Distortion of pipe-flow development by boundary layer growth and unconstrained inlet conditions

2019 ◽  
Vol 31 (6) ◽  
pp. 063602 ◽  
Author(s):  
Herman D. Haustein ◽  
Barak Kashi
Keyword(s):  
Boundary Layer ◽  
Pipe Flow ◽  
Layer Growth ◽  
Flow Development ◽  
Inlet Conditions ◽  
Boundary Layer Growth

Calculation of Diffuser Efficiency for Two-Dimensional Flow

1947 ◽  
Vol 14 (3) ◽  
pp. A213-A216
Author(s):  
R. C. Binder
Keyword(s):  
Boundary Layer ◽  
Incompressible Flow ◽  
Potential Flow ◽  
Layer Growth ◽  
Two Dimensional ◽  
Dimensional Flow ◽  
Check Calculation ◽  
Two Dimensional Flow ◽  
Boundary Layer Growth ◽  
Potential Velocity

Abstract A method is presented for calculating the efficiency of a diffuser for two-dimensional, steady, incompressible flow without separation. The method involves a combination of organized boundary-layer data and frictionless potential-flow relations. The potential velocity and pressure are found after the boundary-layer growth is determined by a trial-and-check calculation.

scholarly journals Wind speed response of marine non-precipitating stratocumulus clouds over a diurnal cycle in cloud-system resolving simulations

2016 ◽  
Vol 16 (9) ◽  
pp. 5811-5839 ◽  
Author(s):  
Jan Kazil ◽  
Graham Feingold ◽  
Takanobu Yamaguchi
Keyword(s):  
Boundary Layer ◽  
Wind Speed ◽  
Large Scale ◽  
Layer Growth ◽  
Radiative Properties ◽  
Cloud Base ◽  
Latent Heat Release ◽  
Marine Stratocumulus ◽  
Stratocumulus Clouds ◽  
Boundary Layer Growth

Abstract. Observed and projected trends in large-scale wind speed over the oceans prompt the question: how do marine stratocumulus clouds and their radiative properties respond to changes in large-scale wind speed? Wind speed drives the surface fluxes of sensible heat, moisture, and momentum and thereby acts on cloud liquid water path (LWP) and cloud radiative properties. We present an investigation of the dynamical response of non-precipitating, overcast marine stratocumulus clouds to different wind speeds over the course of a diurnal cycle, all else equal. In cloud-system resolving simulations, we find that higher wind speed leads to faster boundary layer growth and stronger entrainment. The dynamical driver is enhanced buoyant production of turbulence kinetic energy (TKE) from latent heat release in cloud updrafts. LWP is enhanced during the night and in the morning at higher wind speed, and more strongly suppressed later in the day. Wind speed hence accentuates the diurnal LWP cycle by expanding the morning–afternoon contrast. The higher LWP at higher wind speed does not, however, enhance cloud top cooling because in clouds with LWP ⪆ 50 g m−2, longwave emissions are insensitive to LWP. This leads to the general conclusion that in sufficiently thick stratocumulus clouds, additional boundary layer growth and entrainment due to a boundary layer moistening arises by stronger production of TKE from latent heat release in cloud updrafts, rather than from enhanced longwave cooling. We find that large-scale wind modulates boundary layer decoupling. At nighttime and at low wind speed during daytime, it enhances decoupling in part by faster boundary layer growth and stronger entrainment and in part because shear from large-scale wind in the sub-cloud layer hinders vertical moisture transport between the surface and cloud base. With increasing wind speed, however, in decoupled daytime conditions, shear-driven circulation due to large-scale wind takes over from buoyancy-driven circulation in transporting moisture from the surface to cloud base and thereby reduces decoupling and helps maintain LWP. The total (shortwave + longwave) cloud radiative effect (CRE) responds to changes in LWP and cloud fraction, and higher wind speed translates to a stronger diurnally averaged total CRE. However, the sensitivity of the diurnally averaged total CRE to wind speed decreases with increasing wind speed.

An Integral Method for Turbulent Boundary Layers on Rotating Disks

1993 ◽  
Vol 115 (4) ◽  
pp. 614-619 ◽  
Author(s):  
S. Abrahamson ◽  
S. Lonnes
Keyword(s):  
Boundary Layer ◽  
Boundary Layers ◽  
Integral Method ◽  
Radial Profile ◽  
Tangential Velocity ◽  
Turbulent Boundary Layers ◽  
Similarity Solutions ◽  
Layer Growth ◽  
Rotating Disks ◽  
Boundary Layer Growth

An integral method for computing turbulent boundary layers on rotating disks has been developed using a power law profile for the tangential velocity and a new model for the radial profile. A similarity solution results from the formulation. Radial transport, boundary layer growth, and drag on the disk were computed for the case of a forced vortex frees tream flow. The results were compared to previous similarity solutions. The method was extended to a Rankine vortex freestream flow. Differential equations for boundary layer parameters were developed and solved for different Reynolds numbers to look at the net entrainment, boundary layer growth, and drag on the disk.

Sign in / Sign up

Export Citation Format

Share Document