scholarly journals On the validity of force balance models for predicting gravity-induced detachment of pendant drops and bubbles

2020 ◽  
Vol 32 (10) ◽  
pp. 101703
Author(s):  
Alok Kumar ◽  
Madhu Ranjan Gunjan ◽  
Rishi Raj
Keyword(s):  
Force Balance ◽  
Pendant Drops

A New Generation of Tools for the Design of Tall Buildings Subjected to Wind Loads

2008 ◽  
Author(s):  
Emil Simiu ◽  
Rene D. Gabbai
Keyword(s):  
Structural Engineering ◽  
Tall Buildings ◽  
Building Envelope ◽  
Force Balance ◽  
Wind Loads ◽  
Individual Member ◽  
Engineering Practice ◽  
Wind Effects ◽  
Uncertainty Estimates ◽  
Internal Forces

Current approaches to the estimation of wind-induced wind effects on tall buildings are based largely on 1970s and 1980s technology, and were shown to result in some cases in errors of up to 40%. Improvements are needed in: (i) the description of direction-dependent aerodynamics; (ii) the description of the direction-dependent extreme wind climate; (iii) the estimation of inertial wind effects induced by fluctuating aerodynamic forces acting on the entire building envelope; (iv) the estimation of uncertainties inherent in the wind effects; and (v) the use of applied wind forces, calculated inertial forces, and uncertainty estimates, to obtain via influence coefficients accurate and risk-consistent estimates of wind-induced internal forces or demand-to-capacity ratios for any individual structural member. Methods used in current wind engineering practice are especially deficient when the distribution of the wind loads over the building surface and their effects at levels other than the building base are not known, as is the case when measurements are obtained by the High-Frequency Force Balance method, particularly in the presence of aerodynamic interference effects due to neighboring buildings. The paper describes a procedure that makes it possible to estimate wind-induced internal forces and demand-to-capacity ratios in any individual member by: developing aerodynamic and wind climatological data sets, as well as aerodynamic/climatological directional interaction models; significantly improving the quality of the design via rigorous structural engineering methods made possible by modern computational resources; and properly accounting for knowledge uncertainties. The paper covers estimates of wind effects required for allowable stress design, wherein knowledge uncertainties pertaining to the parameters that determine the wind loading are not considered, as well as estimates required for strength design, in which these uncertainties need to be accounted for explicitly.

scholarly journals Study on the Effect of Nanoparticle Used in Nano-Fluid Flooding on Droplet–Interface Electro-Coalescence

Nanomaterials ◽  
2021 ◽  
Vol 11 (7) ◽  
pp. 1764
Author(s):  
Donghai Yang ◽  
Huayao Sun ◽  
Qing Chang ◽  
Yongxiang Sun ◽  
Limin He
Keyword(s):  
Interfacial Tension ◽  
Oil Recovery ◽  
Liquid Bridge ◽  
High Speed ◽  
Droplet Formation ◽  
Force Balance ◽  
Secondary Droplet ◽  
Droplet Deformation ◽  
Deformation Degree ◽  
Nano Fluid

Nano-fluid flooding is a new method capable of improving oil recovery; however, nanoparticles (NPs) significantly affect electric dehydration, which has rarely been investigated. The effect of silica (SiO2) NPs on the droplet–interface coalescence was investigated using a high-speed digital camera under an electric field. The droplet experienced a fall, coalescence, and secondary droplet formation. The results revealed that the oil–water interfacial tension and water conductivity changed because of the SiO2 NPs. The decrease of interfacial tension facilitated droplet deformation during the falling process. However, with the increase of particle concentration, the formed particle film inhibited the droplet deformation degree. Droplet and interface are connected by a liquid bridge during coalescence, and the NP concentration also resulted in the shape of this liquid bridge changing. The increase of NP concentration inhibited the horizontal contraction of the liquid bridge while promoting vertical collapse. As a result, it did not facilitate secondary droplet formation. Moreover, the droplet falling velocity decreased, while the rising velocity of the secondary droplet increased. Additionally, the inverse calculation of the force balance equation showed that the charge of the secondary droplet also increased. This is attributed to nanoparticle accumulation, which resulted in charge accumulation on the top of the droplet.

scholarly journals Velocity bias in intrusive gas-liquid flow measurements

2021 ◽  
Vol 12 (1) ◽  
Author(s):  
B. Hohermuth ◽  
M. Kramer ◽  
S. Felder ◽  
D. Valero
Keyword(s):  
Liquid Flow ◽  
Breaking Waves ◽  
Correction Method ◽  
Force Balance ◽  
Bubble Velocity ◽  
Natural Environments ◽  
Flow Measurements ◽  
Gas Liquid Flow ◽  
Liquid Flows ◽  
Velocity Bias

AbstractGas–liquid flows occur in many natural environments such as breaking waves, river rapids and human-made systems, including nuclear reactors and water treatment or conveyance infrastructure. Such two-phase flows are commonly investigated using phase-detection intrusive probes, yielding velocities that are considered to be directly representative of bubble velocities. Using different state-of-the-art instruments and analysis algorithms, we show that bubble–probe interactions lead to an underestimation of the real bubble velocity due to surface tension. To overcome this velocity bias, a correction method is formulated based on a force balance on the bubble. The proposed methodology allows to assess the bubble–probe interaction bias for various types of gas-liquid flows and to recover the undisturbed real bubble velocity. We show that the velocity bias is strong in laboratory scale investigations and therefore may affect the extrapolation of results to full scale. The correction method increases the accuracy of bubble velocity estimations, thereby enabling a deeper understanding of fundamental gas-liquid flow processes.

scholarly journals Predicting Critical Heat Flux With Multiphase CFD: 4 Years in the Making

2017 ◽  
Author(s):  
Emilio Baglietto ◽  
Etienne Demarly ◽  
Ravikishore Kommajosyula
Keyword(s):  
Heat Transfer ◽  
Heat Flux ◽  
Critical Heat Flux ◽  
Bubble Dynamics ◽  
Flow Boiling ◽  
Heated Surface ◽  
Force Balance ◽  
Modeling Framework ◽  
Lift Off ◽  
Limiting Condition

Advancement in the experimental techniques have brought new insights into the microscale boiling phenomena, and provide the base for a new physical interpretation of flow boiling heat transfer. A new modeling framework in Computational Fluid Dynamics has been assembled at MIT, and aims at introducing all necessary mechanisms, and explicitly tracks: (1) the size and dynamics of the bubbles on the surface; (2) the amount of microlayer and dry area under each bubble; (3) the amount of surface area influenced by sliding bubbles; (4) the quenching of the boiling surface following a bubble departure and (5) the statistical bubble interaction on the surface. The preliminary assessment of the new framework is used to further extend the portability of the model through an improved formulation of the force balance models for bubble departure and lift-off. Starting from this improved representation at the wall, the work concentrates on the bubble dynamics and dry spot quantification on the heated surface, which governs the Critical Heat Flux (CHF) limit. A new proposition is brought forward, where Critical Heat Flux is a natural limiting condition for the heat flux partitioning on the boiling surface. The first principle based CHF is qualitatively demonstrated, and has the potential to deliver a radically new simulation technique to support the design of advanced heat transfer systems.

The evaporation of sessile or pendant drops in still air

1977 ◽  
Vol 61 (2) ◽  
pp. 336-350 ◽  
Author(s):  
R.G Picknett ◽  
R Bexon
Keyword(s):  
Pendant Drops

scholarly journals The Role of Hyaluronic Acid in Cartilage Boundary Lubrication

Cells ◽  
2020 ◽  
Vol 9 (7) ◽  
pp. 1606 ◽  
Author(s):  
Weifeng Lin ◽  
Zhang Liu ◽  
Nir Kampf ◽  
Jacob Klein
Keyword(s):  
Hyaluronic Acid ◽  
Synovial Fluid ◽  
Surface Force ◽  
Force Balance ◽  
New Paradigm ◽  
Low Friction ◽  
Cartilage Surface ◽  
Boundary Lubricant ◽  
Lipid Layers

Hydration lubrication has emerged as a new paradigm for lubrication in aqueous and biological media, accounting especially for the extremely low friction (friction coefficients down to 0.001) of articular cartilage lubrication in joints. Among the ensemble of molecules acting in the joint, phosphatidylcholine (PC) lipids have been proposed as the key molecules forming, in a complex with other molecules including hyaluronic acid (HA), a robust layer on the outer surface of the cartilage. HA, ubiquitous in synovial joints, is not in itself a good boundary lubricant, but binds the PC lipids at the cartilage surface; these, in turn, massively reduce the friction via hydration lubrication at their exposed, highly hydrated phosphocholine headgroups. An important unresolved issue in this scenario is why the free HA molecules in the synovial fluid do not suppress the lubricity by adsorbing simultaneously to the opposing lipid layers, i.e., forming an adhesive, dissipative bridge between them, as they slide past each other during joint articulation. To address this question, we directly examined the friction between two hydrogenated soy PC (HSPC) lipid layers (in the form of liposomes) immersed in HA solution or two palmitoyl–oleoyl PC (POPC) lipid layers across HA–POPC solution using a surface force balance (SFB). The results show, clearly and surprisingly, that HA addition does not affect the outstanding lubrication provided by the PC lipid layers. A possible mechanism indicated by our data that may account for this is that multiple lipid layers form on each cartilage surface, so that the slip plane may move from the midplane between the opposing surfaces, which is bridged by the HA, to an HA-free interface within a multilayer, where hydration lubrication is freely active. Another possibility suggested by our model experiments is that lipids in synovial fluid may complex with HA, thereby inhibiting the HA molecules from adhering to the lipids on the cartilage surfaces.

Sign in / Sign up

Export Citation Format

Share Document