scholarly journals Magnetic hysteresis of individual Janus particles with hemispherical exchange biased caps

2021 ◽  
Vol 119 (22) ◽  
pp. 222406
Author(s):  
S. Philipp ◽  
B. Gross ◽  
M. Reginka ◽  
M. Merkel ◽  
M. M. Claus ◽  
...  
Keyword(s):  
Magnetic Hysteresis ◽  
Janus Particles

High-resolution scanning electron microscopy of thin-film magnetic media of magnetic recording disk

1992 ◽  
Vol 50 (2) ◽  
pp. 1334-1335
Author(s):  
K. Ogura ◽  
H. Nishioka ◽  
N. Ikeo ◽  
T. Kanazawa ◽  
J. Teshima
Keyword(s):  
Thin Film ◽  
Fine Structure ◽  
High Resolution ◽  
Magnetic Recording ◽  
High Performance ◽  
Magnetic Hysteresis ◽  
Grain Structure ◽  
Magnetic Media ◽  
Cross Sectional ◽  
Resolution Observation

Structural appraisal of thin film magnetic media is very important because their magnetic characters such as magnetic hysteresis and recording behaviors are drastically altered by the grain structure of the film. However, in general, the surface of thin film magnetic media of magnetic recording disk which is process completed is protected by several-nm thick sputtered carbon. Therefore, high-resolution observation of a cross-sectional plane of a disk is strongly required to see the fine structure of the thin film magnetic media. Additionally, observation of the top protection film is also very important in this field.Recently, several different process-completed magnetic disks were examined with a UHR-SEM, the JEOL JSM 890, which consisted of a field emission gun and a high-performance immerse lens. The disks were cut into approximately 10-mm squares, the bottom of these pieces were carved into more than half of the total thickness of the disks, and they were bent. There were many cracks on the bent disks. When these disks were observed with the UHR-SEM, it was very difficult to observe the fine structure of thin film magnetic media which appeared on the cracks, because of a very heavy contamination on the observing area.

Structural and Magnetic Hysteresis Properties of Co-Zr Substituted Hexagonal Barium Ferrites

2015 ◽  
Vol 7 (1) ◽  
pp. 1346-1351
Author(s):  
Ch.Gopal Reddy ◽  
Ch. Venkateshwarlu ◽  
P. Vijaya Bhasker Reddy
Keyword(s):  
Magnetic Properties ◽  
Single Phase ◽  
Magnetic Hysteresis ◽  
Grain Morphology ◽  
Hexagonal Structure ◽  
Ion Composition ◽  
X Ray Diffraction ◽  
Ceramic Method ◽  
Barium Ferrites ◽  
Xrd Patterns

Co-Zr substituted M-type hexagonal barium ferrites, with chemical formula BaCoxZrxFe12-2xO19 (where x = 0.0, 0.2, 0.4, 0.6, 0.8 and 1.0), have been synthesized by double sintering ceramic method. The crystallographic properties, grain morphology and magnetic properties of these ferrites have been investigated by X-ray Diffraction (XRD), Scanning Electron Microscopy (SEM) and Vibrating Sample Magnetometer (VSM). The XRD patterns confirm the single phase with hexagonal structure of prepared ferrites. The magnetic properties have been investigated as a function of Co and Zr ion composition at an applied field in the range of 20 KOe. These studies indicate that the saturation magnetization (Ms) in the samples increases initially up to the Co-Zr composition of x=0.6 and decreases thereafter. On the other hand, the coercivity (Hc) and Remanent magnetization (Mr) are found to decrease continuously with increasing Co-Zr content. This property is most useful in permanent magnetic recording. The observed results are explained on the basis of site occupation of Co and Zr ions in the samples.

Seeking Magneto-Structural Correlations in Easily Tailored Pentagonal Bipyramid Dy(III) Single-Ion Magnets

2019 ◽  
Author(s):  
Guo-Zhang Huang ◽  
Ze-Yu Ruan ◽  
Jie-Yu Zheng ◽  
Yan-Cong Chen ◽  
Si-Guo Wu ◽  
...  
Keyword(s):  
Single Molecule ◽  
Structural Engineering ◽  
Magnetic Hysteresis ◽  
Sweep Rate ◽  
Coordination Bond ◽  
Pentagonal Bipyramid ◽  
Single Molecule Magnets ◽  
Crystal Field Theory ◽  
Bond Angles ◽  
Axial Coordination

<p><a></a>Controlling molecular magnetic anisotropy via structural engineering is delicate and fascinating, especially for single-molecule magnets (SMMs). Herein a family of dysprosium single-ion magnets (SIMs) sitting in pentagonal bipyramid geometry have been synthesized with the variable-size terminal ligands and counter anions, through which the subtle coordination geometry of Dy(III) can be finely tuned based on the size effect. The effective energy barrier (Ueff) successfully increases from 439 K to 632 K and the magnetic hysteresis temperature (under a 200 Oe/s sweep rate) raises from 11 K to 24 K. Based on the crystal-field theory, a semi-quantitative magneto-structural correlation deducing experimentally for the first time is revealed that the Ueff is linearly proportional to the structural-related value S2<sup>0</sup> corresponding to the axial coordination bond lengths and the bond angles. Through the evaluation of the remanent magnetization from hysteresis, quantum tunneling of magnetization (QTM) is found to exhibit negative correlation with the structural-related value S<sub>tun</sub> corresponding to the axial coordination bond angles.<br></p>

Exchange-Biasing in a Dinuclear Dysprosium(III) Single-Molecule Magnet with a Large Energy Barrier for Magnetization Reversal

2019 ◽  
Author(s):  
Tian Han ◽  
Marcus J. Giansiracusa ◽  
Zi-Han Li ◽  
You-Song Ding ◽  
Nicholas F. Chilton ◽  
...  
Keyword(s):  
Single Molecule ◽  
Magnetization Reversal ◽  
Energy Barrier ◽  
Magnetic Hysteresis ◽  
Large Energy ◽  
Magnetic Studies ◽  
Bridging Ligands ◽  
Single Molecule Magnet ◽  
Exchange Biasing

A dichlorido-bridged dinuclear dysprosium(III) single-molecule magnet [Dy<sub>2</sub>L<sub>2</sub>(<i>µ</i>-Cl)<sub>2</sub>(THF)<sub>2</sub>] has been made using a diamine-bis(phenolate) ligand, H<sub>2</sub>L. Magnetic studies show an energy barrier for magnetization reversal (<i>U</i><sub>eff</sub>) around 1000 K. Exchange-biasing effect is clearly seen in magnetic hysteresis with steps up to 4 K. <i>Ab</i> initio calculations exclude the possibility of pure dipolar origin of this effect leading to the conclusion that super-exchange <i>via</i> the chloride bridging ligands is important.

Physical methods of research and monitoring

2019 ◽  
Vol 85 (1(I)) ◽  
pp. 35-44
Author(s):  
S. G. Sandomirski
Keyword(s):  
Heat Treatment ◽  
Coercive Force ◽  
Remanent Magnetization ◽  
Structural Changes ◽  
Mechanical Load ◽  
Magnetic Hysteresis ◽  
Steel Structures ◽  
Magnetic Characteristics ◽  
Magnetic Parameters ◽  
Saturation Intensity

The main magnetic parameters sensitive to the structure of steels are the parameters of their saturation loop of magnetic hysteresis: the coercive force Hcs and remanent magnetization Mrs. The saturation magnetization or saturation intensity Mr is most sensitive to the phase composition of steels. The variety of steel grades and modes of technological treatment (e.g., heat treatment, mechanical load) determined the use of magnetic structurescopy and magnetic characteristics — the coercive force Hc, remanent magnetization Mr , and specific hysteresis losses Wh on the subloops of the magnetic hysteresis of steels — as control parameters in diagnostics of the stressed and structural states of steel structures and pipelines. It has been shown that changes in Hc, Mr , and Wh are more sensitive to structural stresses and structures of steels than the parameters of the saturation hysteresis loop of magnetic hysteresis (Hcs, Mrs, and Mrs). The formulas for calculating Hc, Mr and Wh are presented to be used for estimation of changes in the parameters upon heat treatment of steels. Features of the structural sensitivity of the subloop characteristics and expediency of their use for magnetic structural and phase analyzes are determined. Thus, the range of changes in Ìr attributed to the structural changes in steels upon gradual Hm decrease is many times wider compared to the range of possible changes in Mrs under the same conditions. Conditions (relations between the magnetic parameters) and recommendations regarding the choice of the field strength Hm are given which provide the justified use of Hc, Mr and Wh parameters in magnetic structurescopy

scholarly journals Active Janus particles in a complex plasma

2020 ◽  
Vol 2 (3) ◽  
Author(s):  
V. Nosenko ◽  
F. Luoni ◽  
A. Kaouk ◽  
M. Rubin-Zuzic ◽  
H. Thomas
Keyword(s):  
Janus Particles ◽  
Complex Plasma

scholarly journals Thermophoresis of Janus particles at large Knudsen numbers

2018 ◽  
Vol 3 (9) ◽  
Author(s):  
Tobias Baier ◽  
Sudarshan Tiwari ◽  
Samir Shrestha ◽  
Axel Klar ◽  
Steffen Hardt
Keyword(s):  
Janus Particles ◽  
Knudsen Numbers

Investigation of Magnetic Hysteresis Properties of (Sm0.8Zr0.2)(Fe0.72Co0.24Ti0.04)10–12 Melt-Spun Ribbons

2021 ◽  
Vol 62 (9-10) ◽  
pp. 566-571
Author(s):  
A. V. Protasov ◽  
A. G. Popov ◽  
V. S. Gaviko ◽  
P. B. Terent’ev ◽  
Tiangli Zhang
Keyword(s):  
Magnetic Hysteresis ◽  
Melt Spun ◽  
Melt Spun Ribbons ◽  
Hysteresis Properties

scholarly journals Substrate wettability guided oriented self assembly of Janus particles

2021 ◽  
Vol 11 (1) ◽  
Author(s):  
Meneka Banik ◽  
Shaili Sett ◽  
Chirodeep Bakli ◽  
Arup Kumar Raychaudhuri ◽  
Suman Chakraborty ◽  
...  
Keyword(s):  
Self Assembly ◽  
Janus Particles ◽  
Water Molecules ◽  
Functional Coatings ◽  
Hexagonal Close Packed ◽  
Local Densities ◽  
Inhomogeneous Properties ◽  
Metal Polymer ◽  
Specific Orientation

AbstractSelf-assembly of Janus particles with spatial inhomogeneous properties is of fundamental importance in diverse areas of sciences and has been extensively observed as a favorably functionalized fluidic interface or in a dilute solution. Interestingly, the unique and non-trivial role of surface wettability on oriented self-assembly of Janus particles has remained largely unexplored. Here, the exclusive role of substrate wettability in directing the orientation of amphiphilic metal-polymer Bifacial spherical Janus particles, obtained by topo-selective metal deposition on colloidal Polymestyere (PS) particles, is explored by drop casting a dilute dispersion of the Janus colloids. While all particles orient with their polymeric (hydrophobic) and metallic (hydrophilic) sides facing upwards on hydrophilic and hydrophobic substrates respectively, they exhibit random orientation on a neutral substrate. The substrate wettability guided orientation of the Janus particles is captured using molecular dynamic simulation, which highlights that the arrangement of water molecules and their local densities near the substrate guide the specific orientation. Finally, it is shown that by spin coating it becomes possible to create a hexagonal close-packed array of the Janus colloids with specific orientation on differential wettability substrates. The results reported here open up new possibilities of substrate-wettability driven functional coatings of Janus particles, which has hitherto remained unexplored.

On the Radial Scalability of Magnetic Hysteresis Couplers

2021 ◽  
Author(s):  
Gianvito Gallicchio ◽  
Marco Palmieri ◽  
Francesco Cupertino ◽  
Mauro Di Nardo
Keyword(s):  
Magnetic Hysteresis
Sign in / Sign up

Export Citation Format

Share Document