scholarly journals Quantum friction between oscillating crystal slabs: Graphene monolayers on dielectric substrates

2018 ◽  
Vol 98 (12) ◽  
Author(s):  
Vito Despoja ◽  
Pedro M. Echenique ◽  
Marijan Šunjić
Keyword(s):  
Dielectric Substrates ◽  
Quantum Friction

Electrical Anisotropy of Thin Metal Films Growing on Dielectric Substrates

2002 ◽  
Vol 7 (2) ◽  
pp. 45-52
Author(s):  
L. Jakučionis ◽  
V. Kleiza
Keyword(s):  
Magnetic Field ◽  
Thin Films ◽  
Uniaxial Anisotropy ◽  
Metal Films ◽  
Thin Layers ◽  
Electrical Anisotropy ◽  
Electrical Field ◽  
Dielectric Substrates ◽  
Unequal Probability ◽  
Conductive Thin Films

Electrical properties of conductive thin films, that are produced by vacuum evaporation on the dielectric substrates, and which properties depend on their thickness, usually are anisotropic i.e. they have uniaxial anisotropy. If the condensate grow on dielectric substrates on which plane electrical field E is created the transverse voltage U⊥ appears on the boundary of the film in the direction perpendicular to E. Transverse voltage U⊥ depends on the angle γ between the applied magnetic field H and axis of light magnetisation. When electric field E is applied to continuous or grid layers, U⊥ and resistance R of layers are changed by changing γ. It means that value of U⊥ is the measure of anisotropy magnitude. Increasing voltage U0 , which is created by E, U⊥ increases to certain magnitude and later decreases. The anisotropy of continuous thin layers is excited by inequality of conductivity tensor components σ0 ≠ σ⊥. The reason of anisotropy is explained by the model which shows that properties of grain boundaries are defined by unequal probability of transient of charge carrier.

SOMERS LTA COPPER

Alloy Digest ◽  
1980 ◽  
Vol 29 (12) ◽  
Keyword(s):  
High Temperature ◽  
Low Temperature ◽  
Physical Properties ◽  
Copper Foil ◽  
Heat Treating ◽  
Dielectric Substrates ◽  
Printed Circuits

Abstract SOMERS LTA Copper is a wrought copper foil that can be annealed at 350 F in 15 minutes to the full-soft condition; its use simplifies the manufacture of printed circuits (LTA = Low-Temperature Annealable). LTA Copper is especially useful for foil weights up to and including one ounce per square foot (0.0014-inch thick) for laminating to high-temperature dielectric substrates. This datasheet provides information on composition, physical properties, and elasticity as well as fatigue. It also includes information on forming, heat treating, and machining. Filing Code: Cu-407. Producer or source: Olin Corporation.

scholarly journals Broadband Unidirectional Forward Scattering with High Refractive Index Nanostructures: Application in Solar Cells

Molecules ◽  
2021 ◽  
Vol 26 (15) ◽  
pp. 4421
Author(s):  
Ángela Barreda ◽  
Pablo Albella ◽  
Fernando Moreno ◽  
Francisco González
Keyword(s):  
Refractive Index ◽  
Solar Cells ◽  
Forward Direction ◽  
High Refractive Index ◽  
Incident Radiation ◽  
Antireflection Coating ◽  
Electromagnetic Response ◽  
Silicon Substrates ◽  
Graded Index ◽  
Dielectric Substrates

High refractive index dielectric (HRID) nanoparticles are a clear alternative to metals in nanophotonic applications due to their low losses and directional scattering properties. It has been demonstrated that HRID dimers are more efficient scattering units than single nanoparticles in redirecting the incident radiation towards the forward direction. This effect was recently reported and is known as the “near zero-backward” scattering condition, attained when nanoparticles forming dimers strongly interact with each other. Here, we analyzed the electromagnetic response of HRID isolated nanoparticles and aggregates when deposited on monolayer and graded-index multilayer dielectric substrates. In particular, we studied the fraction of radiation that is scattered towards a substrate with known optical properties when the nanoparticles are located on its surface. We demonstrated that HRID dimers can increase the radiation emitted towards the substrate compared to that of isolated nanoparticles. However, this effect was only present for low values of the substrate refractive index. With the aim of observing the same effect for silicon substrates, we show that it is necessary to use a multilayer antireflection coating. We conclude that dimers of HRID nanoparticles on a graded-index multilayer substrate can increase the radiation scattered into a silicon photovoltaic wafer. The results in this work can be applied to the design of novel solar cells.

scholarly journals A theoretical and numerical approach for selecting miniaturized antenna topologies on magneto-dielectric substrates

2015 ◽  
Vol 7 (3-4) ◽  
pp. 369-377 ◽  
Author(s):  
Alex Pacini ◽  
Alessandra Costanzo ◽  
Diego Masotti
Keyword(s):  
Near Field ◽  
Dielectric Materials ◽  
Numerical Approach ◽  
Operating Conditions ◽  
Microwave Range ◽  
Dielectric Substrates ◽  
Full Wave ◽  
Miniaturized Antenna ◽  
Wavelength Radiation ◽  
Definition Of

An increasing interest is arising in developing miniaturized antennas in the microwave range. However, even when the adopted antennas dimensions are small compared with the wavelength, radiation performances have to be preserved to keep the system-operating conditions. For this purpose, magneto-dielectric materials are currently exploited as promising substrates, which allows us to reduce antenna dimensions by exploiting both relative permittivity and permeability. In this paper, we address generic antennas in resonant conditions and we develop a general theoretical approach, not based on simplified equivalent models, to establish topologies most suitable for exploiting high permeability and/or high-permittivity substrates, for miniaturization purposes. A novel definition of the region pertaining to the antenna near-field and of the associated field strength is proposed. It is then showed that radiation efficiency and bandwidth can be preserved only by a selected combinations of antenna topologies and substrate characteristics. Indeed, by the proposed independent approach, we confirm that non-dispersive magneto-dielectric materials with relative permeability greater than unit, can be efficiently adopted only by antennas that are mainly represented by equivalent magnetic sources. Conversely, if equivalent electric sources are involved, the antenna performances are significantly degraded. The theoretical results are validated by full-wave numerical simulations of reference topologies.

Quantum friction with a stochastic force

1982 ◽  
Vol 15 (11) ◽  
pp. 3543-3550 ◽  
Author(s):  
R Alicki ◽  
J Messer
Keyword(s):  
Stochastic Force ◽  
Quantum Friction

scholarly journals Metal–Organic Frameworks: Face‐to‐Face Growth of Wafer‐Scale 2D Semiconducting MOF Films on Dielectric Substrates (Adv. Mater. 13/2021)

2021 ◽  
Vol 33 (13) ◽  
pp. 2170095
Author(s):  
Youxing Liu ◽  
Yanan Wei ◽  
Minghui Liu ◽  
Yichao Bai ◽  
Xinyu Wang ◽  
...  
Keyword(s):  
Metal Organic Frameworks ◽  
Wafer Scale ◽  
Face To Face ◽  
Dielectric Substrates ◽  
Metal Organic

scholarly journals Characterization of Dielectric Substrates Using Dual Band Microwave Sensor

IEEE Access ◽  
2021 ◽  
Vol 9 ◽  
pp. 62779-62787
Author(s):  
Ammar Armghan ◽  
Turki M. Alanazi ◽  
Ahsan Altaf ◽  
Tanveerul Haq
Keyword(s):  
Dual Band ◽  
Dielectric Substrates ◽  
Microwave Sensor
Sign in / Sign up

Export Citation Format

Share Document