scholarly journals Underway velocity measurements in the Alderney Race: towards a three-dimensional representation of tidal motions

Author(s):  
Alexei Sentchev ◽  
Thinh Duc Nguyen ◽  
Lucille Furgerot ◽  
Pascal Bailly du Bois

The Alderney Race, located northwest of the Cotentin Peninsula (France), is a site with high tidal-stream energy potential. Circulation through the Alderney Race is complex, with current speed exceeding 3 m s −1 at neap tide. Towed acoustic Doppler current profiler (ADCP) measurements and static point velocity measurements were performed in July 2018 focusing on assessment of circulation and vertical structure of tidal currents. Transect surveys revealed peculiar features of local dynamics such as change in location of the tidal jet on ebb and flood flow. The spatial expanse of the tidal jet was quantified and regions with largely sheared or nearly homogeneous velocity distributions were identified on the cross-sections. Velocity profiles acquired along the cross-sections were accurately characterized using a power law. The spatial variability of the power-law exponent α was found to be large and correlated with the tidal conditions. The largest variation in profile shape was observed in the northern sector and assumed to be generated by the current interaction with a bathymetric constriction. The velocity profiles were found to vary from highly sheared on flood flow to nearly homogeneous on ebb flow, with corresponding range of power-law exponent α variation from 6 to 14. In the southern sector, over a relatively smooth bathymetry, the velocity profile shape was accurately approximated using the 1/7 power law with a range of variation of α from 6.5 to 8, with respect to the tidal conditions. To our knowledge, this is the largest field survey done using towed ADCP and the results could represent a significant advance in tidal site characterization and provide advanced information to turbine developers. This article is part of the theme issue ‘New insights on tidal dynamics and tidal energy harvesting in the Alderney Race'.

Universe ◽  
2019 ◽  
Vol 5 (1) ◽  
pp. 36
Author(s):  
Bryn Knight ◽  
Liliana Caballero

Neutron captures are likely to occur in the crust of accreting neutron stars (NSs). Their rate depends on the thermodynamic state of neutrons in the crust. At high densities, neutrons are degenerate. We find degeneracy corrections to neutron capture rates off nuclei, using cross sections evaluated with the reaction code TALYS. We numerically integrate the relevant cross sections over the statistical distribution functions of neutrons at thermodynamic conditions present in the NS crust. We compare our results to analytical calculations of these corrections based on a power-law behavior of the cross section. We find that although an analytical integration can simplify the calculation and incorporation of the results for nucleosynthesis networks, there are uncertainties caused by departures of the cross section from the power-law approach at energies close to the neutron chemical potential. These deviations produce non-negligible corrections that can be important in the NS crust.


1971 ◽  
Vol 32 (1) ◽  
pp. 7-9 ◽  
Author(s):  
J. Galin ◽  
D. Guerreau ◽  
M. Lefort ◽  
X. Tarrago

The work of multilayer glass structures for central and eccentric compression and bending are considered. The substantiation of the chosen research topic is made. The description and features of laminated glass for the structures investigated, their characteristics are presented. The analysis of the results obtained when testing for compression, compression with bending, simple bending of models of columns, beams, samples of laminated glass was made. Overview of the types and nature of destruction of the models are presented, diagrams of material operation are constructed, average values of the resistance of the cross-sections of samples are obtained, the table of destructive loads is generated. The need for development of a set of rules and guidelines for the design of glass structures, including laminated glass, for bearing elements, as well as standards for testing, rules for assessing the strength, stiffness, crack resistance and methods for determining the strength of control samples is emphasized. It is established that the strength properties of glass depend on the type of applied load and vary widely, and significantly lower than the corresponding normative values of the strength of heat-strengthened glass. The effect of the connecting polymeric material and manufacturing technology of laminated glass on the strength of the structure is also shown. The experimental values of the elastic modulus are different in different directions of the cross section and in the direction perpendicular to the glass layers are two times less than along the glass layers.


1991 ◽  
Vol 56 (2) ◽  
pp. 334-343
Author(s):  
Ondřej Wein

Analytical solutions are given to a class of unsteady one-dimensional convective-diffusion problems assuming power-law velocity profiles close to the transport-active surface.


2021 ◽  
Vol 2021 (1) ◽  
Author(s):  
Roman N. Lee ◽  
Alexey A. Lyubyakin ◽  
Vyacheslav A. Stotsky

Abstract Using modern multiloop calculation methods, we derive the analytical expressions for the total cross sections of the processes e−γ →$$ {e}^{-}X\overline{X} $$ e − X X ¯ with X = μ, γ or e at arbitrary energies. For the first two processes our results are expressed via classical polylogarithms. The cross section of e−γ → e−e−e+ is represented as a one-fold integral of complete elliptic integral K and logarithms. Using our results, we calculate the threshold and high-energy asymptotics and compare them with available results.


Author(s):  
Georges Griso ◽  
Larysa Khilkova ◽  
Julia Orlik ◽  
Olena Sivak

AbstractIn this paper, we study the asymptotic behavior of an $\varepsilon $ ε -periodic 3D stable structure made of beams of circular cross-section of radius $r$ r when the periodicity parameter $\varepsilon $ ε and the ratio ${r/\varepsilon }$ r / ε simultaneously tend to 0. The analysis is performed within the frame of linear elasticity theory and it is based on the known decomposition of the beam displacements into a beam centerline displacement, a small rotation of the cross-sections and a warping (the deformation of the cross-sections). This decomposition allows to obtain Korn type inequalities. We introduce two unfolding operators, one for the homogenization of the set of beam centerlines and another for the dimension reduction of the beams. The limit homogenized problem is still a linear elastic, second order PDE.


2018 ◽  
Vol 32 (7) ◽  
pp. 866-872 ◽  
Author(s):  
Swagat Patnaik ◽  
Basudev Biswal ◽  
Dasika Nagesh Kumar ◽  
Bellie Sivakumar

2009 ◽  
Vol 24 (02n03) ◽  
pp. 450-453
Author(s):  
◽  
T. SKORODKO ◽  
M. BASHKANOV ◽  
D. BOGOSLOWSKY ◽  
H. CALÉN ◽  
...  

The two-pion production in pp-collisions has been investigated in exclusive measurements from threshold up to Tp = 1.36 GeV . Total and differential cross sections have been obtained for the channels pnπ+π0, ppπ+π-, ppπ0π0 and also nnπ+π+. For intermediate incident energies Tp > 1 GeV , i.e. in the region, which is beyond the Roper excitation but at the onset of ΔΔ excitation the total ppπ0π0 cross section falls behind theoretical predictions by as much as an order of magnitude near 1.2 GeV, whereas the nnπ+π+ cross section is a factor of five larger than predicted. A model-unconstrained isospin decompostion of the cross section points to a significant contribution of an isospin 3/2 resonance other than the Δ(1232). As a possible candidate the Δ(1600) is discussed.


Sign in / Sign up

Export Citation Format

Share Document