Development of a forward model for Bayesian analysis of a single crystal dispersion interferometer

2021 ◽  
Vol 92 (3) ◽  
pp. 033520 ◽  
Author(s):  
Jae-seok Lee ◽  
Dong-Geun Lee ◽  
K. C. Lee ◽  
J.-W. Juhn ◽  
Y.-c. Ghim
Keyword(s):  
Bayesian Analysis ◽  
Single Crystal ◽  
Forward Model ◽  
Crystal Dispersion

Observation of dislocations in dynamically loaded Cu-SiO2

1986 ◽  
Vol 44 ◽  
pp. 424-425
Author(s):  
D. S. Pritchard
Keyword(s):  
Electron Microscope ◽  
Strain Rate ◽  
Single Crystal ◽  
Transmission Electron Microscope ◽  
Volume Fraction ◽  
Screw Dislocations ◽  
Spherical Inclusions ◽  
Transmission Electron ◽  
Crystal Dispersion ◽  
Strain Rate Loading

The effect of varying the strain rate loading conditions in compression on a copper single crystal dispersion-hardened with SiO2 particles has been examined. These particles appear as small spherical inclusions in the copper lattice and have a volume fraction of 0.6%. The structure of representative crystals was examined prior to any testing on a transmission electron microscope (TEM) to determine the nature of the dislocations initially present in the tested crystals. Only a few scattered edge and screw dislocations were viewed in those specimens.

Effect of Redistribution of the Optical Spectral Weight in CuO Nanostructured Ceramics

2010 ◽  
Vol 168-169 ◽  
pp. 285-288
Author(s):  
A.A. Makhnev ◽  
L.V. Nomerovannaya ◽  
Boris A. Gizhevskii ◽  
Sergey V. Naumov ◽  
Natalia V. Kostromitina
Keyword(s):  
Single Crystal ◽  
Absorption Edge ◽  
High Pressure Torsion ◽  
Cupric Oxide ◽  
Measurement Data ◽  
Fundamental Absorption Edge ◽  
Spectral Weight ◽  
Low Energy ◽  
Crystal Dispersion ◽  
Nanostructured Ceramics

Features of the optical properties of nanostructured samples of cupric oxide CuO prepared by shock wave loading (SWL) and by high pressure torsion (HPT) methods have been investigated by means of spectroscopic ellipsometry in the range of 0.5-5.0 eV. The results for nanostructured samples are discussed in comparison with the measurement data of the CuO single crystal. Dispersion of the components of the complex permittivity in nanostructured CuO samples is significantly different from that for the single crystal. The optical spectral density of the nanostructured CuO is redistributed from the energy region above the fundamental absorption edge to the region below the edge. The shift is unexpected strong for samples prepared by the HPT method. The intensity of the optical spectra is suppressed in the range above the fundamental absorption edge and increases in low-energy one. It has been shown that the energy positions of the main electronic transitions in nanostructured samples on the whole are the same as in the single crystal; at the same time, intensity of the low-energy transitions increases. The possible causes of this increase and resolution of the fine absorption structure of the nanostructured CuO are discussed.

The new single crystal dispersion interferometer installed on KSTAR and its first measurement

2021 ◽  
Vol 92 (3) ◽  
pp. 033536
Author(s):  
Dong-Geun Lee ◽  
K. C. Lee ◽  
J.-W. Juhn ◽  
Jae-seok Lee ◽  
Y.-c. Ghim
Keyword(s):  
Single Crystal ◽  
Crystal Dispersion

A Preparation of High Resolution Standards for Electron Microscopy. Part II

1971 ◽  
Vol 29 ◽  
pp. 160-161
Author(s):  
Akira Tanaka ◽  
David F. Harling
Keyword(s):  
Electron Microscopy ◽  
High Resolution ◽  
Carbon Black ◽  
Single Crystal ◽  
Dark Field ◽  
Graphitized Carbon Black ◽  
Graphitized Carbon ◽  
Dark Field Imaging ◽  
Crystal Films ◽  
Micro Holes

In the previous paper, the author reported on a technique for preparing vapor-deposited single crystal films as high resolution standards for electron microscopy. The present paper is intended to describe the preparation of several high resolution standards for dark field microscopy and also to mention some results obtained from these studies. Three preparations were used initially: 1.) Graphitized carbon black, 2.) Epitaxially grown particles of different metals prepared by vapor deposition, and 3.) Particles grown epitaxially on the edge of micro-holes formed in a gold single crystal film.The authors successfully obtained dark field micrographs demonstrating the 3.4Å lattice spacing of graphitized carbon black and the Au single crystal (111) lattice of 2.35Å. The latter spacing is especially suitable for dark field imaging because of its preparation, as in 3.), above. After the deposited film of Au (001) orientation is prepared at 400°C the substrate temperature is raised, resulting in the formation of many square micro-holes caused by partial evaporation of the Au film.

Structure of Palladium Single-Crystal Films Prepared by Flash Evaporation onto (001) NaCl Substrates

1970 ◽  
Vol 28 ◽  
pp. 456-457
Author(s):  
L. E. Murr ◽  
G. Wong
Keyword(s):  
Single Crystal ◽  
High Vacuum ◽  
Ultra High Vacuum ◽  
High Rate ◽  
Flash Evaporation ◽  
Optimum Load ◽  
Single Crystal Films ◽  
Crystal Films ◽  
A Current

Palladium single-crystal films have been prepared by Matthews in ultra-high vacuum by evaporation onto (001) NaCl substrates cleaved in-situ, and maintained at ∼ 350° C. Murr has also produced large-grained and single-crystal Pd films by high-rate evaporation onto (001) NaCl air-cleaved substrates at 350°C. In the present work, very large (∼ 3cm2), continuous single-crystal films of Pd have been prepared by flash evaporation onto air-cleaved (001) NaCl substrates at temperatures at or below 250°C. Evaporation rates estimated to be ≧ 2000 Å/sec, were obtained by effectively short-circuiting 1 mil tungsten evaporation boats in a self-regulating system which maintained an optimum load current of approximately 90 amperes; corresponding to a current density through the boat of ∼ 4 × 104 amperes/cm2.

Dislocations, Ordering and Antiferromagnetic Domains in MnO

1970 ◽  
Vol 28 ◽  
pp. 522-523
Author(s):  
D. J. Barber ◽  
R. G. Evans
Keyword(s):  
Electron Diffraction ◽  
Single Crystal ◽  
Optical Microscopy ◽  
Defect Chemistry ◽  
Magnetic Structures ◽  
Optically Transparent ◽  
Magnetic Features ◽  
Antiferromagnetic Domains

Manganese (II) oxide, MnO, in common with CoO, NiO and FeO, possesses the NaCl structure and shows antiferromagnetism below its Neel point, Tn∼ 122 K. However, the defect chemistry of the four oxides is different and the magnetic structures are not identical. The non-stoichiometry in MnO2 small (∼2%) and below the Tn the spins lie in (111) planes. Previous work reported observations of magnetic features in CoO and NiO. The aim of our work was to find explanations for certain resonance results on antiferromagnetic MnO.Foils of single crystal MnO were prepared from shaped discs by dissolution in a mixture of HCl and HNO3. Optical microscopy revealed that the etch-pitted foils contained cruciform-shaped precipitates, often thick and proud of the surface but red-colored when optically transparent (MnO is green). Electron diffraction and probe microanalysis indicated that the precipitates were Mn2O3, in contrast with recent findings of Co3O4 in CoO.

Electron Microscopy of Shock Loaded Polycrystalline Beryllium

1974 ◽  
Vol 32 ◽  
pp. 506-507 ◽  
Author(s):  
J. M. Galbraith ◽  
L. E. Murr ◽  
A. L. Stevens
Keyword(s):  
Electron Microscopy ◽  
Wave Propagation ◽  
Structural Change ◽  
Single Crystal ◽  
Diffraction Pattern ◽  
Shock Loading ◽  
Slip Systems ◽  
Compression Tests ◽  
X Ray Diffraction ◽  
X Ray

Uniaxial compression tests and hydrostatic tests at pressures up to 27 kbars have been performed to determine operating slip systems in single crystal and polycrystal1ine beryllium. A recent study has been made of wave propagation in single crystal beryllium by shock loading to selectively activate various slip systems, and this has been followed by a study of wave propagation and spallation in textured, polycrystal1ine beryllium. An alteration in the X-ray diffraction pattern has been noted after shock loading, but this alteration has not yet been correlated with any structural change occurring during shock loading of polycrystal1ine beryllium.This study is being conducted in an effort to characterize the effects of shock loading on textured, polycrystal1ine beryllium. Samples were fabricated from a billet of Kawecki-Berylco hot pressed HP-10 beryllium.

Studies of Oxide Formation on Copper Thin Films by Electron Microscopy

1977 ◽  
Vol 35 ◽  
pp. 316-317
Author(s):  
G. G. Hembree ◽  
M. A. Otooni ◽  
J. M. Cowley
Keyword(s):  
Electron Microscopy ◽  
Electron Diffraction ◽  
Single Crystal ◽  
Crystal Surface ◽  
Crystal Defects ◽  
Diffraction Reflection ◽  
Reaction Products ◽  
Intermediate Energies ◽  
Crystal Films ◽  
Reflection Electron Microscopy

The formation of oxide structures on single crystal films of metals has been investigated using the REMEDIE system (for Reflection Electron Microscopy and Electron Diffraction at Intermediate Energies) (1). Using this instrument scanning images can be obtained with a 5 to 15keV incident electron beam by collecting either secondary or diffracted electrons from the crystal surface (2). It is particularly suited to studies of the present sort where the surface reactions are strongly related to surface morphology and crystal defects and the growth of reaction products is inhomogeneous and not adequately described in terms of a single parameter. Observation of the samples has also been made by reflection electron diffraction, reflection electron microscopy and replication techniques in a JEM-100B electron microscope.A thin single crystal film of copper, epitaxially grown on NaCl of (100) orientation, was repositioned on a large copper single crystal of (111) orientation.

Mechanical Properties and Dislocation Structure of Single Crystal Cdte Deformed in Compression at 300°C

1976 ◽  
Vol 34 ◽  
pp. 592-593
Author(s):  
Ernest L. Hall ◽  
J. B. Vander Sande
Keyword(s):  
Mechanical Properties ◽  
Single Crystal ◽  
Dislocation Structure ◽  
Room Temperature ◽  
Elevated Temperatures ◽  
Strain Curve ◽  
Optical Devices ◽  
Semiconductor Compound ◽  
Wide Range ◽  
Sample Orientation

The present paper describes research on the mechanical properties and related dislocation structure of CdTe, a II-VI semiconductor compound with a wide range of uses in electrical and optical devices. At room temperature CdTe exhibits little plasticity and at the same time relatively low strength and hardness. The mechanical behavior of CdTe was examined at elevated temperatures with the goal of understanding plastic flow in this material and eventually improving the room temperature properties. Several samples of single crystal CdTe of identical size and crystallographic orientation were deformed in compression at 300°C to various levels of total strain. A resolved shear stress vs. compressive glide strain curve (Figure la) was derived from the results of the tests and the knowledge of the sample orientation.

Sign in / Sign up

Export Citation Format

Share Document