Line-solitons of a two-component KP hierarchy

2021 ◽  
Vol 31 (11) ◽  
pp. 113139
Author(s):  
Changgen Hu ◽  
Chuanzhong Li
Keyword(s):  
1990 ◽  
Vol 146 (3) ◽  
pp. 115-118 ◽  
Author(s):  
Kenji Kajiwara ◽  
Junta Matsukidaira ◽  
Junkichi Satsuma

2019 ◽  
Vol 33 (31) ◽  
pp. 1950390
Author(s):  
Tao Xu ◽  
Yong Chen ◽  
Zhijun Qiao

Based on reduction of the KP hierarchy, the general multi-dark soliton solutions in Gram type determinant forms for the (2[Formula: see text]+[Formula: see text]1)-dimensional multi-component Maccari system are constructed. Especially, the two component coupled Maccari system comprising of two component short waves and single-component long waves are discussed in detail. Besides, the dynamics of one and two dark-dark solitons are analyzed. It is shown that the collisions of two dark-dark solitons are elastic by asymptotic analysis. Additionally, the two dark-dark solitons bound states are studied through two different cases (stationary and moving cases). The bound states can exist up to arbitrary order in the stationary case, however, only two-soliton bound state exists in the moving case. Besides, the oblique stationary bound state can be generated for all possible combinations of nonlinearity coefficients consisting of positive, negative and mixed cases. Nevertheless, the parallel stationary and the moving bound states are only possible when nonlinearity coefficients take opposite signs.


1990 ◽  
Vol 23 (21) ◽  
pp. 4793-4804 ◽  
Author(s):  
N C Freeman ◽  
C R Gilson ◽  
J J C Nimmo

1990 ◽  
Vol 144 (6-7) ◽  
pp. 329-332 ◽  
Author(s):  
Marcel Jaulent ◽  
Miguel A. Manna ◽  
Luis Martinez Alonso ◽  
Elena Medina Reus
Keyword(s):  

1965 ◽  
Vol 5 ◽  
pp. 109-111
Author(s):  
Frederick R. West

There are certain visual double stars which, when close to a node of their relative orbit, should have enough radial velocity difference (10-20 km/s) that the spectra of the two component stars will appear resolved on high-dispersion spectrograms (5 Å/mm or less) obtainable by use of modern coudé and solar spectrographs on bright stars. Both star images are then recorded simultaneously on the spectrograph slit, so that two stellar components will appear on each spectrogram.


Author(s):  
R.J. Mount ◽  
R.V. Harrison

The sensory end organ of the ear, the organ of Corti, rests on a thin basilar membrane which lies between the bone of the central modiolus and the bony wall of the cochlea. In vivo, the organ of Corti is protected by the bony wall which totally surrounds it. In order to examine the sensory epithelium by scanning electron microscopy it is necessary to dissect away the protective bone and expose the region of interest (Fig. 1). This leaves the fragile organ of Corti susceptible to physical damage during subsequent handling. In our laboratory cochlear specimens, after dissection, are routinely prepared by the O-T- O-T-O technique, critical point dried and then lightly sputter coated with gold. This processing involves considerable specimen handling including several hours on a rotator during which the organ of Corti is at risk of being physically damaged. The following procedure uses low cost, readily available materials to hold the specimen during processing ,preventing physical damage while allowing an unhindered exchange of fluids.Following fixation, the cochlea is dehydrated to 70% ethanol then dissected under ethanol to prevent air drying. The holder is prepared by punching a hole in the flexible snap cap of a Wheaton vial with a paper hole punch. A small amount of two component epoxy putty is well mixed then pushed through the hole in the cap. The putty on the inner cap is formed into a “cup” to hold the specimen (Fig. 2), the putty on the outside is smoothed into a “button” to give good attachment even when the cap is flexed during handling (Fig. 3). The cap is submerged in the 70% ethanol, the bone at the base of the cochlea is seated into the cup and the sides of the cup squeezed with forceps to grip it (Fig.4). Several types of epoxy putty have been tried, most are either soluble in ethanol to some degree or do not set in ethanol. The only putty we find successful is “DUROtm MASTERMENDtm Epoxy Extra Strength Ribbon” (Loctite Corp., Cleveland, Ohio), this is a blue and yellow ribbon which is kneaded to form a green putty, it is available at many hardware stores.


1997 ◽  
Vol 90 (4) ◽  
pp. 679-681
Author(s):  
F. SAIJA ◽  
G. FIUMARA ◽  
P.V. GIAQUINTA

1994 ◽  
Vol 4 (8) ◽  
pp. 1333-1362 ◽  
Author(s):  
Takashi Taniguchi ◽  
Kyozi Kawasaki ◽  
David Andelman ◽  
Toshihiro Kawakatsu

Sign in / Sign up

Export Citation Format

Share Document