Functioning of Conducting Elements of Phloem and Xylem in the Stalk of the Developing Fruit of Lupinus albus L

1978 ◽  
Vol 5 (3) ◽  
pp. 321 ◽  
Author(s):  
JS Pate ◽  
J Kuo ◽  
PJ Hocking

The economy of water and dry matter in fruits of white lupin (L. albus L.) was studied by measuring transpiration, CO2 exchange and weight changes over an 8-week growth period. These data were combined with analyses of upper stem tracheal (xylem) sap and fruit tip phloem sap to estimate rates of import of dry matter and water through xylem and phloem. Assuming unidirectional mass flow to operate, phloem carried 97 % of the dry matter and 27 % of the water entering the fruit, and xylem supplied the remainder of the water, 30 % of the minerals and 10 % of the amino compounds. The structure of fruit stalks of various age was examined by light microscopy. Cross-sectional areas occupied by different tissues were measured, and numbers and mean transverse areas of conducting elements estimated. Sieve tubes comprised 0.66-1.13% of the stalk's cross-sectional area, vessels plus tracheids 0.27 - 0.50%. Secondary xylem consisted mainly of fibres. Sieve tubes occupied 18 - 27% of the phloem cross-sectional area. The fully grown stalk showed approximately three times as many sieve tubes in transverse section as vessels plus tracheids. Transfer of dry matter and water through the fruit stalk was highest during the exponential phase of fruit growth. Peak specific mass transfer in sieve tubes was 3.95 g dry matter per square centimetre of sieve tube per hour, in tracheids plus vessels 0.28 g cm2 h-1. Maximum flow velocity in sieve tubes was 22 cm h-1, in tracheids plus vessels, 147 cm h-1. Values for specific mass transfer and flow velocities were several times less in stalks of very young or near-mature fruits.

Author(s):  
Rosa H. Cha´vez ◽  
Javier de J. Guadarrama ◽  
Osbaldo Pe´rez ◽  
Abel Herna´ndez-Guerrero

In order to determine the dimension of a separation column, hydrodynamic and mass transfer models are necessary to evaluate the pressure drop and the height of the global mass transfer unit, respectively. Those parameters are a function of the cross sectional area of the column. The present work evaluates the dependency of the pressure drop and height of the global transfer unit with respect to the cross sectional area of the column, using an absorption column with high efficiency structured packing, in order to recover SO2 in the form of NaHSO3, as an example. An optimization was done applying Two Film model which is based on the number of global mass transfer units of both gas and liquid, involving the separation efficiency in terms of the height of a global transfer unit. Structured packing, geometrically heaped in a separation column, has been achieving wider acceptance in the separation processes due to their geometric characteristics that allow them to have greater efficiency in the separation processes. Three different structured packing were evaluated in this work. The results show how ININ packing is one of the packings does the best work having the highest separation efficiency because it has the lowest height of the global mass transfer unit and Mellapak packing has the largest capacity because it manages the largest liquid and gas flows. An analysis is done with respect to the pressure drop through the system for all packings considered, and a discussion is presented for each hydrodynamic and mass transfer parameter studied.


1983 ◽  
Vol 36 (2) ◽  
pp. 223-227
Author(s):  
A. C. B. Hooper ◽  
M. P. Hurley

ABSTRACTUltrastructural parameters of muscle growth were measured in lines of mice which had undergone 15 generations of selection for high and low body weight. Previous light microscopic studies of these lines had shown that selection for altered body weight evokes correlated responses in the weight of skeletal muscles as a result of changes in both the number and the longitudinal and transverse dimensions of the fibres.The length of the myosin filaments and of the actin filaments (including the Z disc) did not differ significantly from the controls in the mm. sternomastoideus, biceps brachii and tibialis anterior of mature male mice from the two selection lines. The mean cross-sectional area of the myofibrils of the mm. sternomastoideus and biceps brachii were also unaltered by selection for high and low body weight. Changes in the area of the fibres were brought about by increases and decreases in the number of their constituent myofibrils and corresponding changes in the non-contractile elements.Selection for high and low body weight did not affect the dimensions of the contractile elements of the muscle fibres. The genetically determined alterations in the length and cross-sectional area of the fibres were due to changes in the number of their constituent sarcomeres and myofibrils. These changes are similar to those which occur during growth.


Author(s):  
Stéphane Weusten ◽  
Luc Murrer ◽  
Matheus de Groot ◽  
John van der Schaaf

This paper investigates the effect of inlet shape, entrance length and turbulence promoters on mass transfer by using 3D printed electrolyzers. Our results show that the inlet design can promote turbulence and lead to an earlier transition to turbulent flow. The Reynolds number at which the transition occurs can be predicted by the ratio of the cross-sectional area of the inlet to the cross-sectional area of the electrolyzer channel. A longer entrance length results in more laminar behavior and a later transition to turbulent flow. With an entrance length of 550mm, the inlet design did no longer affect the mass transfer performance significantly. The addition of gyroid type turbulence promoters resulted in a factor 2 to 4 increase in mass transfer depending on inlet design, entrance length and the type of promoter. From one configuration to another, there was a minimal variation in pressure drop (<16 mbar).


2011 ◽  
Vol 134 (1) ◽  
Author(s):  
Zhipeng Duan

Fully developed turbulent flow in noncircular ducts is examined, and simple models are proposed to predict the friction, heat and mass transfer in most common noncircular channels. It is found that the square root of cross-sectional area is the relatively more appropriate length scale to use in defining the dimensionless parameters to ensure similarity between the circular and most noncircular ducts. By using the dimensionless parameters based on the square root of cross-sectional area, it is demonstrated that the circular tube relations may be applied to most noncircular ducts eliminating large errors in estimation. As turbulent transport phenomena are inherently complex and there, currently, is no extensive experimental data for turbulent heat and mass transfer in noncircular ducts, the simple models are valuable in spite of their limitations.


2020 ◽  
Vol 59 (36) ◽  
pp. 16043-16051
Author(s):  
Zhang-Nan Wen ◽  
Wei Wu ◽  
Yong Luo ◽  
Liang-Liang Zhang ◽  
Bao-Chang Sun ◽  
...  

1994 ◽  
Vol 07 (03) ◽  
pp. 110-113 ◽  
Author(s):  
D. L. Holmberg ◽  
M. B. Hurtig ◽  
H. R. Sukhiani

SummaryDuring a triple pelvic osteotomy, rotation of the free acetabular segment causes the pubic remnant on the acetabulum to rotate into the pelvic canal. The resulting narrowing may cause complications by impingement on the organs within the pelvic canal. Triple pelvic osteotomies were performed on ten cadaver pelves with pubic remnants equal to 0, 25, and 50% of the hemi-pubic length and angles of acetabular rotation of 20, 30, and 40 degrees. All combinations of pubic remnant lengths and angles of acetabular rotation caused a significant reduction in pelvic canal-width and cross-sectional area, when compared to the inact pelvis. Zero, 25, and 50% pubic remnants result in 15, 35, and 50% reductions in pelvic canal width respectively. Overrotation of the acetabulum should be avoided and the pubic remnant on the acetabular segment should be minimized to reduce postoperative complications due to pelvic canal narrowing.When performing triple pelvic osteotomies, the length of the pubic remnant on the acetabular segment and the angle of acetabular rotation both significantly narrow the pelvic canal. To reduce post-operative complications, due to narrowing of the pelvic canal, overrotation of the acetabulum should be avoided and the length of the pubic remnant should be minimized.


Sign in / Sign up

Export Citation Format

Share Document