system condition monitoring. However, the problems of sensors like dropping, deformation and short circuit reduce the reliability and increase costs in monitoring. In view of the above considerations, this paper proposes a real-time calculation method for motion response of mooring system of FPSO, basing on LSTM (Long and short-term memory) algorithm. In the case where the shipborne GPS (Global Positioning System) provides six degree of freedom, the force at the specific position on SYM (Soft Yoke Mooring) system can be directly calculated. The feasibility of the load response calculation involving the critical position like pendant-hull interface and of YOKE head in FPSO SYM system is proved by comparison with the numerical simulation, providing a new method support for gradually replacing the force sensor based mooring response acquisition method, and an economical and efficient way for the real-time calculation of the key position response in the FPSO mooring system.

Edge sensor based real-time calculation method for active panel position of QTT

2020 ◽  
Vol 20 (11) ◽  
pp. 182
Author(s):  
Cong-Si Wang ◽  
Yue-Fei Yan ◽  
Qian Xu ◽  
Na Wang ◽  
Yuan-Peng Zheng ◽  
...  
Keyword(s):  
Real Time ◽  
Calculation Method ◽  
Time Calculation
Sign in / Sign up

Export Citation Format

Share Document