Temperature Responses of the Cactus Dodger, Cacama valvata (Homoptera, Cicadadae)

1972 ◽  
Vol 45 (3) ◽  
pp. 238-246 ◽  
Author(s):  
James Edward Heath ◽  
Peter Julian Wilkin ◽  
Maxine S. Heath
Keyword(s):  
Temperature Responses

Evaluation of the temperature responses in colorimetric measurements of chemisorption enthalpies on metal films

1979 ◽  
Vol 44 (12) ◽  
pp. 3425-3433 ◽  
Author(s):  
Miloš Smutek ◽  
Slavoj Černý
Keyword(s):  
Heat Evolution ◽  
Adiabatic Temperature ◽  
Time Curve ◽  
Model Calculations ◽  
Colorimetric Measurements ◽  
Reliable Procedure ◽  
Temperature Responses ◽  
Temperature Time ◽  
Zero Time ◽  
Cooling Part

An analysis was performed of various estimates of the adiabatic temperature Ttot that corresponds to the total heat liberated by a gas dose adsorbed on a metal film in the calorimeter for measurement of chemisorption enthalpies. Besides the two common procedures consisting either in the construction of the adiabatic temperature-time curve or in the extrapolation of the single-exponential cooling part of the actual temperature-time curve to zero time, we have examined estimates of Ttot by extrapolating the cooling exponential to the mid-point between zero time and the temperature maximum (t = tmax/2). Model calculations have shown the merit of the latter extrapolation, particularly in the cases of slow heat evolution. This has been verified on the data measured in the chemisorption of methane and ethane on molybdenum films. Extrapolation to tmax/2 has turned out to be a simple and reasonably reliable procedure for handling the data obtained in film calorimeters.

scholarly journals Modeling the Temperature Field in the Ground with an Installed Slinky-Coil Heat Exchanger

Energies ◽  
2021 ◽  
Vol 14 (13) ◽  
pp. 4010
Author(s):  
Monika Gwadera ◽  
Krzysztof Kupiec
Keyword(s):  
Temperature Field ◽  
Heat Exchanger ◽  
Surface Temperature ◽  
Ground Surface ◽  
Heat Sources ◽  
Ground Surface Temperature ◽  
Coil Heat Exchanger ◽  
The Relationship ◽  
Temperature Responses ◽  
Coil Heat

In order to find the temperature field in the ground with a heat exchanger, it is necessary to determine temperature responses of the ground caused by heat sources and the influence of the environment. To determine the latter, a new model of heat transfer in the ground under natural conditions was developed. The heat flux of the evaporation of moisture from the ground was described by the relationship taking into account the annual amount of rainfall. The analytical solution for the equations of this model is presented. Under the conditions for which the calculations were performed, the following data were obtained: the average ground surface temperature Tsm = 10.67 °C, the ground surface temperature amplitude As = 13.88 K, and the phase angle Ps = 0.202 rad. This method makes it possible to easily determine the undisturbed ground temperature at any depth and at any time. This solution was used to find the temperature field in the ground with an installed slinky-coil heat exchanger that consisted of 63 coils. The results of calculations according to the presented model were compared with the results of measurements from the literature. The 3D model for the ground with an installed heat exchanger enables the analysis of the influence of miscellaneous parameters of the process of extracting or supplying heat from/to the ground on its temperature field.

Facial Coloration and Temperature Responses in Blushing

1990 ◽  
Vol 27 (6) ◽  
pp. 687-693 ◽  
Author(s):  
Don Shearn ◽  
Erik Bergman ◽  
Katherine Hill ◽  
Andy Abel ◽  
Lael Hinds
Keyword(s):  
Temperature Responses

Different day and night temperature responses in Lilium hansonii in relation to growth and flower development

2013 ◽  
Vol 54 (5) ◽  
pp. 405-411 ◽  
Author(s):  
Juniel Galido Lucidos ◽  
Kwang Bok Ryu ◽  
Adnan Younis ◽  
Chang-Kil Kim ◽  
Yoon-Jung Hwang ◽  
...  
Keyword(s):  
Flower Development ◽  
Night Temperature ◽  
Temperature Responses
Sign in / Sign up

Export Citation Format

Share Document