Statistical and wavelet analysis of detailed physical property measurements on the Bellevue drillcore, Northern Lobe, Bushveld Igneous Complex, South Africa

2001 ◽  
Vol 2001 (1) ◽  
pp. 1-4
Author(s):  
S. J. Webb ◽  
G. R. J. Cooper ◽  
L. D. Ashwal ◽  
M. W. Knoper
Keyword(s):  
South Africa ◽  
Wavelet Analysis ◽  
Physical Property ◽  
Igneous Complex ◽  
Bushveld Igneous Complex

scholarly journals Atmospheric trace metals measured at a regional background site (Welgegund) in South Africa

2017 ◽  
Vol 17 (6) ◽  
pp. 4251-4263 ◽  
Author(s):  
Andrew D. Venter ◽  
Pieter G. van Zyl ◽  
Johan P. Beukes ◽  
Micky Josipovic ◽  
Johan Hendriks ◽  
...  
Keyword(s):  
South Africa ◽  
Trace Metals ◽  
Trace Metal ◽  
Size Fraction ◽  
Abundant Species ◽  
Metal Species ◽  
Metal Concentrations ◽  
Igneous Complex ◽  
Size Fractions ◽  
Bushveld Igneous Complex

Abstract. Atmospheric trace metals can cause a variety of health-related and environmental problems. Only a few studies on atmospheric trace metal concentrations have been conducted in South Africa. Therefore the aim of this study was to determine trace metal concentrations in aerosols collected at a regional background site, i.e. Welgegund, South Africa. PM1, PM1–2. 5 and PM2. 5–10 samples were collected for 13 months, and 31 atmospheric trace metal species were detected. Atmospheric iron (Fe) had the highest concentrations in all three size fractions, while calcium (Ca) was the second-most-abundant species. Chromium (Cr) and sodium (Na) concentrations were the third- and fourth-most-abundant species, respectively. The concentrations of the trace metal species in all three size ranges were similar, with the exception of Fe, which had higher concentrations in the PM1 size fraction. With the exception of titanium (Ti), aluminium (Al) and manganese (Mg), 70 % or more of the trace metal species detected were in the smaller size fractions, which indicated the influence of industrial activities. However, the large influence of wind-blown dust was reflected by 30 % or more of trace metals being present in the PM2. 5–10 size fraction. Comparison of trace metals determined at Welgegund to those in the western Bushveld Igneous Complex indicated that at both locations similar species were observed, with Fe being the most abundant. However, concentrations of these trace metal species were significantly higher in the western Bushveld Igneous Complex. Fe concentrations at the Vaal Triangle were similar to levels thereof at Welgegund, while concentrations of species associated with pyrometallurgical smelting were lower. Annual average Ni was 4 times higher, and annual average As was marginally higher than their respective European standard values, which could be attributed to regional influence of pyrometallurgical industries in the western Bushveld Igneous Complex. All three size fractions indicated elevated trace metal concentrations coinciding with the end of the dry season, which could partially be attributed to decreased wet removal and increases in wind generation of particulates. Principal component factor analysis (PCFA) revealed four meaningful factors in the PM1 size fraction, i.e. crustal, pyrometallurgical-related and Au slimes dams. No meaningful factors were determined for the PM1–2. 5 and PM2. 5–10 size fractions, which was attributed to the large influence of wind-blown dust on atmospheric trace metals determined at Welgegund. Pollution roses confirmed the influence of wind-blown dust on trace metal concentrations measured at Welgegund, while the impact of industrial activities was also substantiated.

scholarly journals Ambient aromatic hydrocarbon measurements at Welgegund, South Africa

2014 ◽  
Vol 14 (4) ◽  
pp. 4189-4227
Author(s):  
K. Jaars ◽  
J. P. Beukes ◽  
P. G. van Zyl ◽  
A. D. Venter ◽  
M. Josipovic ◽  
...  
Keyword(s):  
South Africa ◽  
Aromatic Hydrocarbon ◽  
Human Health ◽  
Aromatic Hydrocarbons ◽  
Night Time ◽  
Air Mass ◽  
Air Masses ◽  
Igneous Complex ◽  
Source Regions ◽  
Bushveld Igneous Complex

Abstract. Aromatic hydrocarbons are associated with direct adverse human health effects and can have negative impacts on ecosystems due to their toxicity, as well as indirect negative effects through the formation of tropospheric ozone and secondary organic aerosol that affect human health, crop production and regional climate. Measurements were conducted at the Welgegund measurement station (South Africa) that is considered to be a regionally representative background site. However, the site is occasionally impacted by plumes from major anthropogenic source regions in the interior of South Africa, which include the western Bushveld Igneous Complex (e.g. platinum, base metal and ferrochrome smelters), the eastern Bushveld Igneous Complex (platinum and ferrochrome smelters), the Johannesburg–Pretoria metropolitan conurbation (>10 million people), the Vaal Triangle (e.g. petrochemical and pyrometallurgical industries), the Mpumalanga Highveld (e.g. coal-fired power plants and petrochemical industry) and also a region of anti-cyclonic recirculation of air mass over the interior of South Africa. The aromatic hydrocarbon measurements were conducted with an automated sampler on Tenax-TA and Carbopack-B adsorbent tubes with heated inlet for one year. Samples were collected twice a week for two hours during daytime and two hours during night-time. A thermal desorption unit, connected to a gas chromatograph and a mass selective detector was used for sample preparation and analysis. Results indicated that the monthly median total aromatic hydrocarbon concentrations ranged between 0.01 to 3.1 ppb. Benzene levels did not exceed local air quality standards. Toluene was the most abundant species, with an annual median concentration of 0.63 ppb. No statistically significant differences in the concentrations measured during daytime and night-time were found and no distinct seasonal patterns were observed. Air mass back trajectory analysis proved that the lack of seasonal cycles could be attributed to patterns determining the origin of the air masses sampled. Aromatic hydrocarbon concentrations were in general significantly higher in air masses that passed over anthropocentrically impacted regions. Interspecies correlations and ratios gave some indications of the possible sources for the different aromatic hydrocarbons in the source regions defined in the paper. The highest contribution of aromatic hydrocarbon concentrations to ozone formation potential was also observed in plumes passing over anthropocentrically impacted regions.

scholarly journals Ambient aromatic hydrocarbon measurements at Welgegund, South Africa

2014 ◽  
Vol 14 (13) ◽  
pp. 7075-7089 ◽  
Author(s):  
K. Jaars ◽  
J. P. Beukes ◽  
P. G. van Zyl ◽  
A. D. Venter ◽  
M. Josipovic ◽  
...  
Keyword(s):  
South Africa ◽  
Aromatic Hydrocarbon ◽  
Human Health ◽  
Aromatic Hydrocarbons ◽  
Night Time ◽  
Air Mass ◽  
Air Masses ◽  
Igneous Complex ◽  
Source Regions ◽  
Bushveld Igneous Complex

Abstract. Aromatic hydrocarbons are associated with direct adverse human health effects and can have negative impacts on ecosystems due to their toxicity, as well as indirect negative effects through the formation of tropospheric ozone and secondary organic aerosol, which affect human health, crop production and regional climate. Measurements of aromatic hydrocarbons were conducted at the Welgegund measurement station (South Africa), which is considered to be a regionally representative background site. However, the site is occasionally impacted by plumes from major anthropogenic source regions in the interior of South Africa, which include the western Bushveld Igneous Complex (e.g. platinum, base metal and ferrochrome smelters), the eastern Bushveld Igneous Complex (platinum and ferrochrome smelters), the Johannesburg–Pretoria metropolitan conurbation (> 10 million people), the Vaal Triangle (e.g. petrochemical and pyrometallurgical industries), the Mpumalanga Highveld (e.g. coal-fired power plants and petrochemical industry) and also a region of anticyclonic recirculation of air mass over the interior of South Africa. The aromatic hydrocarbon measurements were conducted with an automated sampler on Tenax-TA and Carbopack-B adsorbent tubes with heated inlet for 1 year. Samples were collected twice a week for 2 h during daytime and 2 h during night-time. A thermal desorption unit, connected to a gas chromatograph and a mass selective detector was used for sample preparation and analysis. Results indicated that the monthly median (mean) total aromatic hydrocarbon concentrations ranged between 0.01 (0.011) and 3.1 (3.2) ppb. Benzene levels did not exceed the local air quality standard limit, i.e. annual mean of 1.6 ppb. Toluene was the most abundant compound, with an annual median (mean) concentration of 0.63 (0.89) ppb. No statistically significant differences in the concentrations measured during daytime and night-time were found, and no distinct seasonal patterns were observed. Air mass back trajectory analysis indicated that the lack of seasonal cycles could be attributed to patterns determining the origin of the air masses sampled. Aromatic hydrocarbon concentrations were in general significantly higher in air masses that passed over anthropogenically impacted regions. Inter-compound correlations and ratios gave some indications of the possible sources of the different aromatic hydrocarbons in the source regions defined in the paper. The highest contribution of aromatic hydrocarbon concentrations to ozone formation potential was also observed in plumes passing over anthropogenically impacted regions.

Sign in / Sign up

Export Citation Format

Share Document