Crystal structures and formation mechanisms of boron-rich tungsten borides

2021 ◽  
Vol 104 (1) ◽  
Author(s):  
Chao Gu ◽  
Yongcheng Liang ◽  
Xuefeng Zhou ◽  
Jian Chen ◽  
Dejiang Ma ◽  
...  
Keyword(s):  
Crystal Structures ◽  
Formation Mechanisms ◽  
Tungsten Borides

scholarly journals The Crystal Structures of Molybdenum and Tungsten Borides.

1947 ◽  
Vol 1 ◽  
pp. 893-916 ◽  
Author(s):  
Roland Kiessling ◽  
Allan Wetterholm ◽  
Lars Gunnar Sillén ◽  
Annikki Linnasalmi ◽  
Pentti Laukkanen
Keyword(s):  
Crystal Structures ◽  
Tungsten Borides ◽  
And Tungsten

Pollutant Identification by Selected Area Electron Diffraction

1974 ◽  
Vol 32 ◽  
pp. 532-533
Author(s):  
R. E. Ferrell ◽  
G. G. Paulson ◽  
C. W. Walker
Keyword(s):  
Thermal Treatment ◽  
Electron Diffraction ◽  
Sample Preparation ◽  
Crystal Structures ◽  
Water Samples ◽  
Environmental Samples ◽  
Short Review ◽  
Selected Area Electron Diffraction ◽  
Multiple Component

Selected area electron diffraction (SAD) has been used successfully to determine crystal structures, identify traces of minerals in rocks, and characterize the phases formed during thermal treatment of micron-sized particles. There is an increased interest in the method because it has the potential capability of identifying micron-sized pollutants in air and water samples. This paper is a short review of the theory behind SAD and a discussion of the sample preparation employed for the analysis of multiple component environmental samples.

The dislocation structure of a 10° [110] tilt boundary in silicon

1983 ◽  
Vol 41 ◽  
pp. 114-115
Author(s):  
B. Cunningham ◽  
D.G. Ast
Keyword(s):  
Dislocation Structure ◽  
Tilt Angle ◽  
Imaging Technique ◽  
Diamond Lattice ◽  
Tilt Boundary ◽  
Formation Mechanisms ◽  
Diffraction Contrast ◽  
Lattice Fringe ◽  
Tilt Boundaries ◽  
Chemically Vapor Deposited

There have Been a number of studies of low-angle, θ < 4°, [10] tilt boundaries in the diamond lattice. Dislocations with Burgers vectors a/2<110>, a/2<112>, a<111> and a<001> have been reported in melt-grown bicrystals of germanium, and dislocations with Burgers vectors a<001> and a/2<112> have been reported in hot-pressed bicrystals of silicon. Most of the dislocations were found to be dissociated, the dissociation widths being dependent on the tilt angle. Possible dissociation schemes and formation mechanisms for the a<001> and a<111> dislocations from the interaction of lattice dislocations have recently been given.The present study reports on the dislocation structure of a 10° [10] tilt boundary in chemically vapor deposited silicon. The dislocations in the boundary were spaced about 1-3nm apart, making them difficult to resolve by conventional diffraction contrast techniques. The dislocation structure was therefore studied by the lattice-fringe imaging technique.

The Imaging of Crystal Structures and Crystal Defects

1978 ◽  
Vol 36 (3) ◽  
pp. 207-217
Author(s):  
J.M. Cowley
Keyword(s):  
Electron Microscope ◽  
Crystal Structures ◽  
Phase Contrast ◽  
Crystal Defects ◽  
Atom Density ◽  
Lack Of Information ◽  
Spatial Frequencies

The problem of "understandinq" electron microscope imaqes becomes more acute as the resolution is improved. The naive interpretation of an imaqe as representinq the projection of an atom density becomes less and less appropriate. We are increasinqly forced to face the complexities of coherent imaqinq of what are essentially phase objects. Most electron microscopists are now aware that, for very thin weakly scatterinq objects such as thin unstained bioloqical specimens, hiqh resolution imaqes are best obtained near the optimum defocus, as prescribed by Scherzer, where the phase contrast imaqe qives a qood representation of the projected potential, apart from a lack of information on the lower spatial frequencies. But phase contrast imaqinq is never simple except in idealized limitinq cases.

Transmission electron microscope studies in special ceramics

1978 ◽  
Vol 36 (1) ◽  
pp. 268-269
Author(s):  
A. Zangvil ◽  
L.J. Gauckler ◽  
G. Schneider ◽  
M. Rühle
Keyword(s):  
Phase Diagrams ◽  
Crystal Structures ◽  
Thin Foil ◽  
Limited Extent ◽  
Complex Materials ◽  
X Ray Diffraction ◽  
X Ray ◽  
Transmission Electron ◽  
Electron Microscopes ◽  
Lattice Resolution

The use of high temperature special ceramics which are usually complex materials based on oxides, nitrides, carbides and borides of silicon and aluminum, is critically dependent on their thermomechanical and other physical properties. The investigations of the phase diagrams, crystal structures and microstructural features are essential for better understanding of the macro-properties. Phase diagrams and crystal structures have been studied mainly by X-ray diffraction (XRD). Transmission electron microscopy (TEM) has contributed to this field to a very limited extent; it has been used more extensively in the study of microstructure, phase transformations and lattice defects. Often only TEM can give solutions to numerous problems in the above fields, since the various phases exist in extremely fine grains and subgrain structures; single crystals of appreciable size are often not available. Examples with some of our experimental results from two multicomponent systems are presented here. The standard ion thinning technique was used for the preparation of thin foil samples, which were then investigated with JEOL 200A and Siemens ELMISKOP 102 (for the lattice resolution work) electron microscopes.

Formation Mechanisms for Multiply Twinned Particles During Nucleation in the Au/MICA System

1975 ◽  
Vol 33 ◽  
pp. 84-85
Author(s):  
Eal H. Lee ◽  
Helmut Poppa
Keyword(s):  
Deposition Time ◽  
High Vacuum ◽  
Dark Field ◽  
Ultra High Vacuum ◽  
Formation Mechanisms ◽  
Heat Treated ◽  
Cluster Density ◽  
Diffraction Patterns ◽  
Crystal Particle ◽  
Multiply Twinned Particles

The formation of thin films of gold on mica has been studied in ultra-high vacuum (5xl0-10 torr) . The mica substrates were heat-treated for 24 hours at 375°C, cleaved, and annealed for 15 minutes at the deposition temperature of 300°C prior to deposition. An impingement flux of 3x1013 atoms cm-2 sec-1 was used. These conditions were found to give high number densities of multiple twin particles and are based on a systematic series of nucleation experiments described elsewhere. Individual deposits of varying deposition time were made and examined by bright and dark field TEM after "cleavage preparation" of highly transparent specimens. In the early stages of growth, the films generally consist of small particles which are either single crystals or multiply twinned; a strong preference for multiply twinned particles was found whenever the particle number densities were high. Fig. 1 shows the stable cluster density ns and the variation with deposition time of multiple twin particle and single crystal particle densities, respectively. Corresponding micrographs and diffraction patterns are shown in Fig. 2.

Advancing the use of Voronoi–Dirichlet polyhedra to describe interactions in organic molecular crystal structures by the example of galunisertib polymorphs

CrystEngComm ◽  
2021 ◽  
Author(s):  
Viktor N. Serezhkin ◽  
Anton V. Savchenkov
Keyword(s):  
Crystal Structures ◽  
Molecular Crystal ◽  
Noncovalent Interactions ◽  
Organic Molecular Crystal ◽  
Universal Approach ◽  
Structure Properties

The universal approach for studying structure/properties relationships shows that every polymorph of galunisertib is characterized with unique noncovalent interactions.

Crystal structures of Magnaporthe oryzae trehalose-6-phosphate synthase (MoTps1) suggest a model for catalytic process of Tps1

2019 ◽  
Vol 476 (21) ◽  
pp. 3227-3240 ◽  
Author(s):  
Shanshan Wang ◽  
Yanxiang Zhao ◽  
Long Yi ◽  
Minghe Shen ◽  
Chao Wang ◽  
...  
Keyword(s):  
Crystal Structures ◽  
Conformational Changes ◽  
Magnaporthe Oryzae ◽  
Structural Information ◽  
Complex Structure ◽  
Critical Role ◽  
Catalytic Process ◽  
Structural Basis ◽  
Salt Bridges ◽  
Terminal Domain

Trehalose-6-phosphate (T6P) synthase (Tps1) catalyzes the formation of T6P from UDP-glucose (UDPG) (or GDPG, etc.) and glucose-6-phosphate (G6P), and structural basis of this process has not been well studied. MoTps1 (Magnaporthe oryzae Tps1) plays a critical role in carbon and nitrogen metabolism, but its structural information is unknown. Here we present the crystal structures of MoTps1 apo, binary (with UDPG) and ternary (with UDPG/G6P or UDP/T6P) complexes. MoTps1 consists of two modified Rossmann-fold domains and a catalytic center in-between. Unlike Escherichia coli OtsA (EcOtsA, the Tps1 of E. coli), MoTps1 exists as a mixture of monomer, dimer, and oligomer in solution. Inter-chain salt bridges, which are not fully conserved in EcOtsA, play primary roles in MoTps1 oligomerization. Binding of UDPG by MoTps1 C-terminal domain modifies the substrate pocket of MoTps1. In the MoTps1 ternary complex structure, UDP and T6P, the products of UDPG and G6P, are detected, and substantial conformational rearrangements of N-terminal domain, including structural reshuffling (β3–β4 loop to α0 helix) and movement of a ‘shift region' towards the catalytic centre, are observed. These conformational changes render MoTps1 to a ‘closed' state compared with its ‘open' state in apo or UDPG complex structures. By solving the EcOtsA apo structure, we confirmed that similar ligand binding induced conformational changes also exist in EcOtsA, although no structural reshuffling involved. Based on our research and previous studies, we present a model for the catalytic process of Tps1. Our research provides novel information on MoTps1, Tps1 family, and structure-based antifungal drug design.

Sign in / Sign up

Export Citation Format

Share Document