Nonradiative subdiffraction near-field patterns using metagratings

2021 ◽  
Vol 118 (13) ◽  
pp. 131105
Author(s):  
Oshri Rabinovich ◽  
Ariel Epstein
Keyword(s):  
2021 ◽  
Vol 8 ◽  
Author(s):  
Jiaqi Han ◽  
Long Li ◽  
Shuncheng Tian ◽  
Xiangjin Ma ◽  
Qiang Feng ◽  
...  

This article presents a holographic metasurface antenna with stochastically distributed surface impedance, which produces randomly frequency-diverse radiation patterns. Low mutual coherence electric field patterns generated by the holographic metasurface antenna can cover the K-band from 18 to 26 GHz with 0.1 GHz intervals. By utilizing the frequency-diverse holographic metasurface (FDHM) antenna, we build a near-field microwave computational imaging system based on reflected signals in the frequency domain. A standard horn antenna is adopted to acquire frequency domain signals radiated from the proposed FDHM antenna. A detail imaging restoration process is presented, and the desired targets are correctly reconstructed using the 81 frequency-diverse patterns through full-wave simulation studies. Compressed sensing technique and iterative shrinkage/thresholding algorithms are applied for the imaging reconstruction. The achieved compressive ratio of this computational imaging system on the physical layer is 30:1.


2017 ◽  
Vol 50 (3) ◽  
pp. 701-711 ◽  
Author(s):  
Qi Zhong ◽  
Lars Melchior ◽  
Jichang Peng ◽  
Qiushi Huang ◽  
Zhanshan Wang ◽  
...  

Iterative phase retrieval has been used to reconstruct the near-field distribution behind tailored X-ray waveguide arrays, by inversion of the measured far-field pattern recorded under fully coherent conditions. It is thereby shown that multi-waveguide interference can be exploited to control the near-field distribution behind the waveguide exit. This can, for example, serve to create a secondary quasi-focal spot outside the waveguide structure. For this proof of concept, an array of seven planar Ni/C waveguides are used, with precisely varied guiding layer thickness and cladding layer thickness, as fabricated by high-precision magnetron sputtering systems. The controlled thickness variations in the range of 0.2 nm results in a desired phase shift of the different waveguide beams. Two kinds of samples, a one-dimensional waveguide array and periodic waveguide multilayers, were fabricated, each consisting of seven C layers as guiding layers and eight Ni layers as cladding layers. These are shown to yield distinctly different near-field patterns.


1995 ◽  
Vol 37 (6) ◽  
pp. 7-15 ◽  
Author(s):  
M.H. Francis ◽  
A.C. Newell ◽  
K.R. Grimm ◽  
J. Hoffman ◽  
H.E. Schrank

2012 ◽  
Vol 2012 ◽  
pp. 1-7 ◽  
Author(s):  
Shirook M. Ali ◽  
Huanhuan Gu ◽  
Kelce Wilson ◽  
James Warden

A novel and practical approach is presented providing improved antenna performance without enlarging the antenna or the ground plane. The approach electrically extends the ground plane using wire(s) that behave as surface metal extensions of the ground plane. The wire extensions can be accommodated within typical handset housing or as part of the stylish metal used on the handset’s exterior perimeter; hence don’t require enlargement of the device. Consequently, this approach avoids the costs and limitations traditionally associated with physically lengthening of a ground plane. Eight variations are presented and compared with baseline antenna performance. Both far-field patterns and near-field electromagnetic scans demonstrate that the proposed approach controls the electrical length of the ground plane and hence its chassis wavemodes, without negatively impacting the characteristics of the antenna. Improvements in performance of up to 56% in bandwidth at 900 MHz and up to 12% in efficiency with a reduction of up to 12% in the specific absorption rate (SAR) are achieved. An 8% increase in efficiency with a 1.3% improvement in bandwidth and a 20% reduction in SAR is achieved at 1880 MHz. Thus, improvements in bandwidth are achieved without compromising efficiency. Further, improvements at lower frequencies do not compromise performance at higher frequencies.


2015 ◽  
Vol 17 (1) ◽  
pp. 82-90 ◽  
Author(s):  
Tae-Bong Lee ◽  
Min-Nyeon Kim

Purpose – The purpose of this paper is to analyze far and near field emitted field patterns through more exact calculation of the modes formed in finite periodic dielectric gratings. Design/methodology/approach – For the mode calculation, equations are newly defined by applying vertical boundary condition on the assumption that transverse electric modes are generated in the structure. After finding modes, near field patterns are calculated using the wave number and coefficient of the mode. Findings – Additionally, the results from these calculations are compared with that of the rigorous-coupled method. Finally, far field patterns are derived by applying fast Fourier transform to near field patterns and also compared with the results of rigorous-coupled method. Research limitations/implications – For convenience of coordinate, we use rectangular coordinate, though the shape of radome is a hemisphere. Practical implications – In this paper, the authors derive more exact near field patterns without the assumption of infiniteness so that these results can be used practically for a making real frequency-selective structure. Originality/value – Conventional periodic finite dielectric gratings analysis has been done using Floquet–Bloch wave theory, coupled-mode, rigorous-coupled method which is based on the assumption of infiniteness of the structure.


Nanophotonics ◽  
2021 ◽  
Vol 0 (0) ◽  
Author(s):  
Vladimir R. Tuz ◽  
Andrey B. Evlyukhin

Abstract The phenomenon of anapole has attracted considerable attention in the field of metamaterials as a possible realization of radiationless objects. We comprehensively study this phenomenon in the cluster-based systems of dielectric particles by considering conditions of anapole manifestation in both single trimers of disk-shaped particles and metamaterial composed on such trimers. Our analytical approach is based on the multipole decomposition method and the secondary multipole decomposition technique. They allow us to associate the anapole with the multipole moments of the trimer and the separate multipole moments of its constitutive particles. The manifestation of anapole in a two-dimensional metamaterial (metasurface) is confirmed by checking the resonant states in the reflected field as well as from the electromagnetic near-field patterns obtained from the full-wave numerical simulation. It is demonstrated that the anapole excitation in trimers results in the polarization-independent suppression of reflection with the resonant enhancement of local electromagnetic fields in the metasurface. Finally, experimental verification of the theoretical results is presented and discussed.


Sign in / Sign up

Export Citation Format

Share Document