Since the 1980s, there have been general trends in the durum wheat milling industry to higher semolina extraction rate, and in the pasta processing industry to the use of higher drying temperatures. During this time, specification of gluten strength by gluten index, mixograph mixing properties and alveograph parameters has also become widespread. These trends prompted this study of the appropriateness of protocols for quality testing of Canadian durum wheat breeding lines. Four cultivars with intrinsic differences in yellow pigment levels and gluten strength were grown in field plots in Swift Current, Saskatchewan for three consecutive years. A laboratory-scale milling procedure was modified to produce semolina at extraction rates from about 65% to about 80%. Milling to extraction rates above 65%, the extraction rate used routinely in quality testing of Canadian durum wheat breeding lines, had a major impact on semolina ash content and colour, but did not offer any advantage in ranking cultivars for either semolina yield or semolina refinement. Gluten strength, as measured by gluten index, was independent of semolina extraction rate. Dough strength, as measured by mixograph properties and alveograph properties, showed a tendency to weakening at high extraction, particularly for strong cultivars. Semolina was processed into spaghetti using low-temperature (LT), high-temperature (HT) and ultra-high-temperature (UHT) drying cycles. The firmness of cooked spaghetti was predominantly influenced by protein content. As a result, cultivars generally ranked in spaghetti firmness according to protein content. Regardless of drying cycle or cultivar, spaghetti firmness increased as drying temperature increased. Spaghetti dried at LT was less yellow than spaghetti dried at HT or UHT, probably due to thermal inactivation of the bleaching enzyme lipoxygenase at HT and UHT. Regardless of drying cycle, spaghetti became duller, more red and less yellow as extraction rate increased. For each spaghetti trait, cultivar ranking remained relatively constant regardless of extraction rate or drying temperature. On the basis of these results, there appears to be no advantage to increasing semolina extraction rate beyond 65% for evaluation of durum wheat milling performance, gluten strength or pasta properties. In addition, it appears that one drying cycle is adequate to reliably evaluate durum wheat lines for spaghetti colour and firmness. Key words: Durum wheat (Triticum turgidum L. var durum), milling, semolina, pasta, quality screening, gluten strength, colour, texture
A locus for sodium exclusion (Nax1), a trait for salt tolerance, mapped in durum wheat