Theory of the Low-Temperature Thermal Resistivity in Simple Metals

1973 ◽  
Vol 8 (8) ◽  
pp. 3610-3615 ◽  
Author(s):  
A. C. Ehrlich
Keyword(s):  
Low Temperature ◽  
Thermal Resistivity

scholarly journals Investigation of the Thermo-Physical and Mechanical Properties of Coir and Sugarcane Bagasse for Low Temperature Insulation

2021 ◽  
Vol 6 (4) ◽  
pp. 340-356
Author(s):  
Mustapha Ndagi ◽  
Ajiboye Tajudeen Kolawole ◽  
Fabiyi Mustapha Olawale ◽  
Abdulkareem Sulaiman
Keyword(s):  
Thermal Conductivity ◽  
Particle Size ◽  
Low Temperature ◽  
Sugarcane Bagasse ◽  
Control Sample ◽  
Gum Arabic ◽  
Absorption Capacity ◽  
Thermal Resistivity ◽  
Insulating Materials ◽  
Insulating Material

This research  reports on the suitability of Agricultural bi-products as low temperature thermal insulating materials to replace synthetic insulating materials like polyurethane used in food warmers and ice coolers. Coir and sugarcane bagasse chosen for this research was based on literature review and local availability of materials. Coir was obtained from Badagry, Lagos State and Sugarcane bagasse obtained from Batati, Niger State, the materials were washed, sun dried for three days and cut into smaller pieces before being blended into smaller particles using an electric blender. The blended materials (Coir and Bagasse) were sieved into two different sieve size of 0.5 mm and 1.0 mm respectively.  The particles sizes were then combined into blend ratios of 50/50, 60/40, and 70/30 using Gum Arabic as binder. Thermal conductivity test showed that 1.0 mm particle size coir mixed with sugarcane bagasse has the lowest thermal conductivity of 0.01467 W/mK whilst that of 0.5 mm particle size has thermal conductivity of 0.01472 W/mK this is lower compared to the measured thermal conductivity of the polyurethane control sample of 0.01832 W/mK. Sample F (1.0 mm particle size,70% coir and 30% bagasse) with a thermal diffusivity of 5.15  m²/s, water absorption capacity of 410 %, UTS of 0.219 MPa, Compressive strength of 0.583 MPa, Specific heat capacity of 1141.3 J/kgK and thermal resistivity of 68.16 W/m/K is most suitable replacement for polyurethane as low temperature thermal insulator. This is corroborated by the performance evaluation test with carried out between polyurethane lined food warmer and bio-composite lined food warmer. The two test samples have close ice melt rate values and the polyurethane slightly edge the Bio-composite insulating material by 1.2 % in efficiency. The edge in efficiency can be accepted as all materials used in the development of the bio-composite insulating material are completely bio-degradable and environmentally friendly.

LOW TEMPERATURE RESISTIVITY OF THE TRANSITION ELEMENTS: COBALT, TUNGSTEN, AND RHENIUM

1957 ◽  
Vol 35 (5) ◽  
pp. 656-665 ◽  
Author(s):  
G. K. White ◽  
S. B. Woods
Keyword(s):  
Electrical Resistivity ◽  
Low Temperature ◽  
Thermal Resistance ◽  
High Purity ◽  
Thermal Resistivity ◽  
Superconducting Transition ◽  
Transition Elements ◽  
Experimental Values ◽  
Thermal Vibrations ◽  
Temperature Resistivity

Experimental values are reported for the electrical resistivity from 1.5° to 300° K. and for the thermal resistivity from 2° to 120° K. of high purity cobalt, tungsten, and rhenium. The temperature variation of the components of the electrical and of the thermal resistance due to scattering by thermal vibrations is deduced and the possible evidence for the importance of s–d transitions is discussed briefly. The temperature of the superconducting transition in samples of rhenium is found to be close to 1.70° K., the value reported by Hulm (1954).

Exsolution and inversion in pigeonite from the Whin Sill, Northern England

1978 ◽  
Vol 36 (1) ◽  
pp. 474-475
Author(s):  
P.P.K. Smith
Keyword(s):  
High Temperature ◽  
Low Temperature ◽  
Homogeneous Nucleation ◽  
Silicate Mineral ◽  
Antiphase Boundaries ◽  
Two Phase ◽  
Primitive Form ◽  
The Core ◽  
Nucleation Mechanisms ◽  
And Inversion

Grains of pigeonite, a calcium-poor silicate mineral of the pyroxene group, from the Whin Sill dolerite have been ion-thinned and examined by TEM. The pigeonite is strongly zoned chemically from the composition Wo8En64FS28 in the core to Wo13En34FS53 at the rim. Two phase transformations have occurred during the cooling of this pigeonite:- exsolution of augite, a more calcic pyroxene, and inversion of the pigeonite from the high- temperature C face-centred form to the low-temperature primitive form, with the formation of antiphase boundaries (APB's). Different sequences of these exsolution and inversion reactions, together with different nucleation mechanisms of the augite, have created three distinct microstructures depending on the position in the grain.In the core of the grains small platelets of augite about 0.02μm thick have farmed parallel to the (001) plane (Fig. 1). These are thought to have exsolved by homogeneous nucleation. Subsequently the inversion of the pigeonite has led to the creation of APB's.

Low temperature x-ray microanalysis of frozen-hydrated tobacco leaves

1984 ◽  
Vol 42 ◽  
pp. 284-285
Author(s):  
S. Edith Taylor ◽  
Patrick Echlin ◽  
May McKoon ◽  
Thomas L. Hayes
Keyword(s):  
Low Temperature ◽  
Lemna Minor ◽  
Root Tips ◽  
Tobacco Leaves ◽  
X Ray ◽  
Whole Cells ◽  
Carbon Coated ◽  
The Right ◽  
Beam Currents ◽  
The University

Low temperature x-ray microanalysis (LTXM) of solid biological materials has been documented for Lemna minor L. root tips. This discussion will be limited to a demonstration of LTXM for measuring relative elemental distributions of P,S,Cl and K species within whole cells of tobacco leaves.Mature Wisconsin-38 tobacco was grown in the greenhouse at the University of California, Berkeley and picked daily from the mid-stalk position (leaf #9). The tissue was excised from the right of the mid rib and rapidly frozen in liquid nitrogen slush. It was then placed into an Amray biochamber and maintained at 103K. Fracture faces of the tissue were prepared and carbon-coated in the biochamber. The prepared sample was transferred from the biochamber to the Amray 1000A SEM equipped with a cold stage to maintain low temperatures at 103K. Analyses were performed using a tungsten source with accelerating voltages of 17.5 to 20 KV and beam currents from 1-2nA.

Bulk standards for low-temperature biological x-ray microanalysis

1984 ◽  
Vol 42 ◽  
pp. 282-283
Author(s):  
P. Echlin ◽  
M. McKoon ◽  
E.S. Taylor ◽  
C.E. Thomas ◽  
K.L. Maloney ◽  
...  
Keyword(s):  
Phase Separation ◽  
Low Temperature ◽  
Analytical Method ◽  
Salt Solutions ◽  
Absolute Concentration ◽  
Cooling Process ◽  
X Ray ◽  
The Absolute ◽  
Analytical Procedures ◽  
Electrical Conductors

Although sections of frozen salt solutions have been used as standards for x-ray microanalysis, such solutions are less useful when analysed in the bulk form. They are poor thermal and electrical conductors and severe phase separation occurs during the cooling process. Following a suggestion by Whitecross et al we have made up a series of salt solutions containing a small amount of graphite to improve the sample conductivity. In addition, we have incorporated a polymer to ensure the formation of microcrystalline ice and a consequent homogenity of salt dispersion within the frozen matrix. The mixtures have been used to standardize the analytical procedures applied to frozen hydrated bulk specimens based on the peak/background analytical method and to measure the absolute concentration of elements in developing roots.

Field ion microscopy

1988 ◽  
Vol 46 ◽  
pp. 434-435
Author(s):  
Gert Ehrlich
Keyword(s):  
Low Temperature ◽  
Sample Surface ◽  
Low Pressure ◽  
Radius Of Curvature ◽  
Field Ion Microscopy ◽  
Phosphor Screen ◽  
Ion Microscopy ◽  
Field Ion Microscope

The field ion microscope, devised by Erwin Muller in the 1950's, was the first instrument to depict the structure of surfaces in atomic detail. An FIM image of a (111) plane of tungsten (Fig.l) is typical of what can be done by this microscope: for this small plane, every atom, at a separation of 4.48Å from its neighbors in the plane, is revealed. The image of the plane is highly enlarged, as it is projected on a phosphor screen with a radius of curvature more than a million times that of the sample. Müller achieved the resolution necessary to reveal individual atoms by imaging with ions, accommodated to the object at a low temperature. The ions are created at the sample surface by ionization of an inert image gas (usually helium), present at a low pressure (< 1 mTorr). at fields on the order of 4V/Å.

High-Vacuum Evaporation and a Cryostage to Observe Fractured Yeast

1988 ◽  
Vol 46 ◽  
pp. 256-257
Author(s):  
William P. Wergin ◽  
Eric F. Erbe ◽  
Eugene L. Vigil
Keyword(s):  
Electron Microscope ◽  
Low Temperature ◽  
Standard Specimen ◽  
High Vacuum ◽  
Specimen Holder ◽  
Sputter Coating ◽  
Fresh Frozen ◽  
Gain Access ◽  
Scanning Electron ◽  
Transfer Device

Investigators have long realized the potential advantages of using a low temperature (LT) stage to examine fresh, frozen specimens in a scanning electron microscope (SEM). However, long working distances (W.D.), thick sputter coatings and surface contamination have prevented LTSEM from achieving results comparable to those from TEM freeze etch. To improve results, we recently modified techniques that involve a Hitachi S570 SEM, an Emscope SP2000 Sputter Cryo System and a Denton freeze etch unit. Because investigators have frequently utilized the fractured E face of the plasmalemma of yeast, this tissue was selected as a standard for comparison in the present study.In place of a standard specimen holder, a modified rivet was used to achieve a shorter W.D. (1 to -2 mm) and to gain access to the upper detector. However, the additional height afforded by the rivet, precluded use of the standard shroud on the Emscope specimen transfer device. Consequently, the sample became heavily contaminated (Fig. 1). A removable shroud was devised and used to reduce contamination (Fig. 2), but the specimen lacked clean fractured edges. This result suggested that low vacuum sputter coating was also limiting resolution.

Sign in / Sign up

Export Citation Format

Share Document