On the spanwise correlation of vortex shedding from a circular cylinder at high subcritical Reynolds number

1994 ◽  
Vol 6 (7) ◽  
pp. 2406-2416 ◽  
Author(s):  
Stefan Szepessy
Keyword(s):  
Reynolds Number ◽  
Circular Cylinder ◽  
Vortex Shedding

Vortex shedding from a circular cylinder in moderate-Reynolds-number shear flow

1980 ◽  
Vol 101 (4) ◽  
pp. 721-735 ◽  
Author(s):  
Masaru Kiya ◽  
Hisataka Tamura ◽  
Mikio Arie
Keyword(s):  
Reynolds Number ◽  
Circular Cylinder ◽  
Shear Flow ◽  
Vortex Shedding ◽  
Transverse Velocity ◽  
Number Range ◽  
Uniform Shear ◽  
Reynolds Number Range ◽  
Moderate Reynolds Number ◽  
Shear Parameter

The frequency of vortex shedding from a circular cylinder in a uniform shear flow and the flow patterns around it were experimentally investigated. The Reynolds number Re, which was defined in terms of the cylinder diameter and the approaching velocity at its centre, ranged from 35 to 1500. The shear parameter, which is the transverse velocity gradient of the shear flow non-dimensionalized by the above two quantities, was varied from 0 to 0·25. The critical Reynolds number beyond which vortex shedding from the cylinder occurred was found to be higher than that for a uniform stream and increased approximately linearly with increasing shear parameter when it was larger than about 0·06. In the Reynolds-number range 43 < Re < 220, the vortex shedding disappeared for sufficiently large shear parameters. Moreover, in the Reynolds-number range 100 < Re < 1000, the Strouhal number increased as the shear parameter increased beyond about 0·1.

scholarly journals Effect of Cylinder Gap Ratio on The Wake of a Circular Cylinder Enclosed by Various Perforated Shrouds

CFD letters ◽  
2021 ◽  
Vol 13 (4) ◽  
pp. 51-68
Author(s):  
Nurul Azihan Ramli ◽  
Azlin Mohd Azmi ◽  
Ahmad Hussein Abdul Hamid ◽  
Zainal Abidin Kamarul Baharin ◽  
Tongming Zhou
Keyword(s):  
Reynolds Number ◽  
Circular Cylinder ◽  
Vortex Shedding ◽  
Control Method ◽  
Lift Coefficient ◽  
Base Case ◽  
Bluff Bodies ◽  
Ansys Fluent ◽  
Gap Ratio ◽  
Spacing Ratio

Flow over bluff bodies produces vortex shedding in their wake regions, leading to structural failure from the flow-induced forces. In this study, a passive flow control method was explored to suppress the vortex shedding from a circular cylinder that causes many problems in engineering applications. Perforated shrouds were used to control the vortex shedding of a circular cylinder at Reynolds number, Re = 200. The shrouds were of non-uniform and uniform holes with 67% porosity. The spacing gap ratio between the shroud and the cylinder was set at 1.2, 1.5, 2, and 2.2. The analysis was conducted using ANSYS Fluent using a viscous laminar model. The outcomes of the simulation of the base case were validated with existing studies. The drag coefficient, Cd, lift coefficient, Cl and the Strouhal number, St, as well as vorticity contours, velocity contours, and pressure contours were examined. Vortex shedding behind the shrouded cylinders was observed to be suppressed and delayed farther downstream with increasing gap ratio. The effect was significant for spacing ratio greater than 2.0. The effect of hole types: uniform and non-uniform holes, was also effective at these spacing ratios for the chosen Reynolds number of 200. Specifically, a spacing ratio of 1.2 enhanced further the vortex intensity and should be avoided.

Laminar Forced Convection From a Circular Cylinder Placed in a Micropolar Fluid

2006 ◽  
Vol 129 (3) ◽  
pp. 256-264 ◽  
Author(s):  
F. M. Mahfouz
Keyword(s):  
Reynolds Number ◽  
Circular Cylinder ◽  
Prandtl Number ◽  
Drag Coefficient ◽  
Forced Convection ◽  
Vortex Shedding ◽  
Micropolar Fluid ◽  
Clear Trend ◽  
Thermal Fields ◽  
Laminar Forced Convection

In this paper laminar forced convection associated with the cross-flow of micropolar fluid over a horizontal heated circular cylinder is investigated. The conservation equations of mass, linear momentum, angular momentum and energy are solved to give the details of flow and thermal fields. The flow and thermal fields are mainly influenced by Reynolds number, Prandtl number and material parameters of micropolar fluid. The Reynolds number is considered up to 200 while the Prandtl number is fixed at 0.7. The dimensionless vortex viscosity is the only material parameter considered in this study and is selected in the range from 0 to 5. The study has shown that generally the mean heat transfer decreases as the vortex viscosity increases. The results have also shown that both the natural frequency of vortex shedding and the amplitude of oscillating lift force experience clear reduction as the vortex viscosity increases. Moreover, the study showed that there is a threshold value for vortex viscosity above which the flow over the cylinder never responds to perturbation and stays symmetric without vortex shedding. Regarding drag coefficient, the results have revealed that within the selected range of controlling parameters the drag coefficient does not show a clear trend as the vortex viscosity increases.

Numerical Simulation of Vortex Shedding From a Circular Cylinder in the Presence of a Free Surface

2003 ◽  
Author(s):  
S. Nagaya ◽  
R. E. Baddour
Keyword(s):  
Numerical Simulation ◽  
Reynolds Number ◽  
Free Surface ◽  
Circular Cylinder ◽  
Vortex Shedding ◽  
Fluid Flows ◽  
Reynolds Numbers ◽  
Cfd Simulations ◽  
Induced Drag

CFD simulations of crossflows around a 2-D circular cylinder and the resulting vortex shedding from the cylinder are conducted in the present study. The capability of the CFD solver for vortex shedding simulation from a circular cylinder is validated in terms of the induced drag and lifting forces and associated Strouhal numbers computations. The validations are done for uniform horizontal fluid flows at various Reynolds numbers in the range 103 to 5×105. Crossflows around the circular cylinder beneath a free surface are also simulated in order to investigate the characteristics of the interaction between vortex shedding and a free surface at Reynolds number 5×105. The influence of the presence of the free surface on the vortex shedding due to the cylinder is discussed.

Numerical Simulation of Vortex Shedding Past a Circular Cylinder in a Cross-Flow at Low Reynolds Number With Finite Volume-Technique: Part 1 — Forced Oscillations

2007 ◽  
Author(s):  
Antoine Placzek ◽  
Jean-Franc¸ois Sigrist ◽  
Aziz Hamdouni
Keyword(s):  
Numerical Simulation ◽  
Reynolds Number ◽  
Circular Cylinder ◽  
Finite Volume ◽  
Vortex Shedding ◽  
Stokes Equations ◽  
Cross Flow ◽  
Forced Oscillations ◽  
Lift And Drag ◽  
Wake Characteristics

The numerical simulation of the flow past a circular cylinder forced to oscillate transversely to the incident stream is presented here for a fixed Reynolds number equal to 100. The 2D Navier-Stokes equations are solved with a classical Finite Volume Method with an industrial CFD code which has been coupled with a user subroutine to obtain an explicit staggered procedure providing the cylinder displacement. A preliminary work is conducted in order to check the computation of the wake characteristics for Reynolds numbers smaller than 150. The Strouhal frequency fS, the lift and drag coefficients CL and CD are thus controlled among other parameters. The simulations are then performed with forced oscillations f0 for different frequency rations F = f0/fS in [0.50–1.50] and an amplitude A varying between 0.25 and 1.25. The wake characteristics are analysed using the time series of the fluctuating aerodynamic coefficients and their FFT. The frequency content is then linked to the shape of the phase portrait and to the vortex shedding mode. By choosing interesting couples (A,F), different vortex shedding modes have been observed, which are similar to those of the Williamson-Roshko map.

On vortex formation from a cylinder. Part 1. The initial instability

1988 ◽  
Vol 190 ◽  
pp. 491-512 ◽  
Author(s):  
M. F. Unal ◽  
D. Rockwell
Keyword(s):  
Reynolds Number ◽  
Kinetic Energy ◽  
Circular Cylinder ◽  
Shear Layer ◽  
Vortex Shedding ◽  
Vortex Formation ◽  
Absolute Instability ◽  
Near Wake ◽  
Lower Range ◽  
Fluctuation Amplitude

Vortex shedding from a circular cylinder is examined over a tenfold range of Reynolds number, 440 ≤ Re ≤ 5040. The shear layer separating from the cylinder shows, to varying degrees, an exponential variation of fluctuating kinetic energy with distance downstream of the cylinder. The characteristics of this unsteady shear layer are interpreted within the context of an absolute instability of the near wake. At the trailing-end of the cylinder, the fluctuation amplitude of the instability correlates well with previously measured values of mean base pressure. Moreover, this amplitude follows the visualized vortex formation length as Reynolds number varies. There is a drastic decrease in this near-wake fluctuation amplitude in the lower range of Reynolds number and a rapid increase at higher Reynolds number. These trends are addressed relative to the present, as well as previous, observations.

On vortex shedding from a circular cylinder in the critical Reynolds number régime

1969 ◽  
Vol 37 (3) ◽  
pp. 577-585 ◽  
Author(s):  
P. W. Bearman
Keyword(s):  
Reynolds Number ◽  
Circular Cylinder ◽  
Strouhal Number ◽  
Vortex Shedding ◽  
Critical Reynolds Number ◽  
Narrow Band ◽  
Critical Regime ◽  
Number Range ◽  
Velocity Fluctuations ◽  
Reynolds Number Range

The flow around a circular cylinder has been examined over the Reynolds number range 105 to 7·5 × 105, Reynolds number being based on cylinder diameter. Narrow-band vortex shedding has been observed up to a Reynolds number of 5·5 × 105, i.e. well into the critical régime. At this Reynolds number the Strouhal number reached the unusually high value of 0·46. Spectra of the velocity fluctuations measured in the wake are presented for several values of Reynolds number.

Sign in / Sign up

Export Citation Format

Share Document