High-Frequency Effect Due to the Axial Drift Velocity of a Plasma Column

1966 ◽  
Vol 149 (1) ◽  
pp. 131-140 ◽  
Author(s):  
A. M. Messiaen ◽  
P. E. Vandenplas
Keyword(s):  
Drift Velocity ◽  
Plasma Column ◽  
High Frequency ◽  
Frequency Effect

A method to quantify hand-transmitted vibration exposure based on the biodynamic stress concept

2007 ◽  
Vol 221 (8) ◽  
pp. 847-861 ◽  
Author(s):  
R G Dong ◽  
D E Welcome ◽  
J Z Wu
Keyword(s):  
Experimental Data ◽  
High Frequency ◽  
Practical Method ◽  
The Other ◽  
Equivalent Model ◽  
Frequency Effect ◽  
Vibration Exposure ◽  
Stress Cycle ◽  
Vibration Induced White Finger ◽  
Frequency Weightings

This study generally hypothesized that the vibration-induced biodynamic stress and number of its cycles in a substructure of the hand-arm system play an important role in the development of vibration-induced disorders in the substructure. As the first step to test this hypothesis, the specific aims of this study were to develop a practical method to quantify the biodynamic stress-cycle measure, to compare it with ISO-weighted and unweighted accelerations, and to assess its potential for applications. A mechanical-equivalent model of the system was established using reported experimental data. The model was used to estimate the average stresses in the fingers and palm. The frequency weightings of the stresses in these substructures were derived using the proposed stress-cycle measure. This study found the frequency dependence of the average stress distributed in the fingers is different from that in the palm. Therefore, this study predicted that the frequency dependencies of finger disorders could also be different from those of the disorders in the palm, wrist, and arms. If vibration-induced white finger (VWF) is correlated better with unweighted acceleration than with ISO-weighted acceleration, the biodynamic stress distributed in the fingers is likely to play a more important role in the development of VWF than is the biodynamic stress distributed in the other substructures of the hand-arm system. The results of this study also suggest that the ISO weighting underestimates the high-frequency effect on the finger disorder development but it may provide a reasonable risk assessment of the disorders in the wrist and arm.

Nonword repetition and levels of abstraction in phonological knowledge

2006 ◽  
Vol 27 (4) ◽  
pp. 577-581 ◽  
Author(s):  
Benjamin Munson
Keyword(s):  
High Frequency ◽  
Low Frequency ◽  
Nonword Repetition ◽  
Chronological Age ◽  
Frequency Effect ◽  
Vocabulary Size ◽  
Levels Of Abstraction ◽  
Opposite Pattern ◽  
The Difference ◽  
Restriction Of Range

Susan Gathercole's Keynote Article (2006) is an impressive summary of the literature on nonword repetition and its relationship to word learning and vocabulary size. When considering research by Mary Beckman, Jan Edwards, and myself, Gathercole speculates that our finding of a stronger relationship between vocabulary measures and repetition accuracy for low-frequency sequences than for high-frequency sequences is due to differences in the range of the two measures. In our work on diphone repetition (e.g., Edwards, Beckman, & Munson, 2004; Munson, Edwards, & Beckman, 2005) we tried to increase the range in our dependent measures by coding errors on a finer grained scale than simple correct/incorrect scoring would allow. Moreover, restriction of range does not appear to be the driving factor in the relationship between vocabulary size and the difference between high- and low-frequency sequence repetition accuracy (what we call the frequency effect) in at least one of our studies (Munson et al., 2005). When the children with the 50 lowest mean accuracy scores for high-frequency sequences were examined, vocabulary size accounted for 10.5% of the variance in the frequency effect beyond what was accounted for by chronological age. When the 50 children with the highest mean accuracy scores for high-frequency sequences were examined (a group in which the range of high-frequency accuracy scores was more compressed, arguably reflecting ceiling effects), an estimate of vocabulary size accounted for only 6.9% of the frequency effect beyond chronological age. The associated β coefficient was significant only at the α<0.08 level. This is the opposite pattern than Gathercole's argument would predict.

Correlation analysis of radio-auroral scatter signals

1970 ◽  
Vol 48 (14) ◽  
pp. 1716-1723 ◽  
Author(s):  
F. H. Palmer ◽  
D. R. Moorcroft
Keyword(s):  
Correlation Analysis ◽  
Drift Velocity ◽  
Scattered Field ◽  
High Frequency ◽  
Very High Frequency ◽  
Drift Speed ◽  
Scale Size ◽  
Spaced Antennas ◽  
Very High ◽  
East West

Very high frequency radio-auroral scatter signals are regularly observed on an Ottawa–London (Ontario) backscatter circuit operating at 40.35 MHz. For three of these events the scale size and drift velocity of the scattered field at the receiving site were determined by a correlation analysis of the signals received at spaced antennas. The overall east–west extent of the scattering regions was determined from the scale-size measurements. At least two types of event were observed. One type results from scattering by extended regions with horizontal dimensions greater than 200 km and having minimum drift velocities of a few hundred m/s. The second type of event results from simultaneous scattering by a number of independent regions, each having its own drift speed and direction. These regions have drift velocities in excess of 1 km/s and horizontal dimensions often less than 30 km.

Development of a New Fatigue Testing Machine for High Frequency Fatigue Damage Assessment

2013 ◽  
Author(s):  
Naoki Osawa ◽  
Tetsuya Nakamura ◽  
Norio Yamamoto ◽  
Junji Sawamura
Keyword(s):  
High Frequency ◽  
High Speed ◽  
Fatigue Testing ◽  
Low Cost ◽  
Plate Thickness ◽  
Testing Machine ◽  
Fatigue Tests ◽  
Frequency Effect ◽  
Wave Load ◽  
Out Of Plane

A new simple fatigue testing machine, which can carry out fast and low-cost fatigue tests of welded joints subject to wave with high frequency vibration, has been developed. This machine is designed for plate bending type fatigue tests, and wave load is applied by using motors with eccentric mass. Springing vibration is superimposed by attaching an additional vibrator to the test specimen, and whipping vibration is superimposed by an intermittent hammering. Fatigue tests which simulate springing and whipping by a conventional servo-type fatigue testing machines are very expensive and use a large amount of electricity. If one uses these conventional machines, it is difficult to simulate superimposed stress wave forms at high speed, and it takes long hours of testing to examine the high frequency effect. In contrast, it is found that fatigue tests can be carried out in fast, i.e. waves with 10Hz or higher frequency for out-of-plane gusset welded joint specimens with 12mm plate thickness by using the developed machine. The electricity to be used for fatigue tests could be minimal, for example one thousandth of that needed for conventional machines. These results demonstrate the superiority of the developed machine.

Numerical simulation of active separation control by a synthetic jet

2007 ◽  
Vol 574 ◽  
pp. 25-58 ◽  
Author(s):  
JULIEN DANDOIS ◽  
ERIC GARNIER ◽  
PIERRE SAGAUT
Keyword(s):  
Numerical Simulation ◽  
High Frequency ◽  
Velocity Ratio ◽  
Low Frequency ◽  
Separated Flow ◽  
Synthetic Jet ◽  
Frequency Separation ◽  
Frequency Effect ◽  
Stream Velocity ◽  
Mean Velocity

Direct numerical simulation (DNS) and large-eddy simulation (LES) are carried out to investigate the frequency effect of zero-net-mass-flux forcing (synthetic jet) on a generic separated flow. The selected test case is a rounded ramp at a Reynolds number based on the step height of 28 275. The incoming boundary layer is fully turbulent withRθ=1410. The whole flow in the synthetic jet cavity is computed to ensure an accurate description of the actuator effect on the flow field. In a first step, DNS is used to validate LES of this particular flow. In a second step, the effect of a synthetic jet at two reduced frequencies of 0.5 and 4 (based on the separation length of the uncontrolled case and the free-stream velocity) is investigated using LES. It is demonstrated that, with a proper choice of the oscillating frequency, separation can be drastically reduced for a velocity ratio between the jet and the flow lower than one. The low frequency is close to the natural vortex shedding frequency. Two different modes of the synthetic jet have been identified. Avorticity-dominated modeis observed in the low-frequency forcing case for which the separation length is reduced by 54%, while anacoustic-dominated modeis identified in the high-frequency forcing case for which the separation length is increased by 43%. The decrease of the separation length in the low-frequency forcing case is correlated with an increase of the turbulent kinetic energy level and consequently with an increase of the entrainment in the separated zone. A linear inviscid stability analysis shows that the increase of the separation length in the high-frequency forcing case is due to a modification of the mean velocity profile suggested by Stanek and coworkers. The result is a lower amplification of the perturbations and consequently, a lower entrainment into the mixing layer. To our knowledge, it is the first time that Stanek's hypothesis has been assessed, thanks to numerical simulations of fully turbulent flow.

Biodynamic Response of Human Fingers in a Power Grip Subjected to a Random Vibration

2004 ◽  
Vol 126 (4) ◽  
pp. 447-457 ◽  
Author(s):  
R. G. Dong ◽  
D. E. Welcome ◽  
T. W. McDowell ◽  
J. Z. Wu
Keyword(s):  
High Frequency ◽  
Random Vibration ◽  
Grip Force ◽  
Frequency Effect ◽  
Human Hand ◽  
Vibration Exposure ◽  
Power Grip ◽  
Coupling Force ◽  
Frequency Weighting ◽  
Male Subjects

Background. Knowledge of the biodynamic response (BR) of the human hand-arm system is an important part of the foundation for the measurement and assessment of hand-transmitted vibration exposure. This study investigated the BR of human fingers in a power grip subjected to a random vibration. Method. Ten male subjects were used in the experiment. Each subject applied three coupling actions to a simulated tool handle at three different finger grip force levels. Results and Conclusions. The BR is practically independent of the hand coupling actions for frequencies at or above 100 Hz. Above 50 Hz, the BR is correlated to finger and hand sizes. Increasing the finger coupling force significantly increases the BR. Therefore, hand forces should be measured and used when assessing hand-transmitted vibration exposure. The results also show that under a constant-velocity vibration, the finger vibration power absorption at frequencies above 200 Hz is approximately twice that at frequencies below 100 Hz. This suggests that the frequency weighting specified in the current ISO 5349-1 (2001) may underestimate the high frequency effect on vibration-induced finger disorders.

Sign in / Sign up

Export Citation Format

Share Document