Electron Vacancy Production in Near-symmetric Collisions of 100 MeV Copper Ions

1981 ◽  
Vol 34 (2) ◽  
pp. 155 ◽  
Author(s):  
HJ Hay ◽  
LF Pender ◽  
PB Treacy

With a high-resolution Si(Li) X-ray detector, characteristic K X rays have been detected with targets of Cr, Fe, Cu, Ge and Se ombarded by 100 MeV Cu ions, equilibrated by passing through carbon. Cross sections for X-ray production, target-to-projectile vacancy-sharing ratios and K, to K, ratios were measured and compared with predictions of molecular-coupling theories. The results show little greement with existing models based on rotational coupling in molecular-orbital states.

2017 ◽  
Vol 890 ◽  
pp. 223-226 ◽  
Author(s):  
Rıdvan Durak ◽  
Ferdi Akman ◽  
Abdulhalik Karabulut

The Ll, Lα and Lβ X-ray production cross sections for Pr, Nd, Sm, Eu, Gd and Tb elements were determined using a reflection geometry. The excitation was performed with a 241Am radioactive annular source and the L X-rays emitted from targets were counted with a high-resolution Si (Li) detector. The experimental values were compared with other available experimental results and theoretical data. An agreement is observed between the measured and other experimental results or theoretical data.


2002 ◽  
Vol 80 (12) ◽  
pp. 1579-1589 ◽  
Author(s):  
H Tawara ◽  
P Richard

In the present work, mechanisms of Ar K X-ray production have been investigated under low-energy Arq+ + Ar collisions in a wide range of the ion-charge states. Ar K X-rays have been observed as a function of the collision energy over (0.75–3.75)q keV/u and of the charge state over q = 8–16 of projectile Arq+ ions. If the L-shell vacancies become available (q = 9), Ar K X-ray yields are found to be enhanced roughly three orders of magnitude, compared with Ar8+ ions with no L-shell vacancy; to show some threshold; and to tend to quickly saturate at higher collision energies. The present analysis, based on the energy correlation diagrams of the quasi-molecules, suggests that Ar K X-rays originate entirely from target Ar atoms through promotion via the rotational coupling between 2pσ –2pπ molecular orbitals. Furthermore, the observed cross sections are found to increase nonlinearly with the projectile Arq+ ion charge q (q = 9). This can be understood because of the combined effects of two contributions: (i) the increased number of the L-shell vacancies of projectile Arq+ ions and (ii) the enhanced fluorescence yields of target Ar atom. In addition, Ar K X-rays have been observed under 2.5q keV/u Ar17+ and Ar18+ + Ar collisions and found to originate from the decay of K-shell vacancies initially present in the projectile Ar ions through electron capture into their highly excited states, followed by cascade down to the ground states. For the first time, though very weak, the X-rays due to the two-electron–one-photon transition, namely, K αα lines, have also been observed in bare Ar18+ ion collisions. PACS Nos.: 34.70+e, 32.80Rm


1974 ◽  
Vol 18 ◽  
pp. 299-308
Author(s):  
D. I. Bales ◽  
R. R. Landolt ◽  
W. E. Toll

AbstractThe production of characteristic x rays by 100-keV protons has been studied to determine the feasibility of using a Cockcroft- Walton accelerator as an excitation source for x ray fluorescence analysis. Because of the low cross sections at this proton energy, it was necessary to concentrate on characteristic x rays below 6 keV and to use beam currents of 10 to 100 μA. The x rays were measured by a high resolution Si(Li) detector.The preparation of various types of samples and the problems that arise when working at low proton energies and high beam currents are discussed.It was found that the technique is useful for low atomic number elements down to less than 1 ppm in a water sample when there are no other significant impurities. When other elements are present, however, proton absorption becomes an important factor and quantitative determinations become very difficult. Proton absorption and its effect upon the usefulness of the technique are discussed.The precision for the technique was determined and found to be better than 20% for most measurements. This includes errors in sample preparation which was considered to be a significant portion of the uncertainty.


1998 ◽  
Vol 5 (3) ◽  
pp. 515-517 ◽  
Author(s):  
M. Frank ◽  
C. A. Mears ◽  
S. E. Labov ◽  
L. J. Hiller ◽  
J. B. le Grand ◽  
...  

Experimental results are presented obtained with a cryogenically cooled high-resolution X-ray spectrometer based on a 141 × 141 µm Nb-Al-Al2O3-Al-Nb superconducting tunnel junction (STJ) detector in an SR-XRF demonstration experiment. STJ detectors can operate at count rates approaching those of semiconductor detectors while still providing a significantly better energy resolution for soft X-rays. By measuring fluorescence X-rays from samples containing transition metals and low-Z elements, an FWHM energy resolution of 6–15 eV for X-rays in the energy range 180–1100 eV has been obtained. The results show that, in the near future, STJ detectors may prove very useful in XRF and microanalysis applications.


2007 ◽  
Vol 130 ◽  
pp. 7-14 ◽  
Author(s):  
Andrew N. Fitch

The highly-collimated, intense X-rays produced by a synchrotron radiation source can be harnessed to build high-resolution powder diffraction instruments with a wide variety of applications. The general advantages of using synchrotron radiation for powder diffraction are discussed and illustrated with reference to the structural characterisation of crystalline materials, atomic PDF analysis, in-situ and high-throughput studies where the structure is evolving between successive scans, and the measurement of residual strain in engineering components.


1991 ◽  
Vol 01 (03) ◽  
pp. 251-258 ◽  
Author(s):  
M. TERASAWA

K, L, and M X-rays in the wavelengths between 6Å and 130Å generated by the bombardment of 200 keV protons and other heavy ions were measured by means of a wavelength dispersive Bragg’s spectrometer. The X-ray peak intensity was fairly high in general, while the background was very low. The technique was favorably applied to a practical analysis of several light elements (Be, B, C, N, O, and F). Use of moderate-energy heavy ions considering the wavelength selectivity in X-ray generation was effective for the element analysis. The high-resolution spectrometry in the analytical application of ion-induced X-ray generation was found to be useful for the study of fine electronic structure, e.g. satellite and hypersatellite X-ray study, and of the chemical state of materials.


2008 ◽  
Vol 4 (S251) ◽  
pp. 369-370
Author(s):  
S. Pilling ◽  
D. P. P. Andrade ◽  
A. C. F. Santos ◽  
H. M. Boechat-Roberty

AbstractWe present experimental results obtained from photoionization and photodissociation processes of abundant interstellar methanol (CH3OH) as an alternative route for the production of H3+ in dense clouds. The measurements were taken at the Brazilian Synchrotron Light Laboratory (LNLS) employing soft X-ray and time-of-flight mass spectrometry. Mass spectra were obtained using the photoelectron-photoion coincidence techniques. Absolute averaged cross sections for the production of H3+ due to molecular dissociation of methanol by soft X-rays (C1s edge) were determined. The H3+'s photoproduction rate and column density were been estimated adopting a typical soft X-ray luminosity inside dense molecular and the observed column density of methanol. Assuming a steady state scenario, the highest column density value for the photoproduced H3+ was about 1011 cm2, which gives the ratio photoproduced/observed of about 0.05%, as in the case of dense molecular cloud AFGL 2591. Despite the small value, this represent a new and alternative source of H3+ into dense molecular clouds and it is not been considered as yet in interstellar chemistry models.


2016 ◽  
Vol 23 (6) ◽  
pp. 1462-1473 ◽  
Author(s):  
Sebastian Cartier ◽  
Matias Kagias ◽  
Anna Bergamaschi ◽  
Zhentian Wang ◽  
Roberto Dinapoli ◽  
...  

MÖNCH is a 25 µm-pitch charge-integrating detector aimed at exploring the limits of current hybrid silicon detector technology. The small pixel size makes it ideal for high-resolution imaging. With an electronic noise of about 110 eV r.m.s., it opens new perspectives for many synchrotron applications where currently the detector is the limiting factor,e.g.inelastic X-ray scattering, Laue diffraction and soft X-ray or high-resolution color imaging. Due to the small pixel pitch, the charge cloud generated by absorbed X-rays is shared between neighboring pixels for most of the photons. Therefore, at low photon fluxes, interpolation algorithms can be applied to determine the absorption position of each photon with a resolution of the order of 1 µm. In this work, the characterization results of one of the MÖNCH prototypes are presented under low-flux conditions. A custom interpolation algorithm is described and applied to the data to obtain high-resolution images. Images obtained in grating interferometry experiments without the use of the absorption grating G2are shown and discussed. Perspectives for the future developments of the MÖNCH detector are also presented.


2021 ◽  
Author(s):  
Md Inzamam Ul Haque ◽  
Abhishek K Dubey ◽  
Jacob D Hinkle

Deep learning models have received much attention lately for their ability to achieve expert-level performance on the accurate automated analysis of chest X-rays. Although publicly available chest X-ray datasets include high resolution images, most models are trained on reduced size images due to limitations on GPU memory and training time. As compute capability continues to advance, it will become feasible to train large convolutional neural networks on high-resolution images. This study is based on the publicly available MIMIC-CXR-JPG dataset, comprising 377,110 high resolution chest X-ray images, and provided with 14 labels to the corresponding free-text radiology reports. We find, interestingly, that tasks that require a large receptive field are better suited to downscaled input images, and we verify this qualitatively by inspecting effective receptive fields and class activation maps of trained models. Finally, we show that stacking an ensemble across resolutions outperforms each individual learner at all input resolutions while providing interpretable scale weights, suggesting that multi-scale features are crucially important to information extraction from high-resolution chest X-rays.


1984 ◽  
Vol 17 (5) ◽  
pp. 337-343 ◽  
Author(s):  
O. Yoda

A high-resolution small-angle X-ray scattering camera has been built, which has the following features. (i) The point collimation optics employed allows the scattering cross section of the sample to be directly measured without corrections for desmearing. (ii) A small-angle resolution better than 0.5 mrad is achieved with a camera length of 1.6 m. (iii) A high photon flux of 0.9 photons μs−1 is obtained on the sample with the rotating-anode X-ray generator operated at 40 kV–30 mA. (iv) Incident X-rays are monochromated by a bent quartz crystal, which makes the determination of the incident X-ray intensity simple and unambiguous. (v) By rotation of the position-sensitive proportional counter around the direct beam, anisotropic scattering patterns can be observed without adjusting the sample. Details of the design and performance are presented with some applications.


Sign in / Sign up

Export Citation Format

Share Document