The influence of constraint loading conditions on deformation and fracture of polycrystals

2019 ◽  
Author(s):  
M. Sergeev ◽  
R. Balokhonov ◽  
A. Zemlianov
Author(s):  
В.В. Совгира ◽  
В.Н. Совгира

В статье приведены особенности процесса интенсивности развития деструкций, псевдопластического деформирования и разрушения однородно и неоднородно сжатого тяжелого бетона прочностью в диапазоне fc,10 = 23,6; 40,8; 71,0 МПа [2…5 и др.] и отмечаемое отличие процесса интенсивности развития деструкций, деформирования и разрушения одноосно сжатого тяжелого, мелкозернистого и керамзитового бетона прочностью fc,10 = 50,2; 54,9 и 36,9 МПа при «мягком» и «жестком» режимах нагружения одноосно сжатых бетонных призматических колонн 5 типоразмера. Выполнен анализ литературных источников с исследованиями изменения упруго-пластических характеристик vc, Еcsek тяжелого, мелкозернистого и конструкционного керамзитового бетона с учетом влияния значимых факторов и их изменение с увеличением уровня нагрузки при описании зависимости σc-εcх. Установлено, что рекомендованные строительными нормами vcи, и Ес одноосно сжатого бетона количественно и качественно не отражают характер изменения упруго-пластических свойств тяжелого, керамзитового и мелкозернистого бетона (цементно-песчаной матрицы) центрально сжатого бетона с ростом уровня нагрузки. Предложены аналитические выражения зависимости σc-εcх, описывающие опытные значения диаграмм деформирования одноосно сжатого тяжелого, мелкозернистого (цементно-песчаной матрицы) и керамзитобетона серии В призменной прочностью fc,10 =50,2; 54,9 и 36,9 МПа исследованных бетонных образцов 5 группы типоразмеров с «мягким» и «жестким» режимами нагружения. Приведены исследования, свидетельствующие о том, что механизм деформирования и процесс развития деструкций (разуплотнения) структуры цементного камня, тяжелого, мелкозернистого и керамзитобетона с ростом уровня нагрузки отражаются на нелинейном характере изменения упруго-пластических свойств: vc -коэффициента упругости; секущего модуля упругости Еcsek = Еc ∙vc, которые отображают реологические свойства цементных бетонов в рекомендуемых выражениях (1…3). Предложены аналитические выражения зависимости изменения коэффициентов упругости (vc) и коэффициентов интенсивности развития деструкций (KD) одноосно сжатых бетонов с ростом уровня нагрузки при «мягком» и «жестком» режимах нагружения исследованных серий цементных бетонов с использованием: εсx; εсlx ; νсu ; νс, отражающих процесс изменения упруго-пластических свойств тяжелого, керамзитового, мелкозернистого бетона и цементного камня на восходящих и нисходящих участках полных диаграмм деформирования цементных композитов при центральном сжатии кратковременной статической нагрузкой. Исследованиями отмечено, что интенсивность развития деструкций в структуре однородно нагруженного тяжелого бетона существенно (в 1,17 раза) ниже, чем в одноосно сжатом мелкозернистом (цементно-песчаной матрице) и керамзитовом бетоне, и в 1,52 раза менее в цементном камне. Экспериментами установлено характерное расположение уровней параметрических точек Ѳcх; fоcrс; fνcrс тяжелого бетона с ростом уровня нагрузки исследованных видов бетонов, отражающих интенсивность развития деструкций структуры цементных бетонов. The article presents the features of the process of the intensity of the development of destruction, pseudoplastic deformation and fracture of uniformly and inhomogeneously compressed heavy concrete with strength in the range fc,10 = 23,6; 40,8; 71,0 MPa [2...5 and others] and the marked difference in the intensity of the development of destruction, deformation and fracture of uniaxially compressed heavy, fine-grained and expanded clay concrete with strength fc,10 = 50,2; 54,9 and 36,9 MPa under the “soft” and “hard” loading conditions of uniaxially compressed concrete prismatic columns of the 5th standard size. An analysis of literary sources was carried out with studies of changes in the elastic-plastic characteristics of vc, Еcsek heavy, fine-grained and structural expanded clay concrete taking into account the influence of significant factors and their change with increasing load when describing the dependence σc-εcх. It was found that the recommended by the Building Standards vcи , and Ес uniaxially compressed concrete quantitatively and qualitatively do not reflect the nature of the change in the elastic-plastic properties of heavy, expanded clay and fine-grained concrete (cement-sand matrix) of centrally compressed concrete with increasing load level. Proposed analytical expressions of the dependence σc-εcх, describing experimental values of deformation diagrams of uniaxially compressed heavy, fine-grained (cement-sand matrix) and expanded clay concrete of series B with prismatic strength fc,10 = 50,2; 54,9 and 36,9 MPa of the investigated concrete samples of the 5th group of standard sizes with “soft” and “hard” loading conditions. Studies are given that indicate that the mechanism of deformation and the process of development of destructions (decompression) of the structure of cement stone, heavy, fine-grained and expanded clay concrete with increasing load level affects the nonlinear nature of the change in the elastic-plastic properties: vc - coefficient of elasticity; secant modulus of elasticity Еcsek = Еc ∙ vc , which reflect the rheological properties of cement concrete in recommended expressions (1...3). Analytical expressions are proposed for the dependence of changes in the elastic coefficients (vc) and the coefficient of developmental rate of destruction (KD) of uniaxially compressed concrete with an increase in the load level under the “soft” and “hard” loading conditions of the investigated series of cement concrete using: εсx; εсlx ; νсu ; νс , reflecting the process of changing the elastic-plastic properties of heavy, expanded clay, fine-grained concrete and cement stone in the ascending and descending sections of the complete diagrams of deformation of cement composites under central compression with a short-term static load. Studies have noted that the intensity of the development of destruction in the structure of uniformly loaded heavy concrete is significantly (1,17 times) lower than in uniaxially compressed fine-grained (cement-sand matrix) and expanded clay concrete and 1,52 times less in cement stone. The experiments established a characteristic arrangement of the levels of parametric points Ѳcх; fоcrс; fνcrс of heavy concrete with an increase in the load level of the investigated types of concrete, reflecting the intensity of the development of destruction of the structure of cement concrete.


Author(s):  
H. K. Birnbaum ◽  
I. M. Robertson

Studies of the effects of hydrogen environments on the deformation and fracture of fcc, bcc and hep metals and alloys have been carried out in a TEM environmental cell. The initial experiments were performed in the environmental cell of the HVEM facility at Argonne National Laboratory. More recently, a dedicated environmental cell facility has been constructed at the University of Illinois using a JEOL 4000EX and has been used for these studies. In the present paper we will describe the general design features of the JEOL environmental cell and some of the observations we have made on hydrogen effects on deformation and fracture.The JEOL environmental cell is designed to operate at 400 keV and below; in part because of the available accelerating voltage of the microscope and in part because the damage threshold of most materials is below 400 keV. The gas pressure at which chromatic aberration due to electron scattering from the gas molecules becomes excessive does not increase rapidly with with accelerating voltage making 400 keV a good choice from that point of view as well. A series of apertures were placed above and below the cell to control the pressures in various parts of the column.


Author(s):  
D.M. Jiang ◽  
B.D. Hong

Aluminum-lithium alloys have been recently got strong interests especially in the aircraft industry. Compared to conventional high strength aluminum alloys of the 2000 or 7000 series it is anticipated that these alloys offer a 10% increase in the stiffness and a 10% decrease in density, thus making them rather competitive to new up-coming non-metallic materials like carbon fiber reinforced composites.The object of the present paper is to evaluate the inluence of various microstructural features on the monotonic and cyclic deformation and fracture behaviors of Al-Li based alloy. The material used was 8090 alloy. After solution treated and waster quenched, the alloy was underaged (190°Clh), peak-aged (190°C24h) and overaged (150°C4h+230°C16h). The alloy in different aging condition was tensile and fatigue tested, the resultant fractures were observed in SEM. The deformation behavior was studied in TEM.


1988 ◽  
Vol 49 (C5) ◽  
pp. C5-677-C5-680
Author(s):  
I. M. ROBERTSON ◽  
G. M. BOND ◽  
T. C. LEE ◽  
D. S. SHIH ◽  
H. K. BIRNBAUM

Sign in / Sign up

Export Citation Format

Share Document