Striations of the convective type and feedback in low-pressure mercury/noble-gas discharges

1985 ◽  
Vol 28 (10) ◽  
pp. 3034 ◽  
Author(s):  
F. C. van den Heuvel ◽  
Q. H. F. Vrehen
1962 ◽  
Vol 33 (1) ◽  
pp. 230-231 ◽  
Author(s):  
C. Y. Bartholomew ◽  
G. Cassidy ◽  
A. R. LaPadula
Keyword(s):  

1999 ◽  
Author(s):  
Fang Yan ◽  
Bakhtier Farouk

Abstract High Knudsen (Kn) number flows are found in vacuum and micro-scale systems. Such flows are characterized by non-continuum behavior. For gases, the flows are usually in the slip or transition regimes. In this paper, the direct simulation Monte Carlo (DSMC) method has been applied to compute low pressure, high Kn flow fields in partially heated channels. Computations were carried out for nitrogen, argon, hydrogen, oxygen and noble gas mixtures. Variation of the Kn is obtained by reducing the pressure while keeping the channel width constant. Nonlinear pressure profiles along the channel centerline are observed. Heat transfer from the channel walls is also calculated and compared with the Graetz solution. The effects of varying pressure, inlet flow and gas transport properties (Kn, Reynolds number, Re and the Prandtl number, Pr respectively) on the wall heat transfer (Nu) were examined. A simplified correlation for predicting Nu¯ as a function of Pe¯ and Kn¯ is presented.


2002 ◽  
Vol 2 (4) ◽  
pp. 189-195
Author(s):  
Z.D. Nikitovic

Vacuum system set-up is presented and used for calibration of pressure gauges in the region of rough vacuum, from 103 mbar to 10-1 mbar, with dry air. The capacitance manometer is used for the calibration of piezoresistant manometer, oil, mercury and mercury micrometers U manometers. The applicability of the experimental set-up and obtained results for the low pressure gauges calibration in the medium and high vacuum region is approved. It was shown how calibration of some cheaper pressure gauges might be performed and reliable measurements of the pressure may be made in the region that is of interest for atomic and molecular collision physics and low-pressure gas discharges. It was also shown that mentioned calibration procedure could be used for calibration of different U manometer types in order to renormalize older atomic and molecular collision data.


Sign in / Sign up

Export Citation Format

Share Document