Amorphous silicon thin-film transistors on compliant polyimide foil substrates

1999 ◽  
Vol 20 (9) ◽  
pp. 473-475 ◽  
Author(s):  
H. Gleskova ◽  
S. Wagner
2002 ◽  
Vol 715 ◽  
Author(s):  
H. Gleskova ◽  
S. Wagner ◽  
W. Soboyejo ◽  
Z. Suo

AbstractWe evaluated a-Si:H TFTs fabricated on polyimide foil under uniaxial compressive or tensile strain. The strain was induced by bending or stretching. All experiments confirmed that the on-current and hence the electron linear mobility depend on strain å as μ = μ0 (1 + 26·ε), where tensile strain has a positive sign. Upon the application of stress the mobility changes instantly and then remains unchanged in measurements up to 40 hours. In the majority of the TFTs the off-current and leakage current do not change. In tension, the TFTs fail mechanically at a strain of ∼ 3x10-2 but recover if the strain is released ‘immediately’.


1997 ◽  
Vol 36 (Part 1, No. 10) ◽  
pp. 6226-6229 ◽  
Author(s):  
Huang-Chung Cheng ◽  
Jun-Wei Tsai ◽  
Chun-Yao Huang ◽  
Fang-Chen Luo ◽  
Hsing-Chien Tuan

1996 ◽  
Vol 424 ◽  
Author(s):  
R. E. I. Schropp ◽  
K. F. Feenstra ◽  
C. H. M. Van Der Werf ◽  
J. Holleman ◽  
H. Meiling

AbstractWe present the first thin film transistors (TFTs) incorporating a low hydrogen content (5 - 9 at.-%) amorphous silicon (a-Si:H) layer deposited by the Hot-Wire Chemical Vapor Deposition (HWCVD) technique. This demonstrates the possibility of utilizing this material in devices. The deposition rate by Hot-Wire CVD is an order of magnitude higher than by Plasma Enhanced CVD. The switching ratio for TFTs based on HWCVD a-Si:H is better than 5 orders of magnitude. The field-effect mobility as determined from the saturation regime of the transfer characteristics is still quite poor. The interface with the gate dielectric needs further optimization. Current crowding effects, however, could be completely eliminated by a H2 plasma treatment of the HW-deposited intrinsic layer. In contrast to the PECVD reference device, the HWCVD device appears to be almost unsensitive to bias voltage stressing. This shows that HW-deposited material might be an approach to much more stable devices.


2009 ◽  
Vol 105 (12) ◽  
pp. 124504 ◽  
Author(s):  
S. L. Rumyantsev ◽  
Sung Hun Jin ◽  
M. S. Shur ◽  
Mun-Soo Park

1989 ◽  
Vol 28 (Part 1, No. 11) ◽  
pp. 2197-2200 ◽  
Author(s):  
Kouichi Hiranaka ◽  
Tetsuzo Yoshimura ◽  
Tadahisa Yamaguchi

1993 ◽  
Vol 297 ◽  
Author(s):  
Byung Chul Ahn ◽  
Jeong Hyun Kim ◽  
Dong Gil Kim ◽  
Byeong Yeon Moon ◽  
Kwang Nam Kim ◽  
...  

The hydrogenation effect was studied in the fabrication of amorphous silicon thin film transistor using APCVD technique. The inverse staggered type a-Si TFTs were fabricated with the deposited a-Si and SiO2 films by the atmospheric pressure (AP) CVD. The field effect mobility of the fabricated a-Si TFT is 0.79 cm2/Vs and threshold voltage is 5.4V after post hydrogenation. These results can be applied to make low cost a-Si TFT array using an in-line APCVD system.


Sign in / Sign up

Export Citation Format

Share Document