Energy shift and line broadening of three-dimensional excitons in electric fields

1987 ◽  
Vol 36 (12) ◽  
pp. 6609-6612 ◽  
Author(s):  
L. Schultheis ◽  
K. Köhler ◽  
C. W. Tu
Keyword(s):  
Electric Fields ◽  
Three Dimensional ◽  
Energy Shift ◽  
Line Broadening

Ingan Quantum Dots Fabricated On Aigan Surfaces -Growth Mechanism And Optical Propertiesh-

1997 ◽  
Vol 482 ◽  
Author(s):  
H. Hirayama ◽  
S. Tanaka ◽  
P. Ramvall ◽  
Y. Aoyagi
Keyword(s):  
Quantum Dots ◽  
Three Dimensional ◽  
Chemical Vapor ◽  
Energy Shift ◽  
Organic Chemical ◽  
Self Assembling ◽  
Atomic Force ◽  
Peak Energy ◽  
Metal Organic ◽  
Organic Chemical Vapor Deposition

AbstractWe demonstrate photoluminescence from self- assembling InGaN quantum dots (QDs), which are artificially fabricated on AlGaN surfaces via metal- organic chemical vapor deposition. InGaN QDs are successfully fabricated by the growth mode transition from step- flow to three dimensional island formation by using anti-surfactant silicon on AlGaN surface. The diameter and height of the fabricated InGaN QDs are estimated to be ˜10nm and ˜5nm, respectively, by an atomic- force- microscope (AFM). Indium mole fraction of InxGal−x N QDs is controlled from x=˜0.22 to ˜0.52 by varying the growth temperature of QDs. Intense photoluminescence is observed even at room temperature from InGaN QDs embedded with the GaN capping layers. In addition, the temperature- dependent energy shift of the photoluminescence peak- energy shows a localization behavior.

Numerical modelling of twisted nematic devices

1983 ◽  
Vol 309 (1507) ◽  
pp. 203-216 ◽  
Keyword(s):  
Liquid Crystal ◽  
Electric Fields ◽  
Low Cost ◽  
Three Dimensional ◽  
Physical Parameters ◽  
Crystal Layer ◽  
Liquid Crystal Layer ◽  
Chiral Nematic ◽  
Twisted Nematic ◽  
Three Dimensional Simulations

Over most of each active region in nematic and chiral nematic twist cells the motion and configuration of the liquid crystal layer does not vary appreciably with position parallel to the surfaces. In such laminar regions the statics, dynamics and optics ot the cell can be accurately simulated at low cost on a computer of moderate size, given the appropriate physical parameters. Methods and recent advances in simulation of laminar regions are reviewed. Bistable twist cells are simulated for illustration. Important problems of stability and edge effects in the presence of electric fields await solution with two- or three-dimensional simulations.

Smart Hydrogels for Pharmaceutical Applications

2017 ◽  
pp. 1133-1164
Author(s):  
Snežana S. Ilić-Stojanović ◽  
Ljubiša B. Nikolić ◽  
Vesna D. Nikolić ◽  
Slobodan D. Petrović
Keyword(s):  
Electric Fields ◽  
Polymer Network ◽  
Three Dimensional ◽  
Chemical Properties ◽  
Stimuli Responsive ◽  
Crosslinking Degree ◽  
Color Transparency ◽  
Hydrogel Network ◽  
Physical And Chemical ◽  
Responsive Hydrogels

The latest development in the field of smart hydrogels application as drugs carriers is shown in this chapter. Hydrogels are three-dimensional polymer network consisting of at least one hydrophilic monomer. They are insoluble in water, but in the excess presence of water or physiological fluids, swell to the equilibrium state. The amount of absorbed water depends on the chemical composition and the crosslinking degree of 3D hydrogel network and reaches over 1000% of the xerogel weight. Stimuli-responsive hydrogels exhibit significant change of their properties (swelling, color, transparency, conductivity, shape) due to small changes in the external environment conditions (pH, ionic strength, temperature, light wavelength, magnetic or electric fields, ultrasound, or a combination thereof). This smart hydrogels, with different physical and chemical properties, chemical structure and technology of obtaining, show great potential for application in the pharmaceutical industry. The application of smart hydrogels is very promising and at the beginning of the development and exploitation.

scholarly journals Simulations of the neutral structure within the dusk side aurora

2006 ◽  
Vol 24 (10) ◽  
pp. 2519-2532
Author(s):  
H. F. Parish ◽  
L. R. Lyons
Keyword(s):  
Electric Fields ◽  
Three Dimensional ◽  
Meridional Wind ◽  
Recovery Phase ◽  
Limited Area ◽  
Neutral Winds ◽  
E Region ◽  
Linear Interactions ◽  
Simulated Wind ◽  
Equivalent Conditions

Abstract. Observations of neutral winds from rocket release experiments within the premidnight and postmidnight substorm recovery phase aurora, show very large E-region neutral winds of several hundred m/s, where winds measured on the dusk side are even larger than those on the dawn side. These large winds are also associated with strong shears, and there is evidence that some of the regions below these shears may be unstable. The mechanisms which generate this strong vertical structure are not well understood. It is also not known whether the acceleration conditions in the pre and post midnight sectors of the aurora may produce significantly different neutral responses on the dawn and dusk sides. Simulations have been performed using a three-dimensional high resolution limited area thermosphere model to try to understand the neutral structure within the dawn and dusk side aurora. When simulations are performed using auroral forcing alone, for equivalent conditions within the dawn and dusk sectors, differences are found in the simulated response on each side. When measured values of auroral forcing parameters, and background winds and tides consistent with recent observations, are used as model inputs, some of the main features of the zonal and meridional wind observations are reproduced in the simulations, but the magnitude of the peak zonal wind around 140 km tends to be too small and the maximum meridional wind around 130 km is overestimated. The winds above 120 km altitude are found to be sensitive to changes in electric fields and ion densities, as was the case for the dawn side, but the effects of background winds and tides on the magnitudes of the winds above 120 km are found to be relatively small on the dusk side. The structure below 120 km appears to be related mainly to background winds and tides rather than auroral forcing, as was found in earlier studies on the dawn side, although the peak magnitudes of simulated wind variations in the 100 to 120 km altitude range are smaller than those observed. The source of the strong shears measured around 110 km altitude on the dusk side is uncertain, but may be related to different kinds of oscillations, such as gravity waves, non migrating semidiurnal tides, or secondary oscillations produced by non linear interactions between waves.

scholarly journals BEM Modelling of High Voltage ELF electric field applied to a 3D pregnant woman model

2010 ◽  
Vol 6 (1) ◽  
pp. 31 ◽  
Author(s):  
Cristina Peratta ◽  
Andres Peratta ◽  
Dragan Poljak
Keyword(s):  
Pregnant Woman ◽  
Electric Field ◽  
Electric Fields ◽  
High Voltage ◽  
Medical Information ◽  
Three Dimensional ◽  
Low Frequency ◽  
Element Model ◽  
The Body ◽  
Geometrical Properties

The paper introduces a three dimensional multidomainboundary element model of a pregnant woman and foetus for the analysis of exposure to high voltage extremely low frequency electric fields. The definition of the differentphysical and geometrical properties of the relevant tissues is established according to medical information available in existing literature. The model takes into account changes in geometry, body mass, body fat, and overall chemical composition in the body which influence the electrical properties, throughout the different gestational periods. The developed model is used to solve the case of exposure to overhead power transmission lines at different stages of pregnancy including weeks 8, 13, 26 and 38. The results obtained are in line with those published in the earlier works considering different approaches. In addition, a sensitivity analysis involving varying scenarios of conductivity, foetus postures and geometry for each stage is defined and solved. Finally, a correlation between the externally applied electric field and the current density inside the foetus is established and the zones of maximum exposure are identified.

scholarly journals Wavelength dependence of the linear growth rate of the <I>E<sub>s</sub></I> layer instability

2007 ◽  
Vol 25 (6) ◽  
pp. 1311-1322 ◽  
Author(s):  
R. B. Cosgrove
Keyword(s):  
Growth Rate ◽  
Electric Fields ◽  
Large Scale ◽  
Linear Growth ◽  
Three Dimensional ◽  
Generalized Derivation ◽  
Wavelength Dependence ◽  
Meridional Wind ◽  
Linear Growth Rate ◽  
Significant Wavelength

Abstract. It has recently been shown, by computation of the linear growth rate, that midlatitude sporadic-E (Es) layers are subject to a large scale electrodynamic instability. This instability is a logical candidate to explain certain frontal structuring events, and polarization electric fields, which have been observed in Es layers by ionosondes, by coherent scatter radars, and by rockets. However, the original growth rate derivation assumed an infinitely thin Es layer, and therefore did not address the short wavelength cutoff. Also, the same derivation ignored the effects of F region loading, which is a significant wavelength dependent effect. Herein is given a generalized derivation that remedies both these short comings, and thereby allows a computation of the wavelength dependence of the linear growth rate, as well as computations of various threshold conditions. The wavelength dependence of the linear growth rate is compared with observed periodicities, and the role of the zeroth order meridional wind is explored. A three-dimensional paper model is used to explain the instability geometry, which has been defined formally in previous works.

Echoes and imaging in solids

1990 ◽  
Vol 333 (1632) ◽  
pp. 427-439 ◽  
Keyword(s):  
Spin Echo ◽  
Three Dimensional ◽  
Two Dimensions ◽  
Spectral Lines ◽  
Line Broadening ◽  
Rf Pulses ◽  
Field Gradients ◽  
Magnetic Field Gradients ◽  
Bandwidth Limitation ◽  
Successful Approach

The broad spectral lines usually encountered in solid state NMR present considerable difficulties for imaging. One successful approach to the problem is to artificially narrow the line by multipulse or sample spinning methods. An alternative is to apply sufficiently large magnetic field gradients that they dominate the line broadening and seek ways to deal with bandwidth and power requirements thereby introduced. This paper explores the second route and demonstrates that spin-echo techniques help to solve several of the inherent problems. Gradient echoes produced by periodic reversal of the field gradients have significant advantages. The addition of synchronous RF pulses can produce an extended train of ‘solid’ echoes which overcomes, at least to some extent, the bandwidth limitation of this approach and permits rapid imaging in two dimensions. Slice selection and three-dimensional back projection have also been achieved in solid-like samples. Comparison with linenarrowing methods and relative advantages of the different approaches are addressed.

scholarly journals Electrical and Polarimetric Radar Observations of a Multicell Storm in TELEX

2007 ◽  
Vol 135 (7) ◽  
pp. 2525-2544 ◽  
Author(s):  
Eric C. Bruning ◽  
W. David Rust ◽  
Terry J. Schuur ◽  
Donald R. MacGorman ◽  
Paul R. Krehbiel ◽  
...  
Keyword(s):  
Electric Field ◽  
Electric Fields ◽  
Negative Charge ◽  
Positive Charge ◽  
Three Dimensional ◽  
Phase Region ◽  
Polarimetric Radar ◽  
Radar Observations ◽  
Mapping Array ◽  
Lightning Initiation

Abstract On 28–29 June 2004 a multicellular thunderstorm west of Oklahoma City, Oklahoma, was probed as part of the Thunderstorm Electrification and Lightning Experiment field program. This study makes use of radar observations from the Norman, Oklahoma, polarimetric Weather Surveillance Radar-1988 Doppler, three-dimensional lightning mapping data from the Oklahoma Lightning Mapping Array (LMA), and balloon-borne vector electric field meter (EFM) measurements. The storm had a low flash rate (30 flashes in 40 min). Four charge regions were inferred from a combination of LMA and EFM data. Lower positive charge near 4 km and midlevel negative charge from 4.5 to 6 km MSL (from 0° to −6.5°C) were generated in and adjacent to a vigorous updraft pulse. Further midlevel negative charge from 4.5 to 6 km MSL and upper positive charge from 6 to 8 km (from −6.5° to −19°C) were generated later in quantity sufficient to initiate lightning as the updraft decayed. A negative screening layer was present near the storm top (8.5 km MSL, −25°C). Initial lightning flashes were between lower positive and midlevel negative charge and started occurring shortly after a cell began lofting hydrometeors into the mixed phase region, where graupel was formed. A leader from the storm’s first flash avoided a region where polarimetric radar suggested wet growth and the resultant absence of noninductive charging of those hydrometeors. Initiation locations of later flashes that propagated into the upper positive charge tracked the descending location of a polarimetric signature of graupel. As the storm decayed, electric fields greater than 160 kV m−1 exceeded the minimum threshold for lightning initiation suggested by the hypothesized runaway breakdown process at 5.5 km MSL, but lightning did not occur. The small spatial extent (≈100 m) of the large electric field may not have been sufficient to allow runaway breakdown to fully develop and initiate lightning.

Self and Directed Colloidal Assembly on Patterned Electrodes

2005 ◽  
Author(s):  
P. Bahukudumbi ◽  
Michael A. Bevan ◽  
Ali Beskok
Keyword(s):  
Electric Fields ◽  
Colloidal Particles ◽  
Colloidal Particle ◽  
Three Dimensional ◽  
Directed Assembly ◽  
Ordered Structures ◽  
Colloidal Assembly ◽  
Electrode Surfaces ◽  
External Electric Fields ◽  
Potential Energy Landscapes

Clustering of colloidal particles near an electrode surface during and after electrophoretic deposition has been reported in the literature [1, 2, 3, 4]. The aggregation of colloidal particles has made the precise assembly of two and three dimensional colloidal crystals possible. In this paper, we demonstrate the use of external electric fields to sensitively tune the interactions between colloidal particles to form ordered structures. The directed assembly of colloidal particles on patterned electrode surfaces is also investigated as a means of building three-dimensional nanostructures. Finally, a new method to map potential energy landscapes of templated substrates using a diffusing colloidal particle as a sensitive local energy probe is described.

Sign in / Sign up

Export Citation Format

Share Document