scholarly journals Comparison of Phosphorus Extraction from Sludge Incinerated Bottom Ash and Sludge Incinerated Fly Ash Using Sulfuric Acid

2020 ◽  
Vol 37 (9) ◽  
pp. 637-645
Author(s):  
Lingfang Xu ◽  
Ying Chen ◽  
Min Liu ◽  
Xiong Fu
Keyword(s):  
Sulfuric Acid ◽  
Fly Ash ◽  
Bottom Ash ◽  
Phosphorus Extraction

Characterization of lead-bearing phases in municipal waste combustor fly ash

1996 ◽  
Vol 54 ◽  
pp. 516-517
Author(s):  
L. L. Sutter ◽  
G. R. Dewey ◽  
J. F. Sandell
Keyword(s):  
Fly Ash ◽  
Bottom Ash ◽  
Municipal Waste ◽  
Primary Concern ◽  
Leaching Behavior ◽  
Waste Combustion ◽  
Lead And Cadmium ◽  
Lead Speciation ◽  
Accepted Practice

Municipal waste combustion typically involves both energy recovery as well as volume reduction of municipal solid waste prior to landfilling. However, due to environmental concerns, municipal waste combustion (MWC) has not been a widely accepted practice. A primary concern is the leaching behavior of MWC ash when it is stored in a landfill. The ash consists of a finely divided fly ash fraction (10% by volume) and a coarser bottom ash (90% by volume). Typically, MWC fly ash fails tests used to evaluate leaching behavior due to high amounts of soluble lead and cadmium species. The focus of this study was to identify specific lead bearing phases in MWC fly ash. Detailed information regarding lead speciation is necessary to completely understand the leaching behavior of MWC ash.

scholarly journals Ternary Mixes of Self-Compacting Concrete with Fly Ash and Municipal Solid Waste Incinerator Bottom Ash

2020 ◽  
Vol 11 (1) ◽  
pp. 107
Author(s):  
B. Simões ◽  
P. R. da Silva ◽  
R. V. Silva ◽  
Y. Avila ◽  
J. A. Forero
Keyword(s):  
Fly Ash ◽  
Municipal Solid Waste ◽  
Solid Waste ◽  
Bottom Ash ◽  
Chloride Diffusion ◽  
Waste Incinerator ◽  
Chloride Diffusion Coefficient ◽  
Municipal Solid Waste Incinerator ◽  
Self Compacting Concrete ◽  
Solid Waste Incinerator

This study aims to evaluate the potential of incorporating fly ash (FA) and municipal solid waste incinerator bottom ash (MIBA) as a partial substitute of cement in the production of self-compacting concrete mixes through an experimental campaign in which four replacement levels (i.e., 10% FA + 20% MIBA, 20% FA + 10% MIBA, 20% FA + 40% MIBA and 40% FA + 20% MIBA, apart from the reference concrete) were considered. Compressive and tensile strengths, Young’s modulus, ultra-sonic pulse velocity, shrinkage, water absorption by immersion, chloride diffusion coefficient and electrical resistivity were evaluated for all concrete mixes. The results showed a considerable decline in both mechanical and durability-related performances of self-compacting concrete with 60% of substitution by MIBA mainly due to the aluminium corrosion chemical reaction. However, workability properties were not significantly affected, exhibiting values similar to those of the control mix.

scholarly journals Reactivity of Ground Coal Bottom Ash to Be Used in Portland Cement

J ◽  
2021 ◽  
Vol 4 (3) ◽  
pp. 223-232
Author(s):  
Esperanza Menéndez ◽  
Cristina Argiz ◽  
Miguel Ángel Sanjuán
Keyword(s):  
Fly Ash ◽  
Coal Fly Ash ◽  
Bottom Ash ◽  
Blended Cement ◽  
Coal Ash ◽  
Pozzolanic Reaction ◽  
Natural Sand ◽  
Coal Bottom Ash ◽  
Novel Material ◽  
Pozzolanic Properties

Ground coal bottom ash is considered a novel material when used in common cement production as a blended cement. This new application must be evaluated by means of the study of its pozzolanic properties. Coal bottom ash, in some countries, is being used as a replacement for natural sand, but in some others, it is disposed of in a landfill, leading thus to environmental problems. The pozzolanic properties of ground coal bottom ash and coal fly ash cements were investigated in order to assess their pozzolanic performance. Proportions of coal fly ash and ground coal bottom ash in the mixes were 100:0, 90:10, 80:20, 50:50, 0:100. Next, multicomponent cements were formulated using 10%, 25% or 35% of ashes. In general, the pozzolanic performance of the ground coal bottom ash is quite similar to that of the coal fly ash. As expected, the pozzolanic reaction of both of them proceeds slowly at early ages, but the reaction rate increases over time. Ground coal bottom ash is a promising novel material with pozzolanic properties which are comparable to that of coal fly ashes. Then, coal bottom ash subjected to an adequate mechanical grinding is suitable to be used to produce common coal-ash cements.

Microstructure and Mechanical Properties of Ambiently-Cured Blended Coal Ash-Based Geopolymer Concrete

2016 ◽  
Vol 857 ◽  
pp. 400-404
Author(s):  
Tian Yu Xie ◽  
Togay Ozbakkaloglu
Keyword(s):  
Mechanical Properties ◽  
Experimental Study ◽  
Compressive Strength ◽  
Fly Ash ◽  
Bottom Ash ◽  
Coal Ash ◽  
Geopolymer Concrete ◽  
Mass Ratio ◽  
Blended Coal ◽  
Microstructure And Mechanical Properties

This paper presents the results of an experimental study on the behavior of fly ash-, bottom ash-, and blended fly and bottom ash-based geopolymer concrete (GPC) cured at ambient temperature. Four bathes of GPC were manufactured to investigate the influence of the fly ash-to-bottom ash mass ratio on the microstructure, compressive strength and elastic modulus of GPC. All the results indicate that the mass ratio of fly ash-to-bottom ash significantly affects the microstructure and mechanical properties of GPCs

Manufacture of Non-Toxic Lava from Recovery of the Incineration Ash by Plasma Fusing Technology

2011 ◽  
Vol 194-196 ◽  
pp. 2365-2375
Author(s):  
Jai Houng Leu ◽  
Li Fong Wu ◽  
Ay Su
Keyword(s):  
Heavy Metals ◽  
Fly Ash ◽  
Dissolution Rate ◽  
Bottom Ash ◽  
Reduction Ratio ◽  
National Standards ◽  
Toxic Heavy Metals ◽  
Mixture Ratio ◽  
Sustainable Operation ◽  
The Stability

This research investigated and explored the overall technical and legal suggestions on mixed ash (bottom ash + fly ash) from the first BOT(built-operation then transfer) incineration plant in south Taoyuan of Taiwan, with the hope of serving as the reference for treating ash from urban refuse incinerator and making sustainable operation management policies in Taiwan. Both bottom ash and fly ash contain high-content harmful metals like lead, chrome, and cadmium, with the lead content exceeding standard value. Plasma fusing technology may effectively settle toxic heavy metals and reduce their dissolution rate. The results show that the increase in percentage of bottom ash could maintain post-fusing strength and produce solidification effect, but this reduced the stability of toxic heavy metals and raised their dissolution rate. Suitable mixture ratio of bottom ash and fly ash was 2:1, volume reduction ratio 0.349, and weight reduction ratio 0.4936. The mixture was fulvous and dense with gloss and adequate strength. The dissolution test of lava products complied with national standards, and they might be used for recycling aggregates and solidifying cement.

Sign in / Sign up

Export Citation Format

Share Document