Linearity and High Signal‐to‐Noise Performance of the STIS CCD

1999 ◽  
Vol 111 (762) ◽  
pp. 1009-1020 ◽  
Author(s):  
Ronald L. Gilliland ◽  
Paul Goudfrooij ◽  
Randy A. Kimble
Keyword(s):  
High Signal ◽  
Noise Performance ◽  
Signal To Noise

Achieving high signal-to-noise performance for a velocity-map imaging experiment

2005 ◽  
Vol 144-147 ◽  
pp. 251-254 ◽  
Author(s):  
E.H. Roberts ◽  
S.J. Cavanagh ◽  
S.T. Gibson ◽  
B.R. Lewis ◽  
C.J. Dedman ◽  
...  
Keyword(s):  
High Signal ◽  
Velocity Map Imaging ◽  
Noise Performance ◽  
Signal To Noise ◽  
Imaging Experiment

A compact guided-wave EMAT with pulsed electromagnet for ferromagnetic tube inspection

2020 ◽  
Vol 64 (1-4) ◽  
pp. 951-958
Author(s):  
Tianhao Liu ◽  
Yu Jin ◽  
Cuixiang Pei ◽  
Jie Han ◽  
Zhenmao Chen
Keyword(s):  
Power Plants ◽  
Signal To Noise Ratio ◽  
Small Diameter ◽  
Performance Testing ◽  
Guided Wave ◽  
High Signal ◽  
Receiver Coil ◽  
Signal To Noise ◽  
Corrosion Defects

Small-diameter tubes that are widely used in petroleum industries and power plants experience corrosion during long-term services. In this paper, a compact inserted guided-wave EMAT with a pulsed electromagnet is proposed for small-diameter tube inspection. The proposed transducer is noncontact, compact with high signal-to-noise ratio and unattractive to ferromagnetic tubes. The proposed EMAT is designed with coils-only configuration, which consists of a pulsed electromagnet and a meander pulser/receiver coil. Both the numerical simulation and experimental results validate its feasibility on generating and receiving L(0,2) mode guided wave. The parameters for driving the proposed EMAT are optimized by performance testing. Finally, feasibility on quantification evaluation for corrosion defects was verified by experiments.

Computationally Assisted Design of High Signal-to-Noise Photoinduced Electron Transfer-Based Voltage-Sensitive Dyes

2020 ◽  
Author(s):  
Rishikesh Kulkarni ◽  
Anneliese Gest ◽  
Chun Kei Lam ◽  
Benjamin Raliski ◽  
Feroz James ◽  
...  
Keyword(s):  
Electron Transfer ◽  
Dft Calculations ◽  
Photoinduced Electron Transfer ◽  
Density Functional ◽  
Embryonic Stem ◽  
High Sensitivity ◽  
Md Simulations ◽  
High Signal ◽  
Signal To Noise ◽  
Green Fluorescent

<p>High signal-to-noise optical voltage indicators will enable simultaneous interrogation of membrane potential in large ensembles of neurons. However, design principles for voltage sensors with high sensitivity and brightness remain elusive, limiting the applicability of voltage imaging. In this paper, we use molecular dynamics (MD) simulations and density functional theory (DFT) calculations to guide the design of a bright and sensitive green-fluorescent voltage-sensitive fluorophore, or VoltageFluor (VF dye), that uses photoinduced electron transfer (PeT) as a voltage-sensing mechanism. MD simulations predict an 11% increase in sensitivity due to membrane orientation, while DFT calculations predict an increase in fluorescence quantum yield, but a decrease in sensitivity due to a decrease in rate of PeT. We confirm these predictions by synthesizing a new VF dye and demonstrating that it displays the expected improvements by doubling the brightness and retaining similar sensitivity to prior VF dyes. Combining theoretical predictions and experimental validation has resulted in the synthesis of the highest signal-to-noise green VF dye to date. We use this new voltage indicator to monitor the electrophysiological maturation of human embryonic stem cell-derived medium spiny neurons. </p>

Electroanalysis of Catecholamine Drugs using Graphene Modified Electrodes

2019 ◽  
Vol 15 (4) ◽  
pp. 443-466 ◽  
Author(s):  
Mahya Karami Mosammam ◽  
Mohammad Reza Ganjali ◽  
Mona Habibi-Kool-Gheshlaghi ◽  
Farnoush Faridbod
Keyword(s):  
Electrochemical Sensors ◽  
Modified Electrodes ◽  
Electrochemical Methods ◽  
High Signal ◽  
Signal To Noise ◽  
Low Level ◽  
Biological Studies

Background: Catecholamine drugs are a family of electroactive pharmaceutics, which are widely analyzed through electrochemical methods. However, for low level online determination and monitoring of these compounds, which is very important for clinical and biological studies, modified electrodes having high signal to noise ratios are needed. Numerous materials including nanomaterials have been widely used as electrode modifies for these families during the years. Among them, graphene and its family, due to their remarkable properties in electrochemistry, were extensively used in modification of electrochemical sensors. Objective: In this review, working electrodes which have been modified with graphene and its derivatives and applied for electroanalyses of some important catecholamine drugs are considered.

Narrow-frequency sharp-angular filters using all-dielectric cascaded meta-gratings

Nanophotonics ◽  
2020 ◽  
Vol 9 (10) ◽  
pp. 3443-3450 ◽  
Author(s):  
Wei-Nan Liu ◽  
Rui Chen ◽  
Wei-Yi Shi ◽  
Ke-Bo Zeng ◽  
Fu-Li Zhao ◽  
...  
Keyword(s):  
Thin Film ◽  
Signal To Noise Ratio ◽  
Incident Angle ◽  
Design Strategy ◽  
Transmission Peak ◽  
High Signal ◽  
Waveguide Array ◽  
Signal To Noise ◽  
Center Wavelength ◽  
Noise Ratio

AbstractSelective transmission or filtering always responds to either frequency or incident angle, so as hardly to maximize signal-to-noise ratio in communication, detection and sensing. Here, we propose compact meta-filters of narrow-frequency sharp-angular transmission peak along with broad omnidirectional reflection sidebands, in all-dielectric cascaded subwavelength meta-gratings. The inherent collective resonance of waveguide-array modes and thin film approximation of meta-grating are employed as the design strategy. A unity transmission peak, locating at the incident angle of 44.4° and the center wavelength of 1550 nm, is demonstrated in a silicon meta-filter consisting of two-layer silicon rectangular meta-grating. These findings provide possibilities in cascaded meta-gratings spectroscopic design and alternative utilities for high signal-to-noise ratio applications in focus-free spatial filtering and anti-noise systems in telecommunications.

scholarly journals Low-dose, phase-contrast mammography with high signal-to-noise ratio

2016 ◽  
Vol 7 (2) ◽  
pp. 381 ◽  
Author(s):  
Lukas B. Gromann ◽  
Dirk Bequé ◽  
Kai Scherer ◽  
Konstantin Willer ◽  
Lorenz Birnbacher ◽  
...  
Keyword(s):  
Phase Contrast ◽  
Low Dose ◽  
Signal To Noise Ratio ◽  
High Signal ◽  
Signal To Noise ◽  
Noise Ratio

Research on LIFT Technology for 3D Seismic Denoising in Coalfield

2014 ◽  
Vol 556-562 ◽  
pp. 6328-6331
Author(s):  
Su Zhen Shi ◽  
Yi Chen Zhao ◽  
Li Biao Yang ◽  
Yao Tang ◽  
Juan Li
Keyword(s):  
Signal To Noise Ratio ◽  
High Signal ◽  
3D Seismic ◽  
Signal To Noise ◽  
Denoising Method ◽  
Seismic Processing ◽  
Work Area ◽  
Noise Data ◽  
Noise Ratio ◽  
Effective Signal

The LIFT technology has applied in process of denoising to ensure the imaging precision of minor faults and structure in 3D coalfield seismic processing. The paper focused on the denoising process in two study areas where the LIFT technology is used. The separation of signal and noise is done firstly. Then denoising would be done in the noise data. The Data of weak effective signal that is from the noise data could be blended with the original effective signal to reconstruct the denoising data, so the result which has high signal-to-noise ratio and preserved amplitude is acquired. Thus the fact shows that LIFT is an effective denoising method for 3D seismic in coalfield and could be used widely in other work area.

Head Instability Detection for Testing Process in Perpendicular Magnetic Recording System

2013 ◽  
Vol 770 ◽  
pp. 319-322 ◽  
Author(s):  
Piya Kovintavewat ◽  
Santi Koonkarnkhai ◽  
Aimamorn Suvichakorn
Keyword(s):  
Magnetic Recording ◽  
Signal To Noise Ratio ◽  
Disk Drive ◽  
Detection Algorithm ◽  
Recording System ◽  
High Signal ◽  
Signal To Noise ◽  
Perpendicular Magnetic Recording ◽  
Read Head ◽  
Pass Through

During hard disk drive (HDD) testing process, the magneto-resistive read (MR) head is analyzed and checked if the head is defective or not. Baseline popping (BLP) is one of the crucial problems caused by head instability, whose effect can distort the readback signal to the extent of causing possible sector read failure. Without BLP detection algorithm, the defective read head might pass through HDD assembling process, thus producing an unreliable HDD. This situation must be prevented so as to retain customer satisfaction. This paper proposes a simple (but efficient) BLP detection algorithm for perpendicular magnetic recording systems. Results show that the proposed algorithm outperforms the conventional one in terms of both the percentage of detection and the percentage of false alarm, when operating at high signal-to-noise ratio.

High signal-to-noise ratio quantum well bolometer materials

2006 ◽  
Author(s):  
Stanley Wissmar ◽  
Linda Höglund ◽  
Jan Andersson ◽  
Christian Vieider ◽  
Susan Savage ◽  
...  
Keyword(s):  
Quantum Well ◽  
Signal To Noise Ratio ◽  
High Signal ◽  
Signal To Noise ◽  
Noise Ratio
Sign in / Sign up

Export Citation Format

Share Document