scholarly journals Coordinated single-phase control scheme for voltage unbalance reduction in low voltage network

2017 ◽  
Vol 375 (2100) ◽  
pp. 20160308 ◽  
Author(s):  
Deepak Pullaguram ◽  
Sukumar Mishra ◽  
Nilanjan Senroy
Keyword(s):  
Distribution Systems ◽  
Single Phase ◽  
Reactive Power ◽  
Low Voltage ◽  
Power Sharing ◽  
Voltage Unbalance ◽  
Line Configuration ◽  
Control Scheme ◽  
Multi Agent ◽  
Proper Power

Low voltage (LV) distribution systems are typically unbalanced in nature due to unbalanced loading and unsymmetrical line configuration. This situation is further aggravated by single-phase power injections. A coordinated control scheme is proposed for single-phase sources, to reduce voltage unbalance. A consensus-based coordination is achieved using a multi-agent system, where each agent estimates the averaged global voltage and current magnitudes of individual phases in the LV network. These estimated values are used to modify the reference power of individual single-phase sources, to ensure system-wide balanced voltages and proper power sharing among sources connected to the same phase. Further, the high X / R ratio of the filter, used in the inverter of the single-phase source, enables control of reactive power, to minimize voltage unbalance locally. The proposed scheme is validated by simulating a LV distribution network with multiple single-phase sources subjected to various perturbations. This article is part of the themed issue ‘Energy management: flexibility, risk and optimization’.

scholarly journals A Novel Voltage Control Scheme for Low-Voltage DC Distribution Systems Using Multi-Agent Systems

Energies ◽  
2017 ◽  
Vol 10 (1) ◽  
pp. 41 ◽  
Author(s):  
Trinh Hai ◽  
Hector Cho ◽  
Il-Yop Chung ◽  
Hyun-Koo Kang ◽  
Jintae Cho ◽  
...  
Keyword(s):  
Distribution Systems ◽  
Low Voltage ◽  
Voltage Control ◽  
Multi Agent Systems ◽  
Agent Systems ◽  
Dc Distribution ◽  
Control Scheme ◽  
Multi Agent

Improved Load Sharing Control Techniques for Inverters used in a Microgrid

2009 ◽  
Vol 10 (1) ◽  
Author(s):  
Wei Yao ◽  
Zhaoming Qian
Keyword(s):  
Steady State ◽  
Transient Response ◽  
Single Phase ◽  
Load Sharing ◽  
Power Sharing ◽  
Experimental Results ◽  
Control Technique ◽  
Transient Performance ◽  
Control Techniques ◽  
Control Scheme

In this paper, an improved load sharing control scheme is presented, which is able to improve the transient response and power sharing accuracy of parallel-connected inverters used in microgrid. It also shows how the improved droop method can be easily adapted to account for the operation of parallel-connected inverters, providing good performance under the variation and disturbance of loads, as well as achieving good steady-state objectives and transient performance. Two DSP-based single-phase Microgrid inverters are designed and implemented. Simulation and experimental results are all reported, confirming the validity of the proposed control technique.

Implementation of Single-Phase Two-Switch Midpoint Unidirectional Multilevel Converter System

2018 ◽  
Vol 19 (4) ◽  
Author(s):  
Peethala Rajiv Roy ◽  
P. Parthiban ◽  
B. Chitti Babu
Keyword(s):  
Single Phase ◽  
Pulse Width Modulation ◽  
Low Voltage ◽  
Supply Voltage ◽  
Harmonic Distortion ◽  
Input Voltage ◽  
Open Loop ◽  
Current Control ◽  
Control Technique ◽  
Control Scheme

Abstract This paper deals with implementation of a single-phase three level converter system under low voltage condition. The frequency of the switches is made constant and involves change in ${t_{on}}$ and ${t_{off}}$ duration. For this condition the pulse width modulation control scheme for a single phase three level rectifier is developed to improve the power quality. The hysteresis current control technique is adopted to bring forth three-level PWM on the dc side of the bridge rectifier and to achieve high power factor and low harmonic distortion. Based on the proposed control scheme, the line current is driven to follow the sinusoidal current command which is in phase with the supply voltage. By using three-level voltage pattern the blocking voltage of each power device is clamped to half of the dc link voltage. The simulation and experimental results of 20W converter under low input voltage condition are shown to verify the circuit performance. Open loop simulation and hardware tests are implemented by applying a low voltage of 15 V(rms) on the input side.

scholarly journals Fuzzy Logic Control for Low-Voltage Ride-Through Single-Phase Grid-Connected PV Inverter

Energies ◽  
2019 ◽  
Vol 12 (24) ◽  
pp. 4796 ◽  
Author(s):  
Eyad Radwan ◽  
Mutasim Nour ◽  
Emad Awada ◽  
Ali Baniyounes
Keyword(s):  
Fuzzy Logic ◽  
Output Power ◽  
Single Phase ◽  
Reactive Power ◽  
Low Voltage ◽  
Operating Conditions ◽  
Pv System ◽  
Utilization Factor ◽  
Low Voltage Ride Through ◽  
Active And Reactive Power

This paper presents a control scheme for a photovoltaic (PV) system that uses a single-phase grid-connected inverter with low-voltage ride-through (LVRT) capability. In this scheme, two PI regulators are used to adjust the power angle and voltage modulation index of the inverter; therefore, controlling the inverter’s active and reactive output power, respectively. A fuzzy logic controller (FLC) is also implemented to manage the inverter’s operation during the LVRT operation. The FLC adjusts (or de-rates) the inverter’s reference active and reactive power commands based on the grid voltage sag and the power available from the PV system. Therefore, the inverter operation has been divided into two modes: (i) Maximum power point tracking (MPPT) during the normal operating conditions of the grid, and (ii) LVRT support when the grid is operating under faulty conditions. In the LVRT mode, the de-rating of the inverter active output power allows for injection of some reactive power, hence providing voltage support to the grid and enhancing the utilization factor of the inverter’s capacity. The proposed system was modelled and simulated using MATLAB Simulink. The simulation results showed good system performance in response to changes in reference power command, and in adjusting the amount of active and reactive power injected into the grid.

scholarly journals An Improved Centralized Control Structure for Compensation of Voltage Distortions in Inverter-Based Microgrids

Energies ◽  
2018 ◽  
Vol 11 (7) ◽  
pp. 1862 ◽  
Author(s):  
Morteza Afrasiabi ◽  
Esmaeel Rokrok
Keyword(s):  
Distribution System ◽  
Distribution Systems ◽  
Hierarchical Control ◽  
Control Level ◽  
Measurement Unit ◽  
Centralized Control ◽  
Secondary Control ◽  
Voltage Unbalance ◽  
Control Scheme ◽  
Centralized Controller

Recently, increased use of non-linear loads has intensified the harmonic distortion and voltage unbalance in distribution systems. Inverter Based Distributed Generators (IBDGs) can be employed as distributed compensators to improve the power quality, as well as to supply distribution systems. In this paper, an enhanced hierarchical control scheme for the compensation of voltage disturbance in an AC Micro Grid (MG) that includes of two control levels is proposed. The secondary control level is performed by a centralized controller. Data of voltage harmonics and voltage unbalance at the MG Sensitive Load Bus (SLB) is sent to the centralized controller by a measurement unit. A general case with a combined voltage harmonic and unbalance distortion is considered. The compensation coefficients for IBDG units are computed by the centralized controller, and reference commands are sent to the local controllers of the IBDG units that act as a primary level of control. In the secondary control level, harmonic analysis is performed for the MG in order to provide a guide for properly assigning the harmonics and unbalance compensation priorities to IBDGs at different locations in the distribution system. Some buses have more participation in exciting the MG resonance modes; therefore, larger harmonic compensation factors are considered for the IBDGs that are near to these buses. For other IBDGs, the voltage unbalance compensation factor is selected bigger. The control system of the IBDGs mainly includes a current controller, a virtual damping resistor loop, and a load compensation block. Effectiveness of the proposed control scheme is demonstrated through simulation studies.

Sign in / Sign up

Export Citation Format

Share Document