Self-consistent analysis of high-temperature effects on strained-layer multiquantum-well InGaAsP-InP lasers

2000 ◽  
Vol 36 (3) ◽  
pp. 366-374 ◽  
Author(s):  
J. Piprek ◽  
P. Abraham ◽  
J.E. Bowers
Keyword(s):  
High Temperature ◽  
Temperature Effects ◽  
Strained Layer ◽  
Self Consistent ◽  
Multiquantum Well

scholarly journals Environmental effects on photosynthetic capacity of bean genotypes

2004 ◽  
Vol 39 (7) ◽  
pp. 615-623 ◽  
Author(s):  
Rafael Vasconcelos Ribeiro ◽  
Mauro Guida dos Santos ◽  
Gustavo Maia Souza ◽  
Eduardo Caruso Machado ◽  
Ricardo Ferraz de Oliveira ◽  
...  
Keyword(s):  
High Temperature ◽  
Natural Condition ◽  
Temperature Effects ◽  
Environmental Changes ◽  
Photosynthetic Capacity ◽  
Photosynthetic Apparatus ◽  
Co2 Assimilation ◽  
Fluorescence Yield ◽  
Environmental Condition ◽  
Response Curves

Photosynthetic responses to daily environmental changes were studied in bean (Phaseolus vulgaris L.) genotypes 'Carioca', 'Ouro Negro', and Guarumbé. Light response curves of CO2 assimilation and stomatal conductance (g s) were also evaluated under controlled (optimum) environmental condition. Under this condition, CO2 assimilation of 'Carioca' was not saturated at 2,000 µmol m-2 s-1, whereas Guarumbé and 'Ouro Negro' exhibited different levels of light saturation. All genotypes showed dynamic photoinhibition and reversible increase in the minimum chlorophyll fluorescence yield under natural condition, as well as lower photosynthetic capacity when compared with optimum environmental condition. Since differences in g s were not observed between natural and controlled conditions for Guarumbé and 'Ouro Negro', the lower photosynthetic capacity of these genotypes under natural condition seems to be caused by high temperature effects on biochemical reactions, as suggested by increased alternative electron sinks. The highest g s values of 'Carioca' were observed at controlled condition, providing evidences that reduction of photosynthetic capacity at natural condition was due to low g s in addition to the high temperature effects on the photosynthetic apparatus. 'Carioca' exhibited the highest photosynthetic rates under optimum environmental condition, and was more affected by daily changes of air temperature and leaf-to-air vapor pressure difference.

High Temperature Effects in Li-Doped ZnO Thin Films

2004 ◽  
Vol 63 (1) ◽  
pp. 209-213 ◽  
Author(s):  
A. DEYNEKA ◽  
Z. HUBICKA ◽  
M. CADA ◽  
G. SUCHANECK ◽  
M. SAVINOV ◽  
...  
Keyword(s):  
Thin Films ◽  
High Temperature ◽  
Temperature Effects ◽  
Zno Thin Films ◽  
Doped Zno

High- temperature effects of aluminum-coated fiber

1986 ◽  
Vol 4 (8) ◽  
pp. 1151-1156 ◽  
Author(s):  
T. Shiota ◽  
H. Hidaka ◽  
O. Fukuda ◽  
K. Inada
Keyword(s):  
High Temperature ◽  
Temperature Effects ◽  
Coated Fiber

Constitutive Analysis of the High-Temperature Deformation Behavior of Single Phase α-Ti and α+β Ti-6Al-4V Alloy

2007 ◽  
Vol 539-543 ◽  
pp. 3607-3612 ◽  
Author(s):  
Jeoung Han Kim ◽  
Jong Taek Yeom ◽  
Nho Kwang Park ◽  
Chong Soo Lee
Keyword(s):  
High Temperature ◽  
Flow Stress ◽  
Deformation Behavior ◽  
Single Phase ◽  
Volume Fraction ◽  
High Temperature Deformation ◽  
Temperature Deformation ◽  
Β Phase ◽  
Α Phase ◽  
Self Consistent

The high-temperature deformation behavior of the single-phase α (Ti-7.0Al-1.5V) and α + β (Ti-6Al-4V) alloy were determined and compared within the framework of self-consistent scheme at various temperature ranges. For this purpose, isothermal hot compression tests were conducted at temperatures between 650°C ~ 950°C to determine the effect of α/β phase volume fraction on average flow stress under hot-working condition. The flow behavior of α phase was estimated from the compression test results of single-phase α alloy whose chemical composition is close to that of α phase of Ti-6Al-4V alloy. On the other hand, the flow stress of β phase in Ti-6Al-4V was predicted by using self-consistent method. The flow stress of α phase was higher than that of β phase above 750°C, while the β phase revealed higher flow stress than α phase at 650°C. Also, at temperature above 750°C, the predicted strain rate of β phase was higher than that of α phase. It was found that the relative strength between α and β phase significantly varied with temperature.

Sign in / Sign up

Export Citation Format

Share Document