Proposal for the Realization of a Single-Detector Acoustic Camera Using a Space-Coiling Anisotropic Metamaterial

2019 ◽  
Vol 11 (3) ◽  
Author(s):  
Tianxi Jiang ◽  
Qingbo He ◽  
Zhi-Ke Peng
Keyword(s):  
Single Detector ◽  
Anisotropic Metamaterial

A Simple and Inexpensive Clinical Whole Body Counter

1976 ◽  
Vol 15 (05) ◽  
pp. 248-253
Author(s):  
A. K. Basu ◽  
S. K. Guha ◽  
B. N. Tandon ◽  
M. M. Gupta ◽  
M. ML. Rehani
Keyword(s):  
The Body ◽  
Whole Body ◽  
Vitro Assay ◽  
Body Counter ◽  
Optimum Parameters ◽  
Whole Body Counter ◽  
Single Detector ◽  
Background Index ◽  
Iodide Crystal

SummaryThe conventional radioisotope scanner has been used as a whole body counter. The background index of the system is 10.9 counts per minute per ml of sodium iodide crystal. The sensitivity and derived sensitivity parameters have been evaluated and found to be suitable for clinical studies. The optimum parameters for a single detector at two positions above the lying subject have been obtained. It has been found that for the case of 131I measurement it is possible to assay a source located at any point in the body with coefficient of variation less than 5%. To add to the versatility, a fixed geometry for in-vitro counting of large samples has been obtained. The retention values obtained by the whole body counter have been found to correlate with those obtained by in-vitro assay of urine and stool after intravenous administration of 51Cr-albumin.

Immunszintigraphie mit 111ln-DTPA-markierten monoklonalen Antikörpern: Vergleich zwischen ECT und planarer Szintigraphie

1987 ◽  
Vol 26 (06) ◽  
pp. 258-262
Author(s):  
J. Happi ◽  
R. P. Baum ◽  
J. Frohn ◽  
B. Weimer ◽  
A. Halbsguth ◽  
...  
Keyword(s):  
Imaging Techniques ◽  
Diagnostic Procedures ◽  
Undifferentiated Carcinoma ◽  
Whole Body ◽  
Acquisition Time ◽  
Planar Imaging ◽  
Primary Tumors ◽  
Intraindividual Comparison ◽  
Single Detector ◽  
Increased Sensitivity

The present study was done in order to examine if the use of111ln-DTPA- labeled MAb fragments in place of 131l-labeled MAb fragments increases the sensitivity of tomographic immunoscintigraphy to reach the level of that of planar imaging techniques. In 11 patients with various primary tumors, local recurrences or metastases [colorectal carcinoma (n = 7), ovarian carcinoma (n = 2), papillary thyroid carcinoma (n = 1), undifferentiated carcinoma of the lung (n = 1)], immunoscintigraphy (IS) was carried out using 111ln-DTPA- labeled F(ab’)2 fragments of various MAbs (anti-CEA, OC 125, anti-hTG) and planar and tomographic imaging were compared intraindividually. By conventional diagnostic procedures, the presence of a tumor mass was confirmed (transmission computer tomography, ultrasound) or verified (131l whole-body scintigraphy, histology) in all cases. Immunoscintigraphy was positive in 9 out of 11 cases by ECT and in 10 out of 11 cases by planar imaging. When using 111 In-labeled MAb fragments, intraindividual comparison of ECT and planar imaging resulted in a similar sensitivity. The increased sensitivity of ECT using this tracer in contrast to 131l-labeled MAb fragments may be attributed to the fact that the physical properties of111 In are much more suitable for the gamma cameras most commonly used (single detector, 3/8” crystal); using 111 In-labeled MAb fragments, count rates sufficient for ECT can be obtained within a reasonable acquisition time. This allows to combine IS with the advantages of ECT regarding tumour localization and prevention of artefacts due to superposition of background.

PRESSURE AMPLITUDES OF SEISMIC SIGNALS IN OFFSHORE LOUISIANA

Geophysics ◽  
1977 ◽  
Vol 42 (1) ◽  
pp. 3-16
Author(s):  
M. E. Arnold
Keyword(s):  
Field Tests ◽  
Signal Amplitude ◽  
Test Area ◽  
Seismic Signals ◽  
Code Generators ◽  
Single Detector ◽  
First Arrival ◽  
Reflected Signal ◽  
Refracted Waves ◽  
Seismic Lines

Pressure amplitudes were determined for various kinds of seismic signals observed on special test records obtained during field tests conducted along a 14,000-ft seismic lines in Eugene Island Block 184, offshore Louisiana. Vibrators attached to a Seismograph Service Corp. (SSC) boat generated swept‐frequency and monofrequency signals. Signals from detectors on a streamer cable towed by the boat were recorded by an SSC recording system. Signals from a vertical spread of detectors were recorded by a DFS/9000 recorder on the Transco 184 platform centrally located in the test area. Location of the boat was determined by analysis of time relations of signals from responders located at established positions some distance from the test area. Clock times from manually referenced timing code generators were recorded by both the SSC and DFS recorders to permit synchronization between separately recorded signals. The signals analyzed were separated into three classes: [Formula: see text] includes direct and refracted waves; [Formula: see text] consists of primary reflections; and [Formula: see text] includes signals diffracted from scatterers. The average level of first‐arrival signal [Formula: see text] and reflected signal [Formula: see text] for frequency sets 25, 40, 42.2, 50, and 70.4 Hz in the range of 1414 and 2143 ft, which encompasses streamer cable single‐detector groups, is 337 and 29.6 microbars, respectively. The amplitude of signals [Formula: see text], believed to be diffracted from the contact between key reflectors and a salt dome, ranges from 13 to 20 microbars and is 10 to 100 times the amplitudes of towing and ambient noise, respectively. The observed decay of first‐arrival signal amplitude is approximately proportional to the square root of range distance, or about 2 dB/1000 ft. The observed decay of reflected signal amplitude with range distance is approximately 1 dB/1000 ft.

Short-Length and High-Aperture-Efficiency Horn Antenna Using Low-Loss Bulk Anisotropic Metamaterial

2015 ◽  
Vol 14 ◽  
pp. 1642-1645 ◽  
Author(s):  
Yingran He ◽  
Ning Ding ◽  
Lingfei Zhang ◽  
Wenjing Zhang ◽  
Biao Du
Keyword(s):  
Horn Antenna ◽  
Short Length ◽  
Low Loss ◽  
Aperture Efficiency ◽  
Anisotropic Metamaterial

FDTD Simulation on the Interaction Between Gaussian Beam and Biaxial Anisotropic Metamaterial Slabs

2007 ◽  
Vol 29 (2) ◽  
pp. 167-178 ◽  
Author(s):  
Maoyan Wang ◽  
Jian Wu ◽  
Jun Xu ◽  
Debiao Ge ◽  
Hailong Li ◽  
...  
Keyword(s):  
Gaussian Beam ◽  
Fdtd Simulation ◽  
Anisotropic Metamaterial

Rigorous study of propagation in metallic circular waveguide filled with anisotropic metamaterial

2017 ◽  
Vol 9 (4) ◽  
pp. 805-813 ◽  
Author(s):  
Hedi Sakli ◽  
Mohamed Yahia ◽  
Wyssem Fathallah ◽  
Jun Wu Tao ◽  
Taoufik Aguili
Keyword(s):  
Computation Time ◽  
Circular Waveguide ◽  
Transverse Magnetic ◽  
Higher Order Modes ◽  
Anisotropic Metamaterials ◽  
Matching Technique ◽  
Theoretical Predictions ◽  
Rigorous Study ◽  
Circular Waveguides ◽  
Anisotropic Metamaterial

This paper presents an extension of the formulation of wave propagation in transverse electric (TE) and transverse magnetic (TM) modes in the case of metallic circular waveguides filled with anisotropic metamaterials. The determined higher-order modes have been analyzed and exploited to the design of filters. Among the particularities of anisotropic material, the backward waves can propagate below the cut-off frequency. The numerical results for TE and TM modes have been compared with theoretical predictions. Good agreements were obtained. We analyzed a periodic structure containing waveguides filled with anisotropic metamaterial using the mode-matching technique. By using modal analysis, our approach reduced considerably the computation time compared to HFSS.

Sign in / Sign up

Export Citation Format

Share Document