Preparation of yttrium doped lithium iron(II) phosphate as cathode material using solid state reaction

2021 ◽  
Author(s):  
Wagiyo Honggowiranto ◽  
Muhammad Shalahuddin al Ja’farawy ◽  
Sudaryanto
Keyword(s):  
Solid State ◽  
Cathode Material ◽  
Solid State Reaction

Na3.12Fe2.44(P2O7)2/multi-walled carbon nanotube composite as a cathode material for sodium-ion batteries

2015 ◽  
Vol 3 (33) ◽  
pp. 17224-17229 ◽  
Author(s):  
Yubin Niu ◽  
Maowen Xu ◽  
Chuanjun Cheng ◽  
ShuJuan Bao ◽  
Junke Hou ◽  
...  
Keyword(s):  
Carbon Nanotube ◽  
Solid State ◽  
Cathode Material ◽  
Solid State Reaction ◽  
Sodium Ion ◽  
Sodium Ion Batteries ◽  
Multi Walled Carbon Nanotube ◽  
Carbon Nanotube Composite

Na3.12Fe2.44(P2O7)2/multi-walled carbon nanotube (MWCNT) composite was fabricated by a solid state reaction and was further used to fabricate a cathode for sodium-ion batteries.

Synthesis, Characterization and Electrochemical Performance of Li2Mn0.7Fe0.3SiO4 Prepared from Solid-state Reaction

2009 ◽  
Vol 620-622 ◽  
pp. 17-20 ◽  
Author(s):  
Wen Gang Liu ◽  
Yun Hua Xu ◽  
Rong Yang
Keyword(s):  
Solid State ◽  
Electrochemical Performance ◽  
Cathode Material ◽  
Solid State Reaction ◽  
High Capacity ◽  
Reversible Capacity ◽  
Solid State Reaction Method ◽  
Cycle Life ◽  
Solution Route ◽  
Better Than

Li2MSiO4(M=Mn, Co, Ni) is a potential high capacity cathode material because of its outstanding properties that exchange of two electrons per transition metal atom is possible and the theoretical capacity of Li2MSiO4 can reach as high as 330 mAhg-1. In this family, the cathode performance of Li2MnSiO4 synthesized by solution route has been published recently. However, it seems that the cycle life of Li2MnSiO4 fell short of our expectation. In this work, the Li2Mn0.7Fe0.3SiO4 cathode material was synthesized by traditional solid-state reaction method. The prepared powder was consisted of majority of Li2Mn0.7Fe0.3SiO4 and minor impurities which were examined by XRD. FESEM morphology showed that the products of Li2Mn0.7Fe0.3SiO4 and Li2MnSiO4 have similar particle size (about 50-300 nm). The electrochemical performance of Li2Mn0.7Fe0.3SiO4, especially for reversible capacity and cycle life, exhibited better than those of Li2MnSiO4.

scholarly journals Impact of Lithium Composition on Structural, Electronic and Optical Properties of Lithium Cobaltite Prepared by Solid-state Reaction

2014 ◽  
Vol 6 (2) ◽  
pp. 217-231 ◽  
Author(s):  
F. Khatun ◽  
M. A. Gafur ◽  
M. S. Ali ◽  
M. S. Islam ◽  
M. A. R. Sarker
Keyword(s):  
Optical Properties ◽  
Solid State ◽  
Ionic Conductivity ◽  
Cathode Material ◽  
Solid State Reaction ◽  
Layered Crystal ◽  
X Ray Diffraction ◽  
X Ray ◽  
Electronic And Optical Properties ◽  
Lithium Cobaltite

The lithium-cobalt oxide LixCoO2 is a promising candidate as highly active cathode material of lithium ion rechargeable batteries. The crystalline-layered lithium cobaltite has attracted increased attention due to recent discoveries of some extraordinary properties such as unconventional transport and magnetic properties. Due to layered crystal structure, Li contents (x) in LixCoO2 might play an important role on its interesting properties. LiCoO2 crystalline cathode material was prepared by using solid-state reaction synthesis, and then LixCoO2 (x<1) has been synthesized by deintercalation of produced single-phase powders. Structure and morphology of the synthesized powders were investigated by X-ray diffraction (XRD), Infrared spectroscopy, Impedance analyzer etc. The influence of lithium composition (x) on structural, electronic and optical properties of lithium cobaltite was studied. Temperature dependent electrical resistivity was measured using four-probe technique. While LixCoO2 with x = 0.9 is a semiconductor, the highly Li-deficient phase (0.75 ? x ? 0.5) exhibits metallic conductivity. The ionic conductivity of LixCoO2 (x = 0.5 – 1.15) was measured using impedance spectroscopy and maximum conductivity of Li0.5CoO2 was found to be 6.5×10-6 S/cm at 273 K. The properties that are important for applications, such as ionic conductivity, charge capacity, and optical absorption are observed to increase with Li deficiency. Keywords: Calcination; Characterization; Inorganic compounds; Solid-State reaction; X-ray diffraction. © 2014 JSR Publications. ISSN: 2070-0237 (Print); 2070-0245 (Online). All rights reserved.doi: http://dx.doi.org/10.3329/jsr.v6i2.17900 J. Sci. Res. 6 (2), 217-231 (2014)  

Synthesis and characterization of high-voltage cathode material LiNi0.5Mn1.5O4 by one-step solid-state reaction

2005 ◽  
Vol 12 (S1) ◽  
pp. 54-58 ◽  
Author(s):  
Zhi-xing Wang ◽  
Hai-sheng Fang ◽  
Zhou-lan Yin ◽  
Xin-hai Li ◽  
Hua-jun Guo ◽  
...  
Keyword(s):  
Solid State ◽  
Cathode Material ◽  
High Voltage ◽  
Solid State Reaction ◽  
Synthesis And Characterization ◽  
One Step

scholarly journals The Synthesis of LiMnxFe1−xPO4/C Cathode Material through Solvothermal Jointed with Solid-State Reaction

Materials ◽  
2016 ◽  
Vol 9 (9) ◽  
pp. 766 ◽  
Author(s):  
Xiangming He ◽  
Jixian Wang ◽  
Zhongjia Dai ◽  
Li Wang ◽  
Guangyu Tian
Keyword(s):  
Solid State ◽  
Cathode Material ◽  
Solid State Reaction
Sign in / Sign up

Export Citation Format

Share Document