Smooth- and rough-wall boundary layer structure from high spatial range particle image velocimetry

2016 ◽  
Vol 1 (6) ◽  
Author(s):  
D. T. Squire ◽  
C. Morrill-Winter ◽  
N. Hutchins ◽  
I. Marusic ◽  
M. P. Schultz ◽  
...  
Keyword(s):  
Boundary Layer ◽  
Particle Image Velocimetry ◽  
Particle Image ◽  
Layer Structure ◽  
Rough Wall ◽  
Boundary Layer Structure ◽  
Wall Boundary Layer ◽  
Wall Boundary ◽  
Spatial Range ◽  
Image Velocimetry

Characteristics of a separated flow past a semicircular leading-edge airfoil model under different imposed pressure gradient

2021 ◽  
pp. 095441002110212
Author(s):  
K Anand ◽  
KT Ganesh
Keyword(s):  
Boundary Layer ◽  
Particle Image Velocimetry ◽  
Pressure Gradient ◽  
Particle Image ◽  
Separation Bubble ◽  
Separated Flow ◽  
Leading Edge ◽  
Field Measurements ◽  
Bench Mark ◽  
Image Velocimetry

The effect of pressure gradient on a separated boundary layer past the leading edge of an airfoil model is studied experimentally using electronically scanned pressure (ESP) and particle image velocimetry (PIV) for a Reynolds number ( Re) of 25,000, based on leading-edge diameter ( D). The features of the boundary layer in the region of separation and its development past the reattachment location are examined for three cases of β (−30°, 0°, and +30°). The bubble parameters such as the onset of separation and transition and the reattachment location are identified from the averaged data obtained from pressure and velocity measurements. Surface pressure measurements obtained from ESP show a surge in wall static pressure for β = −30° (flap deflected up), while it goes down for β = +30° (flap deflected down) compared to the fundamental case, β = 0°. Particle image velocimetry results show that the roll up of the shear layer past the onset of separation is early for β = +30°, owing to higher amplification of background disturbances compared to β = 0° and −30°. Downstream to transition location, the instantaneous field measurements reveal a stretched, disoriented, and at instances bigger vortices for β = +30°, whereas a regular, periodically shed vortices, keeping their identity past the reattachment location, is observed for β = 0° and −30°. Above all, this study presents a new insight on the features of a separation bubble receiving a disturbance from the downstream end of the model, and these results may serve as a bench mark for future studies over an airfoil under similar environment.

Velocity and temperature scaling in a rough wall boundary layer

2000 ◽  
Vol 62 (1) ◽  
pp. 640-646 ◽  
Author(s):  
R. A. Antonia ◽  
R. J. Smalley
Keyword(s):  
Boundary Layer ◽  
Rough Wall ◽  
Wall Boundary Layer ◽  
Wall Boundary ◽  
Temperature Scaling

Experimental study of the mean structure and quasi-conical scaling of a swept-compression-ramp interaction at Mach 2

2018 ◽  
Vol 841 ◽  
pp. 1-27 ◽  
Author(s):  
Leon Vanstone ◽  
Mustafa Nail Musta ◽  
Serdar Seckin ◽  
Noel Clemens
Keyword(s):  
Boundary Layer ◽  
Shock Wave ◽  
Particle Image Velocimetry ◽  
Flow Field ◽  
Scaling Laws ◽  
Particle Image ◽  
Separated Flow ◽  
Image Velocimetry ◽  
The Mean ◽  
Wave Boundary

This study investigates the mean flow structure of two shock-wave boundary-layer interactions generated by moderately swept compression ramps in a Mach 2 flow. The ramps have a compression angle of either $19^{\circ }$ or $22.5^{\circ }$ and a sweep angle of $30^{\circ }$. The primary diagnostic methods used for this study are surface-streakline flow visualization and particle image velocimetry. The shock-wave boundary-layer interactions are shown to be quasi-conical, with the intermittent region, separation line and reattachment line all scaling in a self-similar manner outside of the inception region. This is one of the first studies to investigate the flow field of a swept ramp using particle image velocimetry, allowing more sensitive measurements of the velocity flow field than previously possible. It is observed that the streamwise velocity component outside of the separated flow reaches the quasi-conical state at the same time as the bulk surface flow features. However, the streamwise and cross-stream components within the separated flow take longer to recover to the quasi-conical state, which indicates that the inception region for these low-magnitude velocity components is actually larger than was previously assumed. Specific scaling laws reported previously in the literature are also investigated and the results of this study are shown to scale similarly to these related interactions. Certain limiting cases of the scaling laws are explored that have potential implications for the interpretation of cylindrical and quasi-conical scaling.

Sign in / Sign up

Export Citation Format

Share Document